首页 | 本学科首页   官方微博 | 高级检索  
相似文献
 共查询到18条相似文献,搜索用时 187 毫秒
1.
用正电子湮没和扰动角关联二种方法研究了Si和Nb的辐射损伤。采用正电子湮没方法得到的结果与扰动角关联的完全一致。  相似文献   

2.
用正电子湮没辐射一维角关联实验装置和正电子湮没寿命谱仪观察了全氟乙烯丙烯共聚物(FEP)系列试样和不同含氯量的聚乙烯系列试样的正电子湮没特性,并分别与聚四氟乙烯均聚物(PTFE)和聚乙烯(PE)进行了对照。结果表明:分子材料的介电性质对正电子湮没特性有明显的影响。极性基团的加入改变了分子链上的电荷密度分布,导致微观偶极电场的产生,使在自由体积内部或陷落在缺陷巾的0-Ps正电子波函数与分子链上轨道电子波函数的重迭几率增加,长寿命τ_3减小;同时,由于卤素原子的电负性较强,抑制了Ps的形成,增加了自由正电子的数目,使角关联曲线低动量成分减小。  相似文献   

3.
聚四氟乙烯中正电子湮没寿命谱已被分解为四个成份(见表1)。其中τ_3的来源尚有争议。我们利用中国科技大学的一维角关联装置测量了从商品聚四氟乙烯棒材切下经不同处理的试样(φ20mm,厚2mm)中正电子湮没一维角关联曲线。根据X-衍射谱用纸样称重法估算了不同试样的结晶度,见表2。由图定性看出:(1)原始样和淬火样的角关联曲线中,相应于p-Ps自湮没的低动量成份显著高于退火样品。这与前二者中无定形区域比例较大因而Ps形成几率较高是一致的。(2)γ辐照剂量足够大(为21Mrad)时,角关联曲线中低动量成份显著减少。这与试样在该条件下结晶区域增大有关,这时Ps形成受到抑制。以上趋势表明结晶度与Ps形成几率是关联的。  相似文献   

4.
本工作用正电子湮没和扰动角关联方法研究Pd0.75Ag0.25和LaNi4.25Al0.75两种贮氢合金。  相似文献   

5.
近年来正电子湮没技术发展很快。它已经广泛地应用于各种领域中,在某些领域如金属及合金的研究中几乎成为一种常规的手段。 正电子湮没实验技术有三种主要的方法即寿命测量、能量的多普勒展宽测量、角关联测量。其中的寿命测量从概念上讲是比较直接的,但是从仪器设备和它的合理使用上讲,寿命测量是三个正电子方法中最为复杂的。 对于正电子寿命测量所使用的正电子寿命谱仪来说,谱仪的分辨率是最为重要的指  相似文献   

6.
Arponen等曾计算了铝中刃位错的正电子湮没效应,在理论上解释了Hautojarvi的变形铝正电子湮没实验,我们采用他们的理论方法,但简化了他们的位错模型,用空心柱孔模型计算了变形铝的正电子湮没效应,得到了与Arponen等结果一致、与Hautojarvi实验符合的结果,角关联曲线亦有所改善。计算结果表明:1)在凝胶模型的意义下,若晶体中存在半径为0.93A的空心柱孔,就将给出与Hautojarvi实验符合的结果;2)Arponen等的模型中的位错弹性理论部分对角关联曲线的计算意义不大。我们看到,一方面位错中心对正电子的捕获可能是较强的,因而对总的湮没效应贡献很大;另一方面也存在着变形铝正电子湮没效应是由一系列微空位所贡献的可能性。  相似文献   

7.
本文通过对甲氧基苄叉丁基苯胺液晶相变的研究来解释这种液晶相变机理—分子自旋模 型。液晶相变测量采用正电子湮没寿命谱仪,从本实验看这种方法比示差量热法优越,其敏感参量τ_2,I_2能很好地反映液晶分子的状态。  相似文献   

8.
本文利用正电子对金属微观结构的敏感性,测定了在不同淬火条件下低碳钢的正电子寿命谱,分析了在A_(c3)以上不同温度加热淬火时,正电子寿命与淬火温度和组织的关系。实验在快慢符合正电子谱仪上进行,用~(60)Co测得的仪器时间分辨率约300ps,道宽44ps,源强约20μCi,谱搜集时间1×10~4秒,总计数3×10~5左右。用微机进行了数据处理,程序按最小二乘迭代法拟合实验谱,并在单高斯函数拟合分辨函数的基础上作了近似处理。配合定量金相法,分析了在两相区却热淬火时,铁素体与马氏体混合组织对正电子寿命的影响(图1—3)。按  相似文献   

9.
生物膜是一个多脂组份系统,前人的工作是利用PAT测量生物膜的模型系统的结构相变,都采用单脂或双脂组份的磷脂脂质体为实验对象,根据测量结果推测多脂系统的行为。为了使模型系统更接近真实的生物膜,本工作以多脂的大豆磷脂(九种组份)脂质体为对象,用PAT测到了在-25℃-+20℃范围内-18℃、-4℃+12℃处的三个相变点并与DSC测量结果作了比较,PAT结果给出了DSC未测出的-4℃处的相交点。  相似文献   

