| Abstract: | This paper describes and analyzes the results of an experiment where various thin polymeric films are continuously sheared between smooth glass substrates. The shear force per unit area has been measured as a function of mean uniaxial stress and temperature using representative “good” and “poor” casting solvents followed by a range of heat treatments. The polymers studied include high density polyethylene, polybisphenol-A–carbonate, poly(ethylene terephthalate), atactic polystyrene, isotactic polystyrene, atactic poly(methyl methacrylate), isotactic poly(methyl methacrylate), poly(vinyl acetate), poly(vinyl alcohol), poly(vinyl pyrrolidone), poly(vinyl chloride), and polytetrafluoroethylene. The results indicate that the casting solvent has a very pronounced influence upon the rheology of the film. The casting solvents may apparently confer either ductile or brittle failure in the film and also influence the nature of the temperature and pressure dependence of the shear stress. The data have been analyzed using Eyring theory and also by reference to relevant published literature on the influence of solvent and thermal treatments on the morphology and deformation behavior of polymers. “Good” solvents generally tend to promote a brittle mode of failure with little temperature dependence. The same type of solvents also produced films which have higher shear strengths and show greater increases in shear strength with pressure. These data are adequately rationalized using free volume and entanglement notions. |
