Isolation of the effect of the hairy layer length on the mechanical properties of waterborne coatings

The effect of the acidic hairy layer length on the interdiffusion of polymer between particles and as a consequence on the mechanical properties of the films produced from waterborne coatings has been studied. In order to isolate this effect, latexes with the same particle diameter and molecular weight but stabilized with poly(acrylic acid)-block-poly(butyl acrylate) (PAA-b-PBA) block copolymers of controlled and different lengths were prepared. Tensile strength measurements showed at the macroscopic level that the presence of AA chains in the particle surface reduced the mechanical properties of the films dried at room temperature, being its effect worse the longer the AA chain length. Higher annealing temperatures erased the negative effect of the acidic hairy layer on mechanical properties. The neutralization with NaOH instead of with NH₄OH also led to worse mechanical properties. These macroscopic results were supported by Fluorescence Resonance Energy Transfer (FRET) experiments that showed that at the microscopic level, the extent of interdiffusion occurred slower when the AA chains in the particles surface increased, the annealing temperature was lower and when NaOH was used as neutralizing agent instead of NH₄OH.     

水力旋流器用于酸性油分离的研究

采用自行研制的水力旋流器进行了降低酸性油酸值的工业实验。实验表明,水力旋流器可将酸值为13．3 mgKOH/g的酸性油酸值降至12 mgKOH/g左右,从而能满足工业生产要求,沉降时间大为缩短。     

80kt/a硫磺回收装置国产化设计

介绍了无在线炉硫回收工艺的基本原理、技术特点和催化剂使用情况。已投用的工业装置运行结果证明 ,用该工艺设计的硫磺回收装置 ,硫回收率和尾气净化度高 ,投资少 ,能耗低 ,流程简单 ,操作控制方便 ,社会效益和经济效益显著 ,适用于同类装置的新建和改扩建项目 ,市场前景广阔。     

某炼油厂一级浮床除盐系统阳床工艺特性及调整试验

论述了某厂一级除盐系统阳床工艺特性及调整试验过程，对存在问题进行分析并改进，得到了实际运行最佳方式和参数，取得良好效果。     

高含酸性气碳酸盐岩气藏流体敏感性实验研究

对川东北雷口坡组、嘉陵江组、飞仙关组、长兴组高含H，S及032的碳酸盐岩储层流体敏感性进行了实验研究，结果表明岩样速敏损害弱～强，水敏和盐敏损害中偏弱～极强，碱敏损害严重。岩石学分析揭示，川东北高含酸性气碳酸盐岩储层发育伊利石、微晶石英、白云石、方解石、硫化钙等潜在损害物质。钻井完井液侵入会破坏储层各物质间的原始动态平衡，诱发储层损害。主要损害机理为：①储层流体pH增加引起黏土矿物以及微晶石英失稳；②碱液与微晶石英、长石、白云石反应生成硅酸盐、高岭石、水镁石等新矿相；③流体矿化度改变可降低伊利石微粒间的连接力；④硫化钙水解产生OH^-，过量的OH-与Ca^2＋结合形成氢氧化钙沉淀；⑤储层含水饱和度和流体离子浓度改变，致使焦沥青脱附并在储层深部沉积；⑥硬石膏水化膨胀、分散运移。针对该气藏损害机理，可采用屏蔽暂堵技术以形成优质滤饼，有效降低储层流体敏感性损害。图5表2参10。     

醋酸甲酯在Cs_(1.5)PW/SiO_2催化剂上的水解反应

通过改变阳离子的种类与配比,制备了一系列SiO2负载的磷钨酸盐催化剂,考察了制备方法对催化剂性能的影响,采用傅里叶变换红外光谱、X射线衍射、X射线荧光光谱、环境扫描电子显微镜等方法对催化剂进行了表征,并考察了该系列催化剂对醋酸甲酯水解反应的活性。实验结果表明,Cs1.5PW/SiO2催化剂的活性最好,当Cs1.5PW负载量(质量分数)为30%时,Cs1.5PW的Keggin结构保持完好,没有硅钨酸阴离子形成,Cs1.5PW在SiO2载体上高度分散;在反应温度55℃、反应时间2h的条件下,醋酸甲酯的转化率为35.79%,约为均相磷钨酸催化剂的1.3倍。该催化剂重复使用4次后,醋酸甲酯的转化率稳定在25%;80℃下反应2h,与NKC-9磺酸树脂催化剂相比,醋酸甲酯的转化率提高了5.17%。     

