Broadband printed ring-slot array with circular polarisation

A novel design of a printed ring-slot antenna with circular polarisation (CP) is first proposed. The CP radiation of the slot antenna is achieved by a series microstrip-line feed configuration. Using the single CP slot antenna as an array element, the 1times2 and 2times2 slot arrays are constructed and measured. To obtain wider CP bandwidth, phase sequential rotation technique is applied to the feed network of these printed slot arrays. The experimental results show that the 2times2 slot array antenna is capable of 15% bandwidth for an axial ratio of less than 3 dB     

Circularly polarised circular ring slot antenna fed by striplinehybrid coupler

A novel circular ring slot antenna which has a stripline hybrid coupler feed network is proposed for generating broadband circular polarisation performance. A broad impedance bandwidth (VSWR 2:1) at 20.5%, and a CP bandwidth at 9% for a <3 dB axial ratio have been achieved     

Performance of a cross-aperture coupled single feed circularlypolarised patch antenna

A novel method for radiating circular polarisation (CP) with a patch antenna without an external polariser has been investigated. It has the advantage of improving the axial ratio bandwidth for single feed CP antennas by using a thick air substrate and inverted patch configuration     

Small circularly polarised folded patch antenna

A small circularly polarised (CP) patch antenna with dual T-shaped probe feeds is presented. The patch is folded like a cap to generate a CP wave as well as to reduce the size of the antenna. The proposed antenna is operated at the centre frequency of 2.28 GHz with circular polarisation. The impedance bandwidth (SWR<2) is 21.8% from 2 to 2.49 GHz and the axial ratio bandwidth (AR<3 dB) is 3.5%. The measured gain is around 7.5 dBi. The antenna shows a good CP performance with a symmetric radiation pattern. The total area of reduction is 54% in comparison with the conventional half-wave patch antenna.     

Fractal boundary circularly polarised single feed microstrip antenna

A Koch fractal boundary circularly polarised single feed microstrip antenna is presented. The proposed antenna gives very good circular polarisation with axial ratio close to 0 dB at the centre frequency of 2510 MHz, 3 db axial ratio bandwidth of about 1.6% and impedance bandwidth of 6.2%. Tt is established that it is easy to obtain circular polarisation using the fractal curve as the boundary. The antenna provides about 6 dB gain over the frequency band of operation.     

Broadband circularly polarised crosspatch- loaded square slot antenna

A new design of a circularly polarised square slot antenna loaded with a cross patch is presented. A cross patch inclined diagonally with respect to the square slot is placed at the centre of the square slot. By choosing proper dimensions of the cross patch, two orthogonal resonant modes with a 90deg phase difference for circular polarisation can be excited and feed the square slot antenna using a 50 Omega CPW with a protruded signal strip. 10 dB return loss bandwidth of 846 MHz (39.6%) and 3 dB axial ratio bandwidth of 240 MHz (12.4%) for the proposed antenna are achieved. Gain variation within the CP bandwidth is observed to be less than 1 dB     

Dual-loop slot array antenna radiating circularly polarised wave

An array antenna consisting of dual-loop slot elements with a simple feeding system is realised. Each dual-loop element has two loop slots that are simultaneously fed by a single triplate transmission line. A narrowed beam, of circular polarisation, with an axial ratio of less than 3 dB, is obtained over a 3% bandwidth. The measured radiation pattern agrees well with a pattern calculated using array theory.<>     

Microstrip-fed crossed-slot array antenna

A microstrip-fed crossed-slot array antenna having a circular polarisation is developed. First, a single crossed-slot antenna, that can radiate a circularly polarised wave in the broadside direction, is designed and its coupling level to the microstrip line is analysed. Based on this result, an eight-element crossed-slot array is designed and its characteristics are experimentally investigated at 12 GHz band. The return loss of -17 dB is obtained at the design frequency of 11.85 GHz, and the axial ratio of less than 3 dB is achieved over the fractional bandwidth of 5%.     

