共查询到19条相似文献,搜索用时 734 毫秒
1.
2.
为了提高光网络中波长资源的使用效率,利用光纤中瞬态受激拉曼散射效应分析理论,设计了一种基于掺锗光子晶体光纤的可调谐四通道波长转换器。由于受激拉曼散射效应的增益随信号光与探测光波长之间的频移量变化,波长转换器各个转换信道波长可由探测光波长调谐。分析了泵浦信号光输入功率对多波长转换器性能的影响,结果表明:随着输入泵浦功率的增大,多路波长转换器的转换性能更好。用OptiSystem对四通道可调谐波长转换进行仿真,结果表明:所设计的波长转换器能够同时实现四通道波长转换,各信道波长可在1 511~1 569nm进行调谐。 相似文献
3.
基于光纤中前向瞬态受激拉曼散射效应分析理论,利用光子晶体的高非线性特性,对光子晶体光纤拉曼波长转换进行了数值分析,并建立了全光波长转换设计方案的理论模型,给出了设计原理框图及实现方法。用OptiSystem对四路探测光进行波长转换仿真,仿真结果表明:所设计的全光波长转换器同时对四路探测光实现波长转换,转换输出的信号光码型和输入泵浦信号光码型一致,并且所得到的眼图线迹清晰,眼睛张开度良好。论证了该设计方案可行。 相似文献
4.
5.
6.
7.
8.
实验研究了基于半导体光放大器(SOA)的四波混频(FWM)效应的单抽运光正交频分复用(OFDM)信号的波长变换系统.信号光源和抽运光源分别由两个不同输出波长的可调分布反馈式激光器(DFB-LD)产生.信号光源经2.5 Gb/s OFDM的电信号直接调制后再和抽运光源耦合,经光放大器后在SOA实现波长变换.实验结果显示,耦合信号经SOA四波混频效应后,产生新波长的信号光将携带OFDM信号,且转换效率与信号光和抽运光的功率、波长以及两者的偏振夹角有关.同时也测量了转换的OFDM信号的功率-误码曲线和接收星座图. 相似文献
9.
基于半导体光放大器中交叉偏振调制效应的波长转换器 总被引:6,自引:2,他引:4
了改善基于半导体光放大器(SOA)中交叉偏振调制效应(CPM)的波长转换器的转换信号码型效应,对交叉偏振调制一半导体光放大器波长转换器的工作原理进行了分析;通过讨论交叉偏振调制一半导体光放大器波长转换脉冲的上升沿和下降沿的频率啁啾,结合滤波器的透过谱特性,提出了一种利用滤波器的波长正斜率边和波长负斜率边分别对正相转换信号和反相转换信号进行码型优化的方案,并进行了实验验证。在信号码率为10Gb/s的交叉偏振调制一半导体光放大器波长转换实验中,采用光带宽为0.3nm的JDS滤波器优化转换信号的波形,基本消除了转换信号中长“1”码和长“0”码的码型效应,并将正相转换信号和反相转换信号的功率代价分别改善了3dB以上。 相似文献
10.
11.
交叉增益型波长转换器的实验研究 总被引:1,自引:0,他引:1
全光波长转换器是全光网络中的关键光电子器件.基于半导体光放大器的交叉增益型波长转换器具有结构简单容易实现、转换效率高、波长转换范围宽以及转换速率高的特点.文中在自行研制半导体光放大器的基础上,对交叉增益型波长转换器进行了实验研究.讨论了实现波长转换的基本原理,描述了实验系统结构,实现了速率为140Mbit/s的1315nm和1301nm之间的波长转换.研究了波长转换器泵浦光功率、探测光功率以及放大器注入电流转换效率、消光比和噪声特性的影响,研究结果与文献中报道的相同.研究表明,不同因素对不同指标的影响是相互制约的,要全面提高波长转换器的性能,必须折衷考虑各方面的因素.研究结果对半导体光放大器结构参数的优化和波长转换工作条件的优化有一定的指导作用. 相似文献
12.
San-Liang Lee Pei-Miin Gong Chin-Tien Yang 《Photonics Technology Letters, IEEE》2002,14(12):1713-1715
We propose to use an additional injection beam of short wavelength to enhance the wavelength conversion that utilizes the four-wave-mixing effect in a semiconductor optical amplifier (SOA). The experiments demonstrated larger than 5-dB improvement on conversion efficiency, as the SOA is biased at the corresponding transparent condition for the assisted beam. At such a condition, an assisted beam can increase the saturation intensity without sacrificing the gain of an SOA, and this leads to an increase in conversion efficiency. The assisted beam also improves the signal-to-background-noise ratio in wavelength conversion. The effects of different assisted wavelengths and the measures for further improvement are discussed. 相似文献
13.
对基于半导体光放大器(SOA)交叉增益调制(XGM)效应的全光波分复用一光时分复用(WDM—OTDM)转换后的两路时分复用输出信号的消光比(ER)特性进行了分析。研究了两路波分复用的输入抽运光和探测光的功率、波长、抽运光的消光比、数据速率以及半导体光放大器的偏置电流、腔长和模场限制因子对转换信号消光比的影响。模拟结果表明,增大抽运光输入功率,选择长波长抽运光,可以增加转换光相应信道消光比,但减小了相邻信道的输出消光比;增加抽运光消光比,可以提高转换光消光比,但各个信道增长幅度不同;减小探测光输入功率,选取短波长探测光波长,增加半导体光放大器的腔长和模场限制因子以及大的偏置电流可提高转换光消光比;对于两路或多路波分复用信号转换时分复用信号的过程中,一定要考虑转换光每个信道消光比的均衡。 相似文献
14.
15.
16.
17.
18.
A novel room-temperature multiwavelength erbium-doped fiber (EDF) laser is demonstrated. Stable multiwavelength lasing at room temperature is realized by incorporating a semiconductor optical amplifier (SOA)-based phase modulator in the laser cavity. The SOA is biased below the transparent point with a sinusoidal signal applied to achieve phase modulation, to suppress the homogenous line broadening of the EDF. Stable multiwavelength lasing with wavelengths up to 26 and wavelength spacing as small as 0.19 nm is demonstrated at room temperature. 相似文献
19.
The static performance of a wavelength converter obtained by a multisection distributed Bragg reflector (DBR) laser with a saturable absorber between two gain sections is analyzed. For this device an optical input signal at one given wavelength is converted into an output signal at the lasing wavelength. The performances are evaluated in terms of conversion efficiency, suppression ratio, and minimum input power needed for wavelength conversion. It is shown that a proper choice of the injected signal wavelength with respect to the lasing wavelength enhances the conversion efficiency and the suppression ratio and reduces the switching power. The performance can be enhanced also by increasing the electrical current applied to the first gain section provided that the second gain section is biased above the transparency level. The authors have shown that reduction of the front facet reflectivity results in a dramatic increase for the conversion efficiency. The sensitivity to the electrical bias condition and to the resonant condition of the injected signal with respect to the cavity has also been investigated 相似文献