Unerroric of control of mutual compliance of the efficiency of hydrogen engines of unmanned vehicles in the conditions of mass production

The issues related to the reliability of hydrogen engines of unmanned vehicles and increasing the efficiency of using hydrogen as fuel when using the method of its production during the decomposition of hydrogen-containing molecules of liquid-phase organic compounds in a plasma discharge under the action of intense ultrasonic exposure are considered. Experiments have shown that as a result of decomposition in the acoustoplasma discharge of liquid hydrocarbons, solid-phase carbon-containing products are formed, chemical transformations occur in the liquid phase and hydrogen-containing combustible gas is formed. Hydrogen-containing gas can be used as fuel immediately after synthesis, i.e. it does not require separation, since in addition to hydrogen it contains only impurities of CO₂ and water vapor. The purpose of the study is to formalize the basic conditions for tightening the control of mutual compliance with the efficiency of hydrogen engines of the same series in the conditions of their mass production. Methods of mathematical statistics and hardware-software modeling were used in the study. The term “unerroric of quality mutual compliance control” is introduced to describe a set of hardware and software tools for such control. The principle of in-depth testing of the technical condition of such engines of one series is described in a multidimensional formulation of the quality control problem for three of their operating parameters at once. The conditions for increasing the mutual correspondence of the measured values of such parameters in the conditions of serial production of hydrogen engines are formalized.     

小型锅炉烟尘测试时锅炉出力的计算

锅炉烟尘测试时,必须对锅炉出力进行测试。但监测中,许多小型锅炉往往不具备相关的计量装置和仪表,为解决这一问题,文章提出了用烟气量和空气过剩系数来计算锅炉的出力的公式,在实际使用中,该方法简单易行,其结果和实测值具有很好的一致怀。     

MgO膨胀剂细度对MgO水化和水泥浆体膨胀的影响

基于《水工混凝土掺用氧化镁技术规范》中的Ⅰ型氧化镁（MgO）,研究了该型MgO膨胀剂（MEA）细度对掺粉煤灰水泥浆体膨胀性能的影响。即采用X射线衍射分析(XRD)及同步热分析（TG DSC）分析了掺MEA水泥浆体中MgO的水化性。结果表明,养护温度相同时,MEA的细度对水泥浆体内MEA中MgO的水化和水泥浆体的膨胀无显著影响,产生的膨胀均能补偿水泥浆体的收缩;MEA的细度可从试验设计采用的45 μm筛筛余15%左右增加到30%左右,这将有利于MEA生产企业的节能降耗。     

Heat of vaporization of mixtures

General expressions for the heat of vaporization of mixtures at constant pressure; at constant temperature; and at constant pressure, temperature, and composition are proposed. The last one is related to the liquid-vapor interface where steady vaporization or condensation is taking place. Numerical examples by the proposed expressions are shown for binary mixtures of HCFC22(R22) and (HCFC123(R123) © 1997 Scripta Technica, Inc. Heat Trans Jpn Res, 25(1): 12–24, 1996     

生物质催化热裂解技术的研究进展

生物质催化裂解是生物质热化学转化的一种重要途径。综述了生物质催化热裂解技术使用的反应器、催化剂类型,以及催化热裂解过程中热裂解温度、吹扫气、升温速率、生物质原料等条件的影响,展望了生物质催化热裂解技术的发展趋势。     

燃烧流化床气泡能量分布模型

应用瞬态谱分析方法对燃烧流化床声波信号进行了频谱分析,发现气泡能量分布呈Ｇａｍｍａ分布形式,在Ａｒｇｙｒｉｏｕｓ和Ｙｏｓｈｉｄａ等人提出的模型的基础上,发展了燃烧流化床气泡能量分布模型,并通过优化迭代对模型参数进行求解,在实验和理论的基础上得出了更加切合实际的燃烧流化床气泡能量分布模型     

