Diluted chemical bath deposition of CdZnS as prospective buffer layer in CIGS solar cell

In this study, dilute chemical bath deposition technique has been used to deposit CdZnS thin films on soda-lime glass substrates. The structural, morphological, optoelectronic properties of as-grown films have been investigated as a function of different Zn²⁺ precursor concentrations. The X-ray diffractogram of CdS thin-film reveals a peak corresponding to (002) plane with wurtzite structure, and the peak shift has been observed with the increase of the Zn²⁺ concentration upon formation of CdZnS thin film. From morphological studies, it has been revealed that the diluted chemical bath deposition technique provides homogeneous distribution of film on the substrate even at a lower concentration of Zn²⁺. Optical characterization has shown that the transparency of the film is influenced by Zn²⁺ concentration and when the Zn²⁺ concentration is varied from 0 M to 0.0256 M, bandgap values of resulting films range from 2.42 eV to 3.90 eV while. Furthermore, electrical properties have shown that with increasing zinc concentration the resistivity of the film increases. Finally, numerical simulation validates and suggests that CdZnS buffer layer with composition of 0.0032 M Zn²⁺ concentration would be a promising candidate in CIGS solar cell.     

基于状态观测器的电镀液温度状态反馈控制系统

针对电镀液温度控制系统,引入状态反馈控制。相对于传统的反馈控制,本方法可以获得更优异的性能。另外,考虑到镀液温度控制具有纯迟延的特点,提出了一种消去纯迟延的方法。仿真验证结果显示,控制效果良好。     

酸性废水中As(Ⅲ)、Cu(Ⅱ)与铁粉的反应行为

在Fe-As(Ⅲ)-Cu(Ⅱ)-H₂O体系中, 研究了酸性废水中As(Ⅲ)、Cu(Ⅱ)与金属铁粉的反应行为, 考察了反应过程中As在气、液、固三相中的分配比。结果表明, As(Ⅲ)和Cu(Ⅱ)离子被Fe还原为单质As和Cu后, As、Cu进一步结合成Cu₅As₂等金属间化合物, 从而促进As(Ⅲ)沉淀反应的发生, 且无AsH3生成。在反应时间40min、铁粉过量系数1.2、溶液初始pH=0.0、温度40 ℃、Cu/As摩尔比1.0条件下, As在气、液、固三相中的分配比分别为0、20.7%和79.3%, 沉砷率为79.3%。     

Isolation of the effect of the hairy layer length on the mechanical properties of waterborne coatings

The effect of the acidic hairy layer length on the interdiffusion of polymer between particles and as a consequence on the mechanical properties of the films produced from waterborne coatings has been studied. In order to isolate this effect, latexes with the same particle diameter and molecular weight but stabilized with poly(acrylic acid)-block-poly(butyl acrylate) (PAA-b-PBA) block copolymers of controlled and different lengths were prepared. Tensile strength measurements showed at the macroscopic level that the presence of AA chains in the particle surface reduced the mechanical properties of the films dried at room temperature, being its effect worse the longer the AA chain length. Higher annealing temperatures erased the negative effect of the acidic hairy layer on mechanical properties. The neutralization with NaOH instead of with NH₄OH also led to worse mechanical properties. These macroscopic results were supported by Fluorescence Resonance Energy Transfer (FRET) experiments that showed that at the microscopic level, the extent of interdiffusion occurred slower when the AA chains in the particles surface increased, the annealing temperature was lower and when NaOH was used as neutralizing agent instead of NH₄OH.     

水力旋流器用于酸性油分离的研究

采用自行研制的水力旋流器进行了降低酸性油酸值的工业实验。实验表明,水力旋流器可将酸值为13．3 mgKOH/g的酸性油酸值降至12 mgKOH/g左右,从而能满足工业生产要求,沉降时间大为缩短。     

80kt/a硫磺回收装置国产化设计

介绍了无在线炉硫回收工艺的基本原理、技术特点和催化剂使用情况。已投用的工业装置运行结果证明 ,用该工艺设计的硫磺回收装置 ,硫回收率和尾气净化度高 ,投资少 ,能耗低 ,流程简单 ,操作控制方便 ,社会效益和经济效益显著 ,适用于同类装置的新建和改扩建项目 ,市场前景广阔。     

CO2泡沫压裂优化设计技术及应用

针对苏里格低压、低渗透气藏常规水基压裂液压后返排困难,导致储层水锁伤害的问题,研究利用CO2泡沫压裂来降低压裂液滤失,提高压裂液返排率,降低对储层的伤害。有针对性地研究了CO2泡沫压裂优化设计技术,包括:CO2泡沫压裂起泡技术、酸性交联技术、变泡沫质量和恒定内相设计技术等。现场应用表明,长庆苏里格气田气藏应用CO2泡沫压裂技术,可大大提高返排率,缩短压裂液返排时间,降低压裂液对气层的伤害,提高压裂效果。     

某炼油厂一级浮床除盐系统阳床工艺特性及调整试验

论述了某厂一级除盐系统阳床工艺特性及调整试验过程，对存在问题进行分析并改进，得到了实际运行最佳方式和参数，取得良好效果。     

高含酸性气碳酸盐岩气藏流体敏感性实验研究

对川东北雷口坡组、嘉陵江组、飞仙关组、长兴组高含H，S及032的碳酸盐岩储层流体敏感性进行了实验研究，结果表明岩样速敏损害弱～强，水敏和盐敏损害中偏弱～极强，碱敏损害严重。岩石学分析揭示，川东北高含酸性气碳酸盐岩储层发育伊利石、微晶石英、白云石、方解石、硫化钙等潜在损害物质。钻井完井液侵入会破坏储层各物质间的原始动态平衡，诱发储层损害。主要损害机理为：①储层流体pH增加引起黏土矿物以及微晶石英失稳；②碱液与微晶石英、长石、白云石反应生成硅酸盐、高岭石、水镁石等新矿相；③流体矿化度改变可降低伊利石微粒间的连接力；④硫化钙水解产生OH^-，过量的OH-与Ca^2＋结合形成氢氧化钙沉淀；⑤储层含水饱和度和流体离子浓度改变，致使焦沥青脱附并在储层深部沉积；⑥硬石膏水化膨胀、分散运移。针对该气藏损害机理，可采用屏蔽暂堵技术以形成优质滤饼，有效降低储层流体敏感性损害。图5表2参10。     

醋酸甲酯在Cs_(1.5)PW/SiO_2催化剂上的水解反应

通过改变阳离子的种类与配比,制备了一系列SiO2负载的磷钨酸盐催化剂,考察了制备方法对催化剂性能的影响,采用傅里叶变换红外光谱、X射线衍射、X射线荧光光谱、环境扫描电子显微镜等方法对催化剂进行了表征,并考察了该系列催化剂对醋酸甲酯水解反应的活性。实验结果表明,Cs1.5PW/SiO2催化剂的活性最好,当Cs1.5PW负载量(质量分数)为30%时,Cs1.5PW的Keggin结构保持完好,没有硅钨酸阴离子形成,Cs1.5PW在SiO2载体上高度分散;在反应温度55℃、反应时间2h的条件下,醋酸甲酯的转化率为35.79%,约为均相磷钨酸催化剂的1.3倍。该催化剂重复使用4次后,醋酸甲酯的转化率稳定在25%;80℃下反应2h,与NKC-9磺酸树脂催化剂相比,醋酸甲酯的转化率提高了5.17%。