共查询到17条相似文献,搜索用时 218 毫秒
1.
文章利用沉降炉系统开展了河南烟煤与海草和桃木两种生物质的混燃成渣特性实验,对混燃灰的理化性能、矿物质转化过程及其聚集成渣的趋势进行了研究。研究结果表明:藻类生物质海草能够加剧混燃灰渣颗粒的聚集成块趋势,而木本生物质桃木仅造成混燃灰颗粒粒径的略微增长;掺混海草导致混燃灰中的碱金属,Cl和S元素含量增加,灰渣中出现大量低熔点的长石和类长石矿物质,从而增强了灰渣的黏附能力,表现为由包覆引起的成渣机制;掺混桃木的混燃灰因含有较高的Ca和Fe等元素,从而生成了较多的能够抑制低温共熔物形成的钙质硅(铝)酸盐,其提高了混燃灰的熔融温度,并减缓了成渣趋势;藻类生物质中的碱金属,Cl和S等元素除对成渣过程有较大影响外,还会引起冷凝腐蚀等问题,从而对其资源化应用产生负面影响。 相似文献
2.
将神华准东煤(神华煤)和天池能源准东煤(天池煤)与碱沟煤按照不同质量掺混比进行混合并制得灰样,将NaCl、CaO、Al2O3和SiO2按不同添加比例加入神华煤和天池煤并制成灰样,对上述混合灰样的熔融特性进行研究.结果表明:碱沟煤掺混2种准东煤后,随着准东煤质量掺混比的增大,混合灰各个灰熔点特征温度先降低后升高;随着灰样中Na含量增加,准东煤灰样的变形温度显著降低,软化温度、半球温度和流动温度先降低后趋于不变;当灰样中Na含量达到一定比例后,NaCl对准东煤灰熔融特性的影响明显减弱;CaO对准东煤灰熔点的影响较复杂,可以降低也可以提高灰熔点;随着Al2O3添加比例的增加,准东煤灰熔点先升高后急剧降低;随着SiO2添加比例的增加,神华煤灰样的变形温度先升高后降低,而天池煤灰样的变形温度逐步升高,其他3个特征温度均逐渐降低. 相似文献
3.
秸秆类生物质燃烧特性的研究 总被引:18,自引:0,他引:18
利用热重分析仪对江苏宿迁地区的玉米秆、稻秆和麦秆三种生物质的燃烧特性进行了分析,测定了生物质的灰熔点和灰组成,用XRD和TEM表征了生物质灰的物相结构和形貌。研究结果表明,三种生物质的燃烧规律基本一致,燃烧过程可分为四个阶段:干燥过程,热解过程,晶型转变过程和熔融过程;三种生物质中,玉米秆灰熔点最高。灰量最少且碱金属含量最低;生物质灰为形态各异的纳米颗粒。 相似文献
4.
《燃烧科学与技术》2017,(3)
选取新疆准东煤田高钠煤(五彩湾煤和天池煤)为研究对象,研究了准东煤中碱金属钠的赋存形态和钠基化合物对煤灰熔融特性影响机制.向低温灰中添加不同比例的Na_2O然后制取其高温混灰,利用X射线衍射仪分析矿物质组分在不同成灰温度下演化规律,探究碱金属钠对准东煤灰熔融特性的影响机制.结果表明:准东煤中钠以水溶钠形式为主;天池煤随着钠含量的增加,灰熔融温度先降低后趋于稳定;五彩湾煤随着钠含量的增加,灰熔融温度先降低后升高.天池煤掺混10%,Na_2O导致灰熔融温度降低,是由于煤灰中白云石、氢氧化钙分解产生大量CaO,碱金属钠促进CaO与煤灰中Si、Al等反应生成含钙钠的低温共熔体,且有低熔点矿物无水芒硝生成;五彩湾煤掺混10%,Na_2O导致灰熔融温度降低,是由于煤灰中新生成低熔点的钙铁辉石和无水芒硝,且碱金属钠促进钙铝黄长石和镁黄长石等含钙矿物质的低温共熔反应,掺混过量Na_2O导致灰熔融温度升高,这是由于煤灰中生成了大量高熔点矿物质. 相似文献
5.
气流床气化炉采用液态排渣,高熔点煤灰不能满足排渣要求,煤灰的结渣问题和灰熔融性有很大关系。为研究CaO对煤灰熔融特性的影响规律,在煤灰中添加不同比例的CaO并对灰熔融温度进行测试。使用扫描电镜能谱仪对试样进行元素组成分析和微观形貌观察,使用X-射线粉末衍射仪分析灰样中矿物质变化。结果表明,随着CaO添加比例的增大,煤灰熔融温度先降低后增高。CaO添加比例从0增加到30%时,高温下高熔点的钙长石含量降低,生成大量低熔点的钙铁榴石,灰熔融温度逐渐降低。CaO添加比例继续增加,高熔点的硅钙石含量增多,灰熔融温度逐渐升高。对本研究煤种,CaO添加比例为30%时,降低灰熔融温度效果最好。 相似文献
6.
