Influence of temperature and strain rate on cohesive properties of a structural epoxy adhesive |
| |
Authors: | Thomas Carlberger Anders Biel Ulf Stigh |
| |
Affiliation: | 1.SAAB Automobile AB,Trollh?ttan,Sweden;2.University of Sk?vde,Sk?vde,Sweden |
| |
Abstract: | Effects of temperature and strain rate on the cohesive relation for an engineering epoxy adhesive are studied experimentally. Two parameters of the cohesive laws are given special attention: the fracture energy and the peak stress. Temperature experiments are performed in peel mode using the double cantilever beam specimen. The temperature varies from −40 to + 80°C. The temperature experiments show monotonically decreasing peak stress with increasing temperature from about 50 MPa at −40°C to about 10 MPa at + 80°C. The fracture energy is shown to be relatively insensitive to the variation in temperature. Strain rate experiments are performed in peel mode using the double cantilever beam specimen and in shear mode, using the end notch flexure specimen. The strain rates vary; for peel loading from about 10−4 to 10 s−1 and for shear loading from 10−3 to 1 s−1. In the peel mode, the fracture energy increases slightly with increasing strain rate; in shear mode, the fracture energy decreases. The peak stresses in the peel and shear mode both increase with increasing strain rate. In peel mode, only minor effects of plasticity are expected while in shear mode, the adhesive experiences large dissipation through plasticity. Rate dependent plasticity, may explain the differences in influence of strain rate on fracture energy between the peel mode and the shear mode. |
| |
Keywords: | Cohesive law Strain rate Temperature dependence Experimental DCB-specimen ENF-specimen Crashworthiness |
本文献已被 SpringerLink 等数据库收录! |
|