首页 | 官方网站   微博 | 高级检索  
     

0.1 THz鳍线单平衡式基波混频电路研究
引用本文:杨大宝,王俊龙,张立森,邢东,梁士雄,赵向阳,冯志红.0.1 THz鳍线单平衡式基波混频电路研究[J].红外与激光工程,2017,46(4):420004-0420004(5).
作者姓名:杨大宝  王俊龙  张立森  邢东  梁士雄  赵向阳  冯志红
作者单位:1.专用集成电路国家级重点实验室,河北 石家庄 050051;
摘    要:研究了一种基于石英基片的0.1 THz频段的鳍线单平衡混频电路,混频电路的射频和本振信号分别从WR10标准波导端口通过波导单面鳍线微带过渡和波导微带探针过渡输入,中频信号通过本振中频双工器输出。这是一种新型的混频电路形式,与传统的W波段混频器相比,混频电路可以省略一个复杂的W波段滤波器,具有电路设计简单、安装方便的特点。该电路使用两只肖特基二极管通过倒装焊工艺粘结在厚度为75 m的石英基片上,石英基片相对传统基板,可以极大提高电路加工精度。在固定50 MHz中频信号时,射频90~110 GHz范围内,0.1 THz混频器单边带变频损耗小于9 dB。

关 键 词:0.1  THz    单平衡    混频电路    石英基片
收稿时间:2016-08-05

Development of 0.1 THz finline fundamental single-balanced mixer circuit
Affiliation:1.National Key Laboratory of Application Specific Integrated Circuit,Shijiazhuang 050051,China;2.The 13 th Research Institute of China Electronics Technology Group Corporation,Shijiazhuang 050051,China
Abstract:This design, fabrication and test of a 0.1 THz fundamental finline single-balanced mixer circuit on a single quartz substrate was presented. The local oscillator(LO) input signal was feeded from WR10 waveguide to a suspended microstrip line, the radio frequency(RF) input signal was also feeded from WR10 waveguide to a finline, and the intermediate frequency(IF) signal was taken to the output port through a LO-IF duplexer. This novel mixer circuit can omit a complex W-band filter compared to traditional mode. The circuit features simple design and easy assemblage. A pair of flip-chipped diodes rested on the 75 m thick quartz substrate, which could improve the size precision of circuit, constitute the basic balanced mixing circuit. After the mixer circuit is fabricated, it owns a 90-110 GHz operating frequency, and its single side band conversion loss is better than 9 dB when the IF is fixed at 50 MHz.
Keywords:
点击此处可从《红外与激光工程》浏览原始摘要信息
点击此处可从《红外与激光工程》下载全文
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司    京ICP备09084417号-23

京公网安备 11010802026262号