Broadband high-efficiency circularly polarized active antenna and array for RF front-end application

This paper presents a broadband high-efficiency circularly polarized (CP) active integrated antenna, and a broadband CP active array at 2 GHz. To realize the broadband CP antenna, a circular patch is aperture coupled by crossed slots in the ground plane, which are fed by an L-shaped microstrip feed line below the ground. The antenna is designed to serve the functions of both a radiator and a harmonics-terminated load for class-E high-efficiency power-amplifier (PA) integration. The broadband CP active antenna is realized by directly integrating the broadband CP antenna with the class-E PA. It achieves a 9% bandwidth (1.84-2.01 GHz) for axial ratio (AR) below 3 dB, and a 12% bandwidth for power-added efficiency (PAE) over 60%. To form the broadband CP active array, four active antenna elements are sequentially rotated, and each element is directly integrated with broadband class-E PA. A low-cost printed-circuit-board technology is employed in fabrication and a pseudomorphic high electron-mobility transistor is used. A peak drain efficiency of 71.5% for the class-E amplifier is measured at 1.95 GHz. The active array achieves a peak-effective radiated power of 39.7 dBm, and PAE is over 50% within a 22.6% bandwidth (1.72-2.16 GHz). The AR is below 3 dB over a 27% bandwidth (1.72-2.26 GHz).     

一种寄生阵列宽带圆极化天线的设计

该文设计了一款C波段单馈寄生阵列的宽带圆极化天线。此天线采用紧邻的双层F4B介质基板,通过在方形驱动贴片上开槽及采用寄生阵列的设计实现了圆极化。对天线结构的设计步骤进行说明,研究了各结构对天线阻抗带宽和轴比带宽的影响,并研究了寄生贴片切角长度和驱动贴片上的缝隙宽度对天线轴比和带宽的影响。对天线的圆极化方向图进行了仿真。仿真结果表明,在5.5 GHz时实现了右旋圆极化,最大增益为8.1 dBi。加工并测试了宽带圆极化天线,测试结果与仿真结果基本相符,天线实测的阻抗带宽为1.3 GHz,轴比带宽为1.26 GHz。设计的叠层天线具有结构紧凑,装配简单和轴比带宽大的优点。     

Circularly polarised microstrip antenna array using proximitycoupled feed

A 2×2 circularly polarised (CP) microstrip antenna array using a proximity coupled feed and sequential rotation is described. As compared with a previously presented single-element circularly polarised microstrip antenna with a cross-slot, the new array achieves a much wider impedance bandwidth of 11.18% and has an axial ratio bandwidth of 4.1%. The return loss, radiation patterns and axial ratio of the antenna array were measured and are presented     

Broadband circularly polarised slot loop antenna fed by three-stubhybrid coupler

A microstrip slot loop antenna with a three-stub hybrid coupler feed network is proposed for generating broadband circular polarisation. A very broad bandwidth of 55.6% at 2:1 VSWR and 22.2% bandwidth for <3 dB axial ratio was achieved     

W 波段圆极化微带阵列天线设计

本文分析和对比了W 波段圆极化微带阵列天线不同的馈电形式,完成了圆极化阵列天线的设计。由理论分析 和仿真结果可知,单元间等幅同相馈电有利于W 波段圆极化微带阵列天线的实现,其2x2 阵列天线仿真结果驻波小于2 的相对带宽为3.5%, 轴比小于3dB 带宽为2%,中心频点94GHz 时天线增益为12.2dB。该天线在军事领域具有广泛的应 用前景。     

Stacked quasi-elliptical patch array with circular polarisation

A simple stacked subarray antenna with circular polarisation is presented. The antenna is based on a quasi-elliptical patch antenna fed with a 45deg offset microstrip line and a circular patch stacked on top of it via an air substrate. The single-element circularly polarised antenna is sequentially rotated into a four-element synchronous subarray resulting in improvement in antenna performance in terms of impedance bandwidth, gain and axial ratio. The antenna is experimentally verified and the results are reported     

Low-Cost Broadband Circularly Polarized Printed Antennas and Array

This paper presents the design, simulation, and measurements of two low-cost broadband circularly polarized (CP) printed antennas: an element and an array at 2 GHz. To realize the broadband circularly polarized antenna element, a circular microstrip patch is electromagnetically coupled by crossed slots cut in the ground plane, which is fed by an L-shaped microstrip feed. Two orthogonal modes in the patch are excited by using the crossed slots, and a single L-shaped feed provides a 90deg phase shift between two orthogonal slots. The antenna element achieves a 9.6% bandwidth for an axial ratio (AR) below 3 dB and a voltage standing wave ratio (VSWR) below 1.5. To further improve the performance, a sequentially rotated feed network is designed for a 2 times 2 array. The axial ratio value of the array is below 3 dB within a 27.2% bandwidth, from 1.75 GHz to 2.3 GHz. The return loss is above 10 dB within a 41% bandwidth, from 1.62 GHz to 2.45 GHz. Details of the proposed antenna element and the array design are described, and both the simulation and the experimental results are presented and discussed.     