10.
在80~300K的温区范围内测试了掺铬、掺碲的砷化镓单晶及中子辐照后高阻P型直拉硅及区熔硅的正电子湮没寿命谱。谱仪的FWHM为350ps,每个数据点的积分计数约10~6。实验结果如图1所示。  相似文献   

11.
12.
13.
先进中子学栅格程序KYLIN-Ⅱ的输运计算模块采用了特征线中子输运计算方法,其计算精度较高,可适用于反应堆中复杂的燃料组件,然而当网格规模、能群数、特征线数较大时,计算时间较长,计算效率较低,因此需对其进行并行优化,以提高计算效率。通过性能分析,发现特征线扫描和高阶散射源计算较为耗时。本文通过基于MPI的能群并行、E指数优化、角通量球谐函数展开等方法实现了并行优化。基准题验证表明,并行优化计算精度较高,E指数优化对特征线扫描效率提升较好,角通量球谐函数展开对高阶散射源计算效率提升较好。经过优化后的KYLIN-Ⅱ的输运计算模块加速效果显著,可满足工程使用需求。  相似文献   

14.
The sputtering yield angular distributions have been calculated based on the ion energy dependence of tohal sputtering yields for Ni and Mo targets bombarded by low-energy Hg^ ion. The calculated curves show excellent agreement with the corresponding Wehner‘s experimental results of sputtering yield angular distribution. The fact clearly demonstrated the intrinsic relation between the ion energy dependence of total sputtering yields and the sputtering yield angular distribution. This intrinsic relation had been ignored in Yamamura‘s papers (1981,1982) due to some obvious mistakes.  相似文献   

15.
In ocean environment, the ship motion significantly affects the natural circulation behavior in ship-based integrated-type reactor. This paper theoretically and experimentally investigated natural circulation characteristics in symmetrical loops under rolling condition. Experiments were carried out on a test loop with a symmetrical configuration by simulating the structure of an accrual reactor. The theoretical results revealed that only angular acceleration contributes to the resultant force under zero power rolling condition. In a closed circuit with a uniform cross-section area, the angular acceleration force integral is proportional to the angular acceleration and the area enclosed by the circuit. The integral value varies over time and causes flow oscillations. However, the angular acceleration force does not influence the flow status in the shared part of the two symmetrical neighbor circuits due to force interactions. Rolling experiments with a zero power load confirmed these results. Full power experiments under rolling condition exhibited observable flow rate and temperature oscillations in each branch of the flow channel. The oscillations in the side flow channels had the same values for both the period and the phase with the variation of rolling angle. The angular acceleration force was the main cause of this. The oscillations in the middle channel had a period half the value of the rolling period. The periodical variation of the vertical component of gravity caused this. The horizontal component of gravity was out-phasing with angular acceleration. Therefore, it alleviated oscillation in the side channels. The experimental results showed that for the same rolling period, as the rolling angle increased, the average flow rate decreased and oscillation amplitudes increased. Also, as the power load increased, the oscillations in the middle channel increased and the oscillation in the side channel decreased.  相似文献   

16.
金属铍具有较稳定的理化性质,同时也易与入射的轻核粒子发生反应产生中子,在小型中子发生器的研制中具有其他靶材所不具有的优势。9Be(d,n)10 B反应的中子产额和中子角分布数据,尤其是低能区的数据,对小型中子发生器的设计非常重要。本文在中国原子能科学研究院的600kV高压倍加器上测量了100~500keV能区9Be(d,n)10B反应的中子产额和中子角分布。  相似文献   

17.
We have developed a new shaped NaI(Tl) scintillation detector for the direct measurement of “effective dose, (E)” or “effective dose equivalent, (HE )” for external photon exposures. These quantities related to human risk are generally difficult to be evaluated directly from measurements, because these depend not only on the energy distribution but also on the angular distribution of the gamma ray field. The present work, however, solved the problem concerning the angular dependence, by considering a detector shape that satisfies the angular response similar to human body's. The optimum dimensions of NaI(Tl) crystal for HE and for E were determined respectively by a Monte Carlo simulation. The detector subject to HE was manufactured and tested. The angular characteristics of the developed detector indicate a fairly good coincidence with those of the theoretical values, HE . Together with the dose conversion method, so called “G(E) Function method”, it was made possible to directly measure effective dose (equivalent).  相似文献   

18.
介绍了放射性核束弹性散射实验中测量的角分布进行归一化的方法。由于有限的测量角区及放射性核束有较大的发散度,采用了逐个事件计算的方法,在探测器空间分布区域用事先产生的一系列点构成的数据库模拟探测器边界,对这些点进行坐标转换,再进行选择判断,得到每个事件的几何探测效率。通过每个事件的几何探测效率推算到整个空间,得到实际的角分布。  相似文献   

设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号