共查询到20条相似文献,搜索用时 125 毫秒
1.
2.
<正> 最近国外专利报导了一种锌导电浆料,特别适用于制作陶瓷电容器、可变电阻器以及其它电子元件的电极。 通常,陶瓷电容器和可变电阻器的电极浆料为银浆料,由银粉,玻璃粉和有机载体组成。但是,用贵金属银作电子元件电极,成本较高。 相似文献
3.
LaNiO3导电金属氧化物薄膜在现代应用科学研究中作为电极和过渡阻挡层倍受青睐,它具有很好的导电特性和稳定性。该文采用射频溅射法制备了具有(100)择优取向的赝立方结构LaNiO3-x薄膜,并进行了原位热处理。实验结果表明,在265℃的处理条件下,LaNiO3薄膜表现出不稳定性,晶格中的氧在2h内失去了2.7%。氧的损失对品格结构没有明显影响,但薄膜的导电性能明显下降,折射率和消光系数也具有相同幅度的下降。对薄膜的应用具有一定的影响。该文从LaNiO3薄膜的导电机理方面对实验现象给出了分析和解释。 相似文献
4.
用溶胶-凝胶工艺在披覆了LaNiO3底电极的(100)Si衬底上制备了Bi3.15Nd0.85Ti3O12(BNdT)铁电薄膜.X射线衍射结果显示,LaNiO3层呈(110)择优取向,BNdT薄膜呈c轴和a/b轴混合择优取向.透射电镜观察表明,LaNiO3电极层和BNdT薄膜厚度分别约为180 nm和320 nm.BNdT薄膜分为上下两层,厚约100 nm的底层以薄片状c轴择优取向晶粒为主,在顶层许多柱状晶粒为a/b轴择优取向.讨论了BNdT薄膜在(110)LaNiO3电极上的择优取向生长机制. 相似文献
5.
6.
7.
8.
碳膜电位器端头用铜银导电浆料的研究 总被引:1,自引:1,他引:0
碳膜电位器端头一般用银导电浆料,以微细片状银粉作导电相。本文的研究工作试图以铜代替部分银,并根据碳膜电位器端头导电性及表面光泽度的要求,适当调整铜扣银含量的比例,通过大量的实验,给出了最佳条件。 相似文献
9.
10.
采用传统固相反应法制备了Mn2.1Ni0.9O4热敏陶瓷,运用X射线衍射仪、直流阻温测试仪、交流阻抗技术对其结构和电学性能进行了测试,并对Mn2.1Ni0.9O4热敏陶瓷的微观导电机理进行了分析。结果表明:Mn2.1Ni0.9O4热敏陶瓷由立方尖晶石相和岩盐相NiO组成。其电阻主要来源于晶粒和晶界的贡献,在293~363 K测试温区内,其晶粒电阻和晶界电阻都表现出明显的NTC特性,且两者导电机理均符合小极化子跳跃电导模型,晶界电阻受岩盐相NiO的影响大于晶粒电阻。 相似文献
11.
In this paper, the effect of silver oxalate addition on physical characteristics of metallo-organic-decomposition (MOD) silver screen-printable paste for thick film technology was investigated. The addition of silver oxalate in the paste not only produces fresh fine silver particles after curing, but also reduces the decomposition temperature of the lubricant coated on the silver flakes. This is an effective route to provide fine silver particles to the paste without significantly changing the rheological behavior. At the curing temperature of 225 °C, the resistivity decreases from 180.1 to 31.9 μΩ-cm, as the silver oxalate content increases from 0 to 10 wt%. This is due to the fact that active silver catalysts produced increase the packing density of silver flakes, and also the removal of lubricant from the surface of silver flakes enhances the electrical conductivity, thereby decreasing the resistance of film. 相似文献
12.