中国煤炭地下气化技术的发展

本文综述了煤炭地下汽化技术的国内外发展现状,对我国“长通道、大断面”煤炭地下气化新工艺给予了技术经济评述,并提出了发展煤炭地下汽化技术的政策建议。     

Review of theory of distortion and disintegration of liquid streams

Linear and nonlinear analyses of the instabilities and distortion of liquid streams injected into a gaseous media are discussed. The various fundamental mechanisms and the predictive capabilities for the distortions are emphasized. Round jets, planar sheets, annular sheets, and conical sheets are discussed in detail. The balance between capillary and inertial forces is primarily examined. The method for simplifying the analyses in the case of thin liquid sheets is discussed. The capabilities for representing the droplet size distribution that follows the stream disintegration are outlined.     

促进城镇生活污水处理装置产业化

城镇生活污水处理装置是由农村户用沼气地发展演变而来，是一种小型、分散化处理污水的装置 ，是环境建设的需要。文章着重从我国环保政策及目标、生活污水造成的污染状况、急需整治的公共设施、生活污水净化装置的演变以及社会经济效益和环境效益等方面，阐述了其产业化的重要性。     

Investigation of effect of variation of cycle parameters on thermodynamic performance of gas-steam combined cycle

The paper deals with second law thermodynamic analysis of a basic gas turbine based gas-steam combined cycle. The article investigates the effect of variation of cycle parameters on rational efficiency and component-wise non-dimensionalised exergy destruction of the plant. Component-wise inefficiencies of the combined cycle have been quantified with the objective to pin-point the major sources of exergy destruction. The parameter that affects cycle performance most is the TIT (turbine inlet temperature). TIT should be kept on the higher side, because at lower values, the exergy destruction is higher. The summation of total exergy destruction of all components in percentage terms is lower (44.88%) at TIT of 1800 K & r_p,c = 23, as compared to that at TIT = 1700 K. The sum total of rational efficiency of gas turbine and steam turbine is found to be higher (54.91%) at TIT = 1800 K & r_p,c = 23, as compared to that at TIT = 1700 K. Compressor pressure ratio also affects the exergy performance. The sum total of exergy destruction of all components of the combined cycle plant is lower (44.17%) at higher value of compressor pressure ratio (23)& TIT = 1700 K, as compared to that at compressor pressure ratio (16). Also exergy destruction is minimized with the adoption of multi-pressure-reheat steam generator configuration.     

机车车轮多轴疲劳强度安全评定的研究

使用ANSYS8.0软件对高速列车车轮进行了三维有限元分析,计算出车轮在直线、曲线和道岔条件下牵引、制动共6种工况时孔边薄弱部位的应力,分别通过Mises等效平均应力方法、Sines平均主应力方法和应力分量中考虑平均应力方法计算出应力在极值位置时的等效应力幅、等效平均应力,从而进一步算出车轮的安全系数,对其疲劳强度进行评定,并对3种方法进行了比较研究。     

Constructal optimization of the geometry of an array of micro-channels

This paper documents the geometric optimization of an array of circular and non-circular ducts. The optimization was carried out numerically using finite volume method. As optimal dimensions were independent of the array configuration, the numerical simulation was performed on a unit cell. Numerical optimization for circular, square and isosceles right triangle cross-sections of channels was performed. Based on the results of this investigation, some correlations were proposed to predict the optimal hydraulic diameter and dimensionless heat transfer per unit volume. In addition to examining the effect of pressure drop on these parameters, it was showed that among the different geometries of this study, square cross-section has the most efficiency for a given volume. The numerical results of the present study were compared with approximate results reported in the literature which a good agreement was observed.     

