| TiCN超细粉末的制备工艺研究 |
| |
| 引用本文： | 严迪科,张厚安,唐思文. TiCN超细粉末的制备工艺研究[J]. 中国粉体技术, 2010, 16(5). DOI: 10.3969/j.issn.1008-5548.2010.05.007 |
| |
| 作者姓名： | 严迪科 张厚安 唐思文 |
| |
| 作者单位： | 1. 湖南科技大学,先进材料制备及应用技术研究所,湖南,湘潭,411201
2. 厦门理工学院,材料制备与应用技术研究所,福建,厦门361024 |
| |
| 基金项目： | 湖南省杰出青年基金，福建省省属高校科研专项计划项目 |
| |
| 摘 要： | 采用湿式高能球磨法制备超细TiCN粉体,考察不同球磨时间下粉体粒度的分布情况,分析球料质量比和球磨时间对TiCN粉体粒度的影响,并利用扫描电镜观察制备粉体的形貌。结果表明:随着球料质量比和球磨时间的增加,TiCN粉体平均粒径均出现先减小后增大的趋势,当球料质量比为8∶1时,球磨50h可获得平均粒径为0.84μm的类球形TiCN粉体。
|
| 关 键 词： | 超细粉体 高能球磨 粒度分布 |
Preparation Technology of Ultrafine TiCN Powder |
| |
| Yan Dike,Zhang Houan,Tang Siwen. Preparation Technology of Ultrafine TiCN Powder[J]. China Powder Science and Technology, 2010, 16(5). DOI: 10.3969/j.issn.1008-5548.2010.05.007 |
| |
| Authors: | Yan Dike Zhang Houan Tang Siwen |
| |
| Abstract: | The ultrafine TiCN powder was prepared by high energy ball milling method. The size distribution of TiCN particles in different milling time was tested and the effect of mass ratio of ball and powder and milling time on the average particle size of TiCN powder was analyzed. The micrographs of TiCN particles were observed by using scanning electron microscopy (SEM). The results showed that with the increasing of the mass ratio of ball and powder and the milling time, the average particle size reduced first and then increased. When the milling time was 50 h and the mass ratio of ball and powder was 8∶1, the ultrafine spheroidal particles of TiCN with the average size of 0.84 μm were obtained. |
| |
| Keywords: | ultrafine powder high energy ball milling particle size distribution |
| 本文献已被 CNKI 万方数据 等数据库收录！ |
|
