Characteristic tryptic peptides and gelling properties of porcine skin gelatin affected by thermal action

Thermal action in extraction process had effects on characteristic tryptic peptides identification and gelling properties of porcine gelatin. SDS-PAGE, HPLC-LTQ/Orbitrap high-resolution mass spectrometry, texture analyser and rheometer were used to evaluate collagen depolymerisation degree, characteristic tryptic peptides and gelling properties of gelatins prepared in various thermal actions. Results showed that with increasing temperature and time, depolymerisation degree enlarged, while gel strength, gelling and melting temperature decreased. Mass spectra showed that 47 and 49 common characteristic tryptic peptides were identified in gelatins extracted at 50 °C and 100 °C with various times, respectively. Moreover, 34 common characteristic tryptic peptides were identified in all gelatin samples. Further comparison between this work and our previous investigations yielded 20 common characteristic tryptic peptides, which stably exist in various thermal actions. These common characteristic tryptic peptides may be very helpful for the accurate authentication of porcine gelatin.     

含煤盆地深层“超饱和”煤层气形成条件

中国深层煤层气资源丰富，但总体勘探和认识程度较低，尚未形成较为系统的深层煤层气地质理论。通过解剖分析准噶尔盆地白家海凸起和鄂尔多斯盆地临兴区块深层"超饱和"煤层气井的试气/生产动态，估算原地游离气的含气量，分析了深层"超饱和"煤层气的形成条件。研究表明：①深层"超饱和"煤层气储层中除吸附气外，还含有原地游离气，用常规试气方法可直接获得气流，煤层气的产出不明显依赖于排水降压；②埋藏超过一定深度，在煤阶和温度的综合作用下，煤的吸附能力将随埋深的继续增加而降低，煤层中吸附气的饱和度有增加的趋势，在达到吸附饱和后，出现原地游离气并形成"超饱和"煤层气，盆地深层具有"超饱和"煤层气形成的优势条件；③由于地温梯度和压力梯度的不同，不同盆地"超饱和"煤层气出现的临界深度不同，异常高压和异常高热流可以降低深层"超饱和"煤层气形成的临界深度；④深层"超饱和"煤层气开发具有大大缩短见气时间、充分利用地层能量和累积产水量低等优势，有望成为未来煤层气勘探开发的一个重要领域。     

A first-principles investigation on mechanical and metallic properties of titanium carbides under pressure

The titanium carbides are potential candidates to achieve both high hardness and refractory property. We carried out a structural search for titanium carbides at three pressures of 0 GPa, 30 GPa and 50 GPa. A phase diagram of the Ti-C system at 0 K was obtained by elucidating formation enthalpies as a function of compositions, and their mechanical and metallic properties of titanium carbides were investigated systematically. We also discussed the relation of titanium concentration to the both mechanical and metallic properties of titanium carbides. It has been found that the average valence electron density and tractility improved at higher concentrations of titanium, while the degree of covalent bonding directionality decreased. To this effect, the hardness of titanium carbide decreases as the content of titanium increases. Our results indicated that the titanium content significantly affected the metallic properties of the Ti-C system.     

Optimal Block Design for Asynchronous Wake-Up Schedules and Its Applications in Multihop Wireless Networks

In this paper, we consider the problem of designing optimal asynchronous wake-up schedules to facilitate distributed power management and neighbor discovery in multihop wireless networks. We first formulate it as a block design problem and derive the fundamental trade-offs between wake-up latency and the average duty cycle of a node. After the theoretical foundation is laid, we then devise a neighbor discovery and schedule bookkeeping protocol that can operate on the optimal wake-up schedule derived. To demonstrate the usefulness of asynchronous wake-up, we investigate the efficiency of neighbor discovery and the application of on-demand power management, which overlays a desirable communication schedule over the wake-up schedule mandated by the asynchronous wake-up mechanism. Simulation studies demonstrate that the proposed asynchronous wake-up protocol has short discovery time which scales with the density of the network; it can accommodate various traffic characteristics and loads to achieve an energy savings that can be as high as 70 percent, while the packet delivery ratio is comparable to that without power management.     

某雷达数据处理有关问题分析

对某雷达数据处理应用中存在的一些特殊问题进行讨论分析,并就具体问题提出了解决的方法.     

Fastmet工艺评述

介绍了Ｆａｓｔｍｅｔ工艺及发展状况，并对工艺特点和指标进行了分析。使用冷固结含碳球团和转底炉使该工艺可直接采用粉矿和提高生产效率，但因硫含量高、铁品位低而产品质量较差。不过投资和生产成本与传统工艺比较却占有较大优势。     

Crystal growth of selected II–VI semiconducting alloys by directional solidification: Part I Ground-based experiments

A series of Hg_0.84Zn_0.16 Te crystal ingots have been grown from pseudobinary melts by the Bridgmam–Stockbarger type directional solidification using a Marshall Space Flight Center/Space Science Laboratory heat-pipe furnace and the ground control experiment laboratory furnace of the crystal growth furnace which was flown on the first United States Microgravity Mission. A number of translation rates and a series of hot- and cold-zone temperatures were employed to assess the influence of growth parameters on the crystal properties for the purpose of optimizing the in-flight growth conditions. This revised version was published online in November 2006 with corrections to the Cover Date.     

Ion irradiation—induced structure damage to botanic samples using the ion transmission energy spectrum

1 INTRODUCTIONThe new aPplications of low energy heavy ion beam in irradi4ted botanical materialswere studied in recellt yeaxs. The beaminduced mutation effect on crop seeds has causedthe attention of physicist and biologists.[1l:] FOr examPle, 1ow energy ions can induceremarkable mutation to rice seeds.[3] There are many special phenomena when heavyions bombard botanic sW1e due to its special structure. Some studies showed that tllepenetration depths of some ions were far larger than t…     

Air bearing design, optimization, stability analysis andverification for sub-25 nm flying

Three sub-25 nm fly height sliders are presented for near contact recording. The designs are geared towards the goal of achieving 10 Gb/in ² areal density. The optimization procedure presented shows promise for facilitating achievement of this goal. The dynamic simulations show the stability of these designs when disturbed from their steady state conditions     

阴极爆炸发射电子电离气体原初过程的动力学模拟

基于阴极爆炸发射电子和电子对气体的碰撞电离模型 ,用胞中粒子 (PIC)模拟方法对单间隙冷阴极气体放电过程中阴极爆炸发射产生的电子和电子碰撞电离产生质子的动力学特性进行了研究。分别给出了在 1.33× 10 - 2 Pa氢气压和 10kV间隙电压下 ,气体放电过程中电子和质子的空间和相空间分布、速度统计分布以及轴线上电荷密度分布 ,分析了阴极爆炸发射电子电离过程。模拟结果表明 ,间隙中电子的最大速度达 5 .8× 10 7m/s ,而只有少数的气体电离产生的质子最大速度达到 1.3× 10 6 m/s。