Variation of activation energy of hydrogen absorption of vanadium as a function of aluminum

Hydrogen absorption kinetics of vanadium–aluminum alloys in the temperature range of 624–924 K have been studied. These alloys were prepared by the aluminothermy process and refined by electron beam melting. The data of instantaneous reacted fractions at four different temperatures were obtained using the pressure drop method and these data were linearly fitted to a suitable reaction mechanism function. Three-dimensional diffusion appears to be the intrinsic rate limiting step of the hydrogen absorption. The rate constants were obtained from the slope of the linearly fitted curves. Apparent activation energies were calculated using the Arrhenius equation. The activation energies were increased linearly with aluminum content resulting in a decrease in the hydrogen absorption rate. The variation in standard entropies and enthalpies of vanadium–hydrogen solid solution has been studied as a function of aluminum content.     

分选机制砂对混凝土性能影响试验研究

平江抽水蓄能电站泵送混凝土使用的花岗岩为主的人工细骨料,云母含量较高.通过分选工艺降低游离云母的机制砂配制混凝土,性能试验结果表明:分选后机制砂混凝土拌和物混凝土用水量减少,混凝土工作性能提高,混凝土的抗冻性能得到改善.     

固体热辐射Yong性能分析

本文对漫灰均温物体在常物性条件下对外辐射传热的Ｙｏｎｇ值计算建立了数学模型。通过与物体内能Ｙｏｎｇ公式的数值计算比较,得出了辐射能量的Ｙｏｎｇ值不大于内能Ｙｏｎｇ值的结论。从初步的热射Ｙｏｎｇ值计算公式发现。Ｙｏｎｇ与物体表面辐射率有关。     

汽轮机零件防锈性能的改善

介绍了汽轮机零件的封存特点、防锈要求及防锈油性能对比试验的方法,通过对试验结果的对比分析,客观验证了各种防锈油的性能。试验表明,只有选择了合适的防锈油,才能保证汽轮机零件长期封存的质量。     

Measurements of concentration distribution of hydrogen jet using deflection of center of the laser spot

The main purpose of this work is to propose a new method to evaluate the concentration distribution of the hydrogen jet by using a He–Ne laser through the jet. This research attempts to apply the expression of concentration Gaussian distribution, the refraction formula of inhomogeneous refractive index medium, and the concentration inversion function to disclose the displacement of the center of the laser spot at different heights in the gas jet. The spot images of the laser beam passing through the gas jet at three vertical heights z = 10d, 20d, 30d, and different radial positions are obtained. The radial spatial asymmetry of the gas jet is also found in the experiment. Finally, the calculated concentration distribution curve and the fluent simulation curve, it is found that the two results are very similar. Our findings show that the error between the concentration distribution of this method and the simulated concentration distribution reaches 2.43%.     

太阳能综合利用技术探讨

介绍了太阳能利用技术发展史及现状,包括光伏产业、太阳能热水器、太阳能空调降温、太阳能热发电、太阳房以及太阳能热利用的其他方面。     

Impact of nanostructuring on the enthalpy of formation of metal hydrides

High-energy ball milling has been shown to decrease the release temperature, increase the reaction kinetics, and lower the enthalpy of formation of metal hydrides in certain cases. This paper discusses several potential mechanisms for the reduction of the enthalpy of formation. Although the increased surface and grain boundary energy could play a role in reducing the enthalpy of formation, the predicted magnitude is too small to account for experimental observations. Structural deformation and the associated volume change provide another mechanism for the change in this thermodynamic property. We employed three equations of state models to characterize the excess energy present in the deformed regions and found that the excess volume provides a plausible explanation for the experimentally observed change in thermodynamic properties.     

煤粉燃烧反应动力学参数的试验研究

采用热天平,在２０℃／ｍｉｎ的升温速度下,对１２种煤的燃烧反应动力参数进行了试验研究,得到表面反应违率系数ＩｎＫｓ与１／Ｔ间的关系曲线呈三段线性分布,其分界点温度与由燃烧特性曲线所得到的着火温度及最大燃烧速率对应的温度相一致。此外,通过计算得到了活化能与Ｅ与煤的组成成分间的变化规律及Ｅ和频率因子Ｋ两者的关系曲线。图１０表１参３