| 基于正交试验法的W-Fe-Ni合金车削表面粗糙度研究 |
| |
| 引用本文： | 刘梅,陈杰,单东伟,迟永刚. 基于正交试验法的W-Fe-Ni合金车削表面粗糙度研究[J]. 工具技术, 2006, 40(12): 52-54 |
| |
| 作者姓名： | 刘梅 陈杰 单东伟 迟永刚 |
| |
| 作者单位： | 中国工程物理研究院,621900,四川省绵阳市;中国工程物理研究院 |
| |
| 摘 要： | 运用正交试验法对W-Fe-Ni合金半球试件车削加工表面粗糙度进行了试验,并采用极差分析法分析了试验结果。结果表明,球形零件的加工表面粗糙度随进给量、切削深度的增大而增大,随切削速度的增大而减小,其中进给量是最主要的影响因素,其次为切削深度,切削速度的影响很小。
|
| 关 键 词： | 表面粗糙度 车削 正交试验 W-Fe-Ni合金 切削参数 |
| 收稿时间： | 2006-05-01 |
| 修稿时间： | 2006-05-01 |
Research on Surface Roughness of Turned W-Fe-Ni Alloy Part by Orthogonal Test Method |
| |
| Liu Mei, Chen Jie, Shan Dongwei, et al. Research on Surface Roughness of Turned W-Fe-Ni Alloy Part by Orthogonal Test Method[J]. Tool Engineering(The Magazine for Cutting & Measuring Engineering), 2006, 40(12): 52-54 |
| |
| Authors: | Liu Mei Chen Jie Shan Dongwei et al |
| |
| Affiliation: | Liu Mei Chen Jie Shan Dongwei et al |
| |
| Abstract: | The experiment was carried out on W-Fe-Ni alloy semi-sphere parts by using orthogonal test method to study the turned surface roughness, and results of experiments were analyzed by using maximum difference method. The results show that the surface roughness is increased as the increases of feed rate and depth of cut, but reverse to the cutting speed. Feed rate is the main influencing factor on surface roughness, followed by depth of cut and cutting speed. |
| |
| Keywords: | surface roughness turning orthogonal experiment W-Fe-Ni alloy cutting parameter |
| 本文献已被 CNKI 维普 万方数据 等数据库收录！ |