7.
8.
9.
10.
选用高硫长广煤为试验煤种、分析纯 CaO 和 MgO 为添加剂,按照设定的配料方案配制为混合煤粉.依据 GB/T 219-1996煤灰熔融特性测试方法,使用 SE-AF 智能灰熔点测试仪对混合煤粉的灰熔点进行了测量.结果表明:随混合煤粉中 CaO 添加质量分数的逐渐增加,混合煤粉灰熔融特性温度呈现 V 型变化规律;按照联产 Q 相水泥熟料配料方案配制的混合煤粉煤灰的结渣趋势程度属于轻微,较长广煤的结渣趋势程度有所降低.对软化温度下混合煤粉煤灰的矿物组成进行了 XRD 分析,并利用 CaO-Al2O3一SiO2 三元系统相图,进一步分析了混合煤粉熔融特性温度变化机理.结果表明:随着混合煤粉中 CaO 添加质量分数的变化,煤灰矿物组成中不同程度地出现低温共融体是煤灰熔融特性温度变化的原因. 相似文献
11.
《能源学会志》2020,93(2):642-648
The change of mineral composition in ash and the effect of CaO on the melting characteristics of coal ash were studied by adding different contents of CaO to coal ash. At the same time, the Factsage thermodynamics software was used to simulate the mineral changes in the synthetic ash to support and verify the experimental results. The results show that with the increase of CaO content, the melting characteristic temperature of coal ash first decreases and then rises. After adding a certain amount of CaO, the quartz with higher melting point completely disappears, and the melting point of the coal ash reaches a minimum value. And with the increase of CaO content, the appearance of wollastonite and single crystal calcium oxide mineral makes the melting point of coal ash gradually increase. It can be seen from the phase diagram calculated by Factsage that as the CaO content increases, the corresponding position of the coal ash gradually moves from the hematite region to the calcareous region. And the phenomenon of low temperature eutectic occurs when the CaO content is 35%, which is consistent with the trend of temperature change of the melting characteristics. These phenomena all indicate that the change in the melting point of coal ash is nonlinear as the content of CaO minerals increases. 相似文献
12.
13.
实验研究了广东省典型农业生物质稻杆、甘蔗渣/叶的燃烧结渣特性。采用GB/T212-2001和ASTM E1755标准进行灰化实验,采用角锥法和一步法检测生物质的熔融特性。实验结果证实ASTM的低温灰化标准更适合稻杆类高无机盐含量的生物质原料。稻杆中碱金属氧化物含量达20%以上,是导致灰渣粘结和熔融的主要因素。由于角锥法灰熔点检测法提前将部分碱金属和Cl元素转化和析出,导致检测结果远高于实际燃烧的熔融温度;相比而言,一步法更具有直观性和指导作用。通过一步法实验获得稻杆临界结渣温度为700℃ ~ 750℃,甘蔗渣为850℃ ~ 900℃,甘蔗叶为900℃ ~ 950℃。CaO和Al2O3添加剂对于生物质燃烧过程具有一定的抗结渣功能,CaO通过与SiO2 (s) 反应生成高熔点的固态Ca3Si2O7 (s) 和MgOCa3O3Si2O4 (s),因此能消耗物料周围的SiO2 (s),抑制低温共融;Al2O3则通过生成高熔点温度的固态KAlSiO4和固态KAlSi2O6,减少低温共熔现象的发生。 相似文献
14.
The agglomeration characteristics of alumina sand-straw ash mixtures were investigated at various levels of ash content (0.0, 3.3, 27.8, and 43.5%) and temperature (620, 740, 850, and 1000°C) using scanning electron microscopy and energy dispersive X-ray analysis techniques. Agglomeration of alumina sand did not take place below the temperature of 850°C at all levels of ash content, but at the temperature of 850°C a weak bonding of particles was observed. However, at the temperature of 1000°C, the alumina particles agglomerated in the presence of straw ash at all levels of ash content as a layer of ash melt bonded the particles together. The temperature at which agglomeration occurred was within the range of the initial deformation (921°C) and softening (1054°C) temperatures of straw ash and the liquidus temperature of potash feldspar (990 ± 20°C). The softening of straw ash and the formation of low melting temperature eutectic (potash feldspar) are two possible mechanisms for the agglomeration of alumina sand. 相似文献
15.
16.