Broadband circularly-polarised microstrip antenna with switchable polarisation sense

A circularly-polarised microstrip antenna capable of switching polarisation sense is presented. The proposed microstrip antenna has a circular radiating patch and is excited by an open-loop microstrip line through the coupling of a ring slot in the ground plane. Two ends of the open-loop microstrip line can be taken for the input ports to excite right-hand and left-hand circular polarisations, respectively. A prototype using PIN diodes to electrically switch the input ports is implemented, and the measured results show the 3 dB axial ratio bandwidth of more than 10% can be obtained at the two polarisation senses     

Broadband circularly polarised hexagonal slot antenna excited by a tapered microstrip feeder

In this article, a broadband circularly polarised slot antenna fed by a single microstrip line is implemented. The proposed antenna is composed of an unequilateral hexagonal slot to implement circular polarisation and tapered microstrip feeding line to enhance the impedance bandwidth. A conducting reflector is also employed to enhance the antenna gain. The proposed antenna, 60 mm × 60 mm × 18.12 mm in size, was fabricated and tested. The measured??10 dB reflection bandwidth and 3 dB axial ratio bandwidth were 48.9% and 17%, respectively. The measured gain of the fabricated antenna ranged from 5.4 dBi to 6 dBi within an axial ratio bandwidth of 3 dB.     

Circular polarisation design of a single-feedequilateral-triangular microstrip antenna

By inserting a narrow slit at the edge of an equilateral-triangular microstrip patch, circular polarisation (CP) radiation can be obtained using a single probe feed. This CP design is easy to implement. Details of the antenna design are described, and experimental results of the axial ratio and radiation pattern are presented and analysed     

Single-feed circularly polarized microstrip ring antenna and arrays

An analysis is presented for a microstrip-feed proximity-coupled ring antenna and a four-element array. Interactions between the embedded microstrip feed and the radiating element(s) are rigorously included. Results demonstrate that circular polarization of both senses can be achieved with a ring antenna with proper design of two inner stubs located at angles of ±45° with respect to the feedline. Theory and experiment demonstrate an axial ratio 3-dB bandwidth of 1% and the voltage standing wave ratio (VSWR) <2 bandwidth of 6.1%. The axial ratio bandwidth is typical for a microstrip antenna with perturbations, while the VSWR bandwidth is larger than for the circular or rectangular patch with perturbations. A mutual coupling study between two elements shows that the axial ratio is less than 2 dB for interelement spacing greater than 0.55λ_eff, while the VSWR <2 for all spacings considered. A comparison between theory and experiment is provided for a 2×2 element array. The benefits of sequentially rotating the antenna elements in an array environment are presented. The axial ratio and VSWR bandwidths are both increased to 6.1% and 18% for a four-element array. A single-element antenna with two orthogonal feeds to provide both senses of polarization is demonstrated. The ring antenna is small (D/λ₀=0.325), the substrate thickness is thin (H/λ₀~0.035), and the microstrip feed produces a completely planar antenna system, which is compatible with microwave and millimeter integrated circuits (MICs), and monolithic microwave integrated circuits (MMICs)     

一种新型环状宽带圆极化微带天线设计

本文设计了一种新型的环状开缝的宽带圆极化微带贴片天线,通过等幅度90°相位差的L型探针馈电。通过在环状贴片上开槽可以有效的增加轴比和阻抗带宽。传统的圆极化天线带宽受限于阻抗、轴比和增益的公共带宽,本文提出的天线得到有效带宽从1.1GHz到1.9GHz,相对带宽达到了53%以上,频带覆盖了GPS、GALILEO、COMPASS、GLONASS四大导航系统。该天线性能较好,加工调试简便,在卫星导航等领域具有广阔的应用前景。