共查询到20条相似文献,搜索用时 490 毫秒
1.
N—氯代丁二酰亚胺8—羟基喹哪啶分光光度法测定水中苯胺类化合物的方法研究 总被引:3,自引:0,他引:3
本文提出一种能够方便、快速、灵敏地检测水质中苯胺在化合物的新方法。这种方法是先用 N-氯代丁二酰亚胺氧化苯胺 ,再用 8-羟基喹哪啶作为偶联显色剂 ,在 p H9- 1 1的碱性介质中 1进行显色。显色反应所得蓝色化合物的最大吸收波长为 62 0 nm,摩尔吸光系数为 1 .1× 1 0 4 L· mol- 1· cm- 1,在苯胺为 0 .2~ 1 0 mg/l的浓度范围内符和比尔定律 ,最低检出限为 0 .0 3mg/l,测定的重现性在± 5 %以内。该方法成功地用于环境水样的分析 ,并获得满意的分析结果 相似文献
2.
本文提出一种能快速灵敏地检测地面水和污水中苯胺类化合物的试剂盒。该方法是以 N-氯代丁二酰亚胺氧化苯胺 ,在 p H9- 1 1的碱性介质中 〔1〕,以 1 -萘酚偶联显色。显色反应所得的蓝色化合物的最大吸收波长为 61 0 nm,在苯胺浓度为 0 .2~ 8mg/L的浓度范围内符合比尔定律 ,最低检出限为 0 .0 2 mg/L ,测定的重现性在± 5 %以内。该试剂盒用于合成水样和环境水样的分析 ,回收率在 94.9~ 98.2之间。这种试剂盒可以成功地用于合成水样和环境水样的分析 相似文献
3.
水体中苯胺类化合物测定方法的改进 总被引:1,自引:0,他引:1
本文分别利用活性炭吸附、三氯甲烷萃取和前两种方法联用对显色剂 N-(1 -萘基 )乙二胺进行了提纯 ,从而使水体中苯胺类化合物测定方法的显色时间由 1 2 0 min(未提纯法 )缩短至 90 min(经三种方法提纯 ) ,显色剂溶液的稳定性有了明显的提高 ,测定方法的精密度得到了显著的改善 ,同时检出限也由 0 .3 0 mg/L (未提纯法 )分别降至 0 .0 48mg/L (活性炭吸附提纯法 )、0 .0 59mg/L(三氯甲烷萃取提纯法 )和 0 .0 3 1 mg/L(两种方法联用提纯法 ) ,用经三种方法提纯后的显色剂溶液测定水样中的苯胺 ,测定结果均令人满意 相似文献
4.
提出了用激光反射光声法测定水样中的苯胺,对方法原理、实验装置以及苯胺的最佳显色条件进行了详尽的讨论。该方法的检出限为0.23mg/L,苯胺定量线性范围1×10-5~1×10-3mol/L(r=0.9965),对1×10-5mol/L试样10次测量的相对标准偏差为1.8%,用本方法测定了几种废水样中苯胺的含量,回收率均达91%以上。 相似文献
5.
用激光反射光声法测定苯胺 总被引:1,自引:0,他引:1
提出了用激光反射光声法测定水样中的苯胺,对方法原理、实验装置以及苯胺的最佳显色条件进行了详尽的讨论。该方法的检出限为0.23mg/L,苯胺定量线性范围1×10-5~1×10-3mol/L(r=0.9965),对1×10-5mol/L试样10次测量的相对标准偏差为1.8%,用本方法测定了几种废水样中苯胺的含量,回收率均达91%以上。 相似文献
6.
7.
对还原-偶氮分光光度法测定水中硝基苯类实验装置进行改革,研究并建立了分析测定的优化实验条件。在此实验条件的基础上,对测定方法中的显色酸度、样品空白等测定条件进行了优化和补充;增加了苯胺类样品空白实验,解决了苯胺类样品及空白样品与体系酸度调节条件不一致的问题;同时拓宽了校准曲线的测定范围。硝基苯质量浓度在0~1.6 mg/L范围内线性关系良好,方法检出限为0.004 mg/L。用优化改进后的测定方法对水质硝基苯标准样品和实际废水样品进行分析测定,样品测定精密度(n=6)小于3%;加标实验回收率达到96.4%~101.8%。 相似文献
8.
利用还原型若丹明B(RRhB)与KClO3 的显色反应,对含镉(Ⅱ)陶瓷污泥中痕量镉(Ⅱ)进行测定。结果表明,在pH 5.3HAc -NaAc缓冲溶液中具有高灵敏的显色反应,产物的最大吸收波长为56 0nm ,该方法的检出限为3.0×1 0 -8gCd2 + /L ,催化程度与镉(Ⅱ)量在0~0 .0 4 5 /L范围内符合比耳定律,加标回收率为97.4 %~1 0 3.8% (n =6 )。结合KI—MIBK萃取分离,满意地测定了陶瓷污泥中的微量镉。 相似文献
9.
二溴邻硝基苯基荧光酮催化光度法测定粉煤灰中痕量锰 总被引:2,自引:0,他引:2
研究了在pH 1 0 .0的NH3 ·H2 O NH4Cl缓冲溶液中 ,痕量Mn(Ⅱ )催化过氧化氢氧化二溴邻硝基苯基荧光酮 (DBoN PFO)的显色反应 ,建立了测定痕量锰的催化光度新方法。催化程度与Mn(Ⅱ )量在 0 .0~ 5 0 .0 μg/L范围内呈线性关系 ,方法的检出限为 1 .1× 1 0 -8g/L。方法已用于粉煤灰中痕量锰的测定 相似文献
10.