静态水热脱铝处理对HZSM-5分子筛的结构、酸性和催化性能的影响

开发了一种静态水热脱铝的方法。HZSM-5经此法处理后,正戊烷的裂解活性增加,脱氢和芳构化性能加强。可用改变处理温度的方法来控制脱铝的程度。用XRD和吡啶吸附红外技术进行了研究。HZSM-5分子筛催化剂性能的变化用非骨架铝产生的强L酸中心来解释。     

Fabrication of damascene Cu wirings using solid acidic catalyst

The copper damascene process is one of the most promising technologies for fabricating Cu wirings for electronic devices such as LSIs. In this research, the fabrication of damascene Cu wirings was conducted using solid acidic catalyst. When a Cu-plated wafer, whose oxide is a basic oxide is dipped into a mixture of oxidizing solution and acidic solution, surface atoms are ionized and etched off into the solution. However, because conventional nonelectrolytic etching does not have a reference surface, it is difficult to utilize for planarization. Therefore, a new nonelectrolytic machining method using a cation-exchange fabric instead of an acidic solution was developed. To be more precise, the planarization of a Cu-plated wafer was carried out by rubbing with the cation-exchange fabric in ozone water. Basically, this method exploits chemical reactions so that the physical properties of the workpiece surface are not deteriorated. Furthermore, this method uses no chemicals except for ozone water, which easily dissociates into water and oxygen molecules; thus, this method is a low-cost, environmentally friendly process. In this paper, as a preliminary experiment, the nonelectrolytic etching of a Cu sample using solutions of O₃ and CO₂ was carried out to inspect the dependence of the etching rate on [O₃] and [H⁺]. The results indicate that the etching rate increased as [O₃] and [H⁺] increased. When [H⁺] was high relative to [O₃], a smooth etch-pit-free surface was achieved. Next, nonelectrolytic etching using a cation-exchange fabric was carried out, and properties similar to those in the case of etching using solutions were obtained. Finally, damascene Cu wirings were fabricated using ozone water and a cation-exchange catalyst.     

Acidic and basic hydrolysis of poly(N‐vinylformamide)

Poly(N‐vinylformamide) (PNVF) was synthesized and hydrolyzed to poly(vinylamine) (PVAm) in both HCl and NaOH solutions. The hydrolysis kinetics and the equilibrium hydrolysis were examined experimentally at different temperatures, polymer concentrations, and acid‐ or base‐to‐amide molar ratios. The hydrolysis kinetics strongly depended on temperature, polymer, and HCl or NaOH concentrations, but showed little dependence on PNVF molecular weight. The acid hydrolysis of PNVF exhibited limited conversions because of the electrostatic repulsion among the cationic amine groups generated during hydrolysis and proton hydrates. In the basic hydrolysis, complete amide conversions were observed when the NaOH/amide molar ratios were greater than unity. The effects of temperature and PNVF concentration on the equilibrium amide conversion appeared to be negligible in both acidic and basic hydrolysis. The equilibrium conversions of base hydrolysis were higher than those of acidic hydrolysis under the same reaction conditions. At NaOH/amide ratios of less than unity, the equilibrium hydrolysis experiments revealed that one base molecule could induce the hydrolysis of more than one amide group. © 2002 Wiley Periodicals, Inc. J Appl Polym Sci 86: 3412–3419, 2002     

酸性Ni-Mo-P/Ni-P双层化学镀工艺研究

对酸性Ni-Mo-P／Ni—P双层直接连续化学镀的工艺进行了试验研究。通过对钼酸根与次磷酸根加量比对镀速的影响，络合剂与pH对镀速及成分影响的研究，优化得到一种双层化学镀的酸性镀液的组成。试验研究了钼含量对镀层结构的影响，进而确定了具有非晶结构的双层镀的最佳工艺并对其性能进行了研究。