Electrical Properties of Sputter-deposited ZrO2-based Pt/ZrO2/Si Capacitors

Pt/ZrO2/Si sandwich structures where ZrO2 is deposited by radio frequency （r.f.） magnetron sputtering using a Zr target in an atmosphere of O2/Ar gas mixture, were fabricated and the effects of the O2/Ar flow ratio in the reactive sputtering process, the annealing temperature, the ZrO2 film thickness on the structure, the surface roughness of ZrO2 films and the electric properties of Pt/ZrO2/Si metal-oxide-semiconductor （MOS） capacitors were investigated. The optimum process parameters of the Pt/ZrO2/Si capacitor based on reactively sputtered-ZrO2 determined in such a way as the capacitance is maximized and the leakage current, the oxide charge, and the interface trap density are minimized that is the O2/Ar flow ratio of 1.5, the annealing temperature of 800℃, and the film thickness of 10 nm. Also the conduction mechanism in the Pt/ZrO2/Si capacitor has been discussed.     

离子色谱法测定食品中的二氧化氯及其副产物

目的建立离子色谱法同步检测食品中消毒残留的二氧化氯及其副产物氯酸盐含量的分析方法。方法用超声波处理浸泡的水中的样品并振荡提取,经离心取上层液。采用离子色谱进行分析,采用AS-19色谱柱分离,20 mmol/L KOH溶液以1.0 mL/min流速等度淋洗,电导检测器检测,外标法定量。结果各化合物的质量浓度与其相应峰面积呈线性关系。检出限为0.05 mg/L。测定值的相对标准偏差为3.6%~8.9%(n=6),加标回收率在81.6%~92.5%之间(n=6)。结论利用离子色谱法检测食品中的二氧化氯及其副产物氯酸盐,方法准确、可靠、实用性强。     

Experimental investigation of friction coefficient in tube hydroforming

The friction coefficient between tube and die in guide zone of tube hydroforming was obtained. In hydroforming, the tube is expanded by an internal pressure against the tool wall. By pushing the tube through tool, a friction force at the contact surface between the tube and the tool occurs. In guiding zone, the friction coefficients between tube and die can be estimated from the measured axial feeding forces. In expansion zone, the friction coefficients between tube and die can be evaluated from the measured geometries of expanded tubes and FE analysis.     

Experimental investigation of friction coefficient in tube hydroforming

The friction coefficient between tube and die in guide zone of tube hydroforming was obtained. In hydroforming, the tube is expanded by an internal pressure against the tool wall. By pushing the tube through tool, a friction force at the contact surface between the tube and the tool occurs. In guiding zone, the friction coefficients between tube and die can be estimated from the measured axial feeding forces. In expansion zone, the friction coefficients between tube and die can be evaluated from the measured geometries of expanded tubes and FE analysis.     

A comparison of transmittance properties between ZnO∶Al films for transparent conductors for solar cells deposited by sputtering of AZO and cosputtering of AZO/ZnO

Aluminum-doped zinc oxide (AZO) thin films were deposited on sapphire (002) andglass substrates by two different sputtering techniques radio frequency magnetron cosputtering of AZO and ZnO targets and sputtering of an AZO target. The dependence of the photoluminescence (PL) and transmittance properties of the AZO films deposited by cosputtering and sputtering on the AZO/ZnO target power ratio, R and the O2/Ar flow ratio, r were investigated, respectively. Only a deep level emission peak appears in the PL spectra of cosputtered AZO films whereas both UV emission and deep level emission peaks are observed in the PL spectra of sputtered AZO films. The absorption edges in the transmittance spectra of the AZO films shift to the lower wavelength region as R and r increase. Effects ofcrystallinity, surface roughness, PL on the transmittance of the AZO films werealso explained using the X-ray diffraction (XRD), atomic force microscopy (AFM), and PL analysis results.     

Changes in fatty acid composition in plant tissues expressing a mammalian Δ9 desaturase

Plant tissues expressing a mammalian stearoyl-CoA Δ9 desaturase were reported to accumulate Δ9 hexadecenoic acid (16∶1), normally very minor in most plant tissues. The transgenic plants were thoroughly analyzed for alterations of individual lipids in different subcellular sites. Western blot analysis indicated that the animal desaturase was targeted to the microsomes. The Δ9 16∶1 was incorporated into both the sn-1 and sn-2 positions of all the major membrane lipids tested, indicating that the endoplasmic reticulum acyltransferases do not exclude unsaturated C₁₆ fatty acids from the sn-2 position. In addition to increases in monounsaturated and decreases in saturated fatty acids, accumulation of 16∶1 was accompanied by a reduction in 18∶3 in all the lipids tested except phosphatidylglycerol, and increases in 18∶2 in phospholipids. Total C₁₆ fatty acid content in the galactolipids of the transgenics was significantly higher than that in the control, but those in the phospholipids were unchanged. In transgenics, Δ11 18∶1 was detected in the sn-1 position of the lipids tested except phosphatidylinositol and phosphatidylserine. Introduction of the animal desaturase, controlled by a seed-specific phaseolin promoter, into soybean somatic embryo resulted in a significant reduction in saturated fatty acids. Such effects were greater in cotyledons than hypocotyl-radicles. This study demonstrated that the animal desaturase can be used to decrease the levels of saturated fatty acids in a crop plant.