本文筛选并研制出三种检测水中苯胺类化合物的试剂盒:邻甲氧基苯酚试剂盒、8-羟基喹啉试剂盒和1-萘酚试剂盒。邻甲氧基苯酚、8-羟基喹啉和1-萘酚分别在pH 9.2、12.2、12.2的氢氧化钠介质中与苯胺形成黄色、橙色和橙色偶氮化合物,它们的最大吸收波长分别位于450、480和491nm处,显然反应的摩尔吸光系数分别为3.036、4.235和4.146×104L.m o-l 1.cm-1,线性范围分别为0-5.6、0-4.8和0-4.0m g/L,检出限分别为8.0、0.0和12μg/L。这三种试剂盒用于水中苯胺类化合物的测定更加方便、快速、灵敏,线性范围更宽。这三种试剂盒应用于环境水样的测定,均获得了满意的分析结果。 相似文献
11.
乙烯酮(双乙烯酮)是十分重要的化工中间体,其下游产品较多。江苏某化工厂开发生产乙烯酮(双乙烯酮)下游产品三十多个,年生产规模三万多吨,是国内以乙烯酮(双乙烯酮)为中间体生产精细化学品的综合骨干企业。针对乙烯酮(双乙烯酮)下游产品废水特点,该厂结合企业实际,开展了产品优化,结构调整,清洁生产,资源循环利用,节水降耗等工作,从源头削减了污染物的生产。同时投资二千多万元新建预处理装置三套,6000m3/d废水生化处理装置一套,使全厂乙烯酮(双乙烯酮)下游产品的废水得到了有效的治理。 相似文献
12.
13.
D. G. Gordeev L. F. Gudarenko M. V. Zhernokletov V. G. Kudel’kin M. A. Mochalov 《Combustion, Explosion, and Shock Waves》2008,44(2):177-189
A semi-empirical equation of state for metals is described. Its capabilities are demonstrated by the example of the equation
of state for aluminum. New experimental data are presented on the location of the isentrope of aluminum for unloading from
the state at p = 229.71 GPa on the shock adiabat to an aerogel (SiO2) of density 0.08 g/cm3.
__________
Translated from Fizika Goreniya i Vzryva, Vol. 44, No. 2, pp. 61–75, March–April, 2008. 相似文献
14.
15.
The objective of the study was to explore the effect of the degree of deacetylation (DD) of the chitosan used on the degradation rate and rate constant during ultrasonic degradation. Chitin was extracted from red shrimp process waste. Four different DD chitosans were prepared from chitin by alkali deacetylation. Those chitosans were degraded by ultrasonic radiation to different molecular weights. Changes of the molecular weight were determined by light scattering, and data of molecular weight changes were used to calculate the degradation rate and rate constant. The results were as follows: The molecular weight of chitosans decreased with an increasing ultrasonication time. The curves of the molecular weight versus the ultrasonication time were broken at 1‐h treatment. The degradation rate and rate constant of sonolysis decreased with an increasing ultrasonication time. This may be because the chances of being attacked by the cavitation energy increased with an increasing molecular weight species and may be because smaller molecular weight species have shorter relaxation times and, thus, can alleviate the sonication stress easier. However, the degradation rate and rate constant of sonolysis increased with an increasing DD of the chitosan used. This may be because the flexibilitier molecules of higher DD chitosans are more susceptible to the shear force of elongation flow generated by the cavitation field or due to the bond energy difference of acetamido and β‐1,4‐glucoside linkage or hydrogen bonds. Breakage of the β‐1,4‐glucoside linkage will result in lower molecular weight and an increasing reaction rate and rate constant. © 2003 Wiley Periodicals, Inc. J Appl Polym Sci 90: 3526–3531, 2003 相似文献
16.
Jorge Marcelo Romero Soledad Bustillo Hugo Enrique Ramirez Maisuls Nelly Lidia Jorge Manuel Eduardo Gómez Vara Eduardo Alberto Castro Alicia H. Jubert 《International journal of molecular sciences》2007,8(7):688-694
A thermochemical rather simple experimental technique is applied to determine the enthalpy of formation of Diperoxide of ciclohexanone. The study is complemented with suitable theoretical calculations at the semiempirical and ab initio levels. A particular satisfactory agreement between both ways is found for the ab initio calculation at the 6–311G basis This set level. Some possible extensions of the present procedure are pointed out. 相似文献
17.
18.
19.
醋酸纤维素取代基分布与性质的关系 总被引:9,自引:0,他引:9
分析了以吡啶为溶剂的醋酸纤维素的13C-NMR核磁共振谱,得出了三种不同位置羟基的取代度。结合X—射线和DSC分析,初步说明具有相同取代度但未经水解和经过水解的醋酸纤维素(CA) 性质上的差异是由于三个羟基上的取代度分布不同及消晶程度差异所致。 相似文献
20.
1 INTRODUCTIONBecause of importance of equations of state (EOS)in science and industry,hundreds forms of EOS havebeen presented since latter 19th century.It seems impossible to develop a general equation covering vari-ous kinds of EOS.But for cubic EOS,several generalequations have been reported already. Martin presented the first general equation whichis following p=RT/V-α(T)/(υ β)(υ γ) δ(T)/υ(υ β)(υ γ) (1) Kumar et a1.presented an equation called the most general form of a density-cubic or, alterna tively,volume-cubic mathematical equation,the form of which is as follows 相似文献