We have explored the electrical conductivity of thick films made from silver methylcarbamate paste using metallic silver as the electrically conductive phase. The paste was composed of 30 wt.% to 90 wt.% organic vehicle and 10 wt.% to 70 wt.% functional phase precursor (silver methylcarbamate). After the paste was sintered, films with thickness of 4.50 μm to 12.70 μm were obtained, in which the elemental percentage of silver varied from about 5 wt.% to above 99 wt.%. Experiments showed that both the electrical conductivity and the elemental percentage were mainly affected by the initial silver content in the paste and the parameters of the sintering process. For given sintering conditions, higher initial silver content led to higher elemental percentage of silver, improving the electrical conductivity of the thick film. The conditions of the sintering process had a significant influence on the evaporation and decomposition rates of the paste components, the elemental percentage of silver, and the microstructure of the thick film. Higher temperatures, longer times, lower heating rates, and more oxygen-rich sintering atmospheres were found to accelerate the evaporation and decomposition and increase the elemental percentage of silver, both of which served to enhance the electrical conductivity. For initial silver contents less than about 10 wt.%, the lowest electrical resistivity of the thick film only reached the order of 10?4 Ω cm, irrespective of the sintering conditions. For contents between 10 wt.% and 25 wt.%, it was possible to attain lowest resistivity values on the order of 10?5 Ω cm. Above 25 wt.%, the lowest resistivity could reach 10?6 Ω cm, comparable to that of bulk silver. 相似文献
13.
纳米银有多种形态,高导电率的纳米银应具有片状结构,同时复合有部分小颗粒的球形纳米银。本文利用AgNO3和H2C2O4溶液反应使Ag2C2O4沉淀,分析草酸银的热分解行为,研究了分散性较好的球形纳米银晶状体颗粒的制备方法。实验表明:在配位剂三乙醇胺、DMF和分散剂PVP的存在下,利用AgC2O4的自身氧化还原性,在85℃左右加热4 min可得到球形纳米银晶粒,将其分散在乙醇中并混入之前制备好的片状纳米导电银浆中进行烧结,其导电效果好于结构单一的纳米银浆。 相似文献
14.
15.
采用优化后的玻璃粉配制成导电银浆,与MgSiO3-CaSiO3生瓷片共烧后形成导电厚膜,探讨了不同玻璃粉配方对所制厚膜的微观结构、热学性能、附着力、线膨胀系数和导电性能的影响,研究了导电银浆与基片低温共烧的匹配性能。结果表明,SiO2-Al2O3-B2O3-CaO-Li2O系玻璃粉配制的导电银浆低温共烧后获得的导电厚膜平滑、均匀、致密;随着该系玻璃粉中Li2O含量的增加,导电银浆的线胀系数逐渐降低;Li2O的质量分数为6%时,该浆料线胀系数最低,为18.482×10–6℃–1;Li2O的质量分数为2%时,导电厚膜与基片的线膨胀匹配性良好,导电性能最好,方阻为3.02 m?/□。 相似文献
16.
Cheng Yang Yu‐Tao Xie Matthew Ming‐Fai Yuen Bing Xu Bo Gao Xiaomin Xiong C. P. Wong 《Advanced functional materials》2010,20(16):2580-2587
The electrical conductivity of a silver microflake‐filled conductive composites is dramatically improved after a filler surface treatment. By a simple iodine solution treatment, nonstoichiometric silver/silver iodide nanoislands form on the silver filler surface. Evidence of the decrease of surface silver oxide species is provided by TOF‐SIMS and the redox property of the nanoclusters is studied using cyclic voltammetry and TOF‐SIMS depth profile analyses. The redox property of the nanoclusters on silver flakes helps enhance the electrical conductivity of the conductive composites. The electrical resistivity of the improved conductive composites is measured by four‐point probe method; the reliability of the printed thin film resistors is evaluated by both the 85 °C/85% relative humidity moisture exposure and the −40 ∼ 125 °C thermal cycling exposure. The conductive composite printed radio frequency identification (RFID) antennas with 27.5 wt% of the modified silver flake content show comparable performance in the RFID tag read range versus copper foil antennas, and better than those commercial conductive adhesives that require much higher silver content (i.e., 80 wt%). This work suggests that a surface chemistry method can significantly reduce the percolation threshold of the loading level of the silver flakes and improve the electrical conductivity of an important printed electronic passive component. 相似文献
17.
18.
19.
20.
用于氮化铝陶瓷基片的电子浆料 总被引:2,自引:0,他引:2
研制了用于AlN陶瓷基片的导体银浆和电阻浆料。采用低PbO含量晶化玻璃料配制银导体浆料,玻璃软化点430~450℃。电阻浆料采用PbO(质量分数小于6%)的晶化玻璃料B、C、D三种,软化点分别为520℃、690℃、610℃。改变RuO2与玻璃相的质量比,能控制电阻浆料的方阻值。质量比在50比50至15比85之间。加入添加剂MnO2可改善电阻浆料的TCR,阻值在20Ω/□~1MΩ/□范围内,TCR绝对值小于200×10-6/℃。 相似文献