Optical and electrical properties of ITO film on flexible fluorphlogopite substrate

Indium Tin Oxide (ITO) films were prepared, at room temperature, on a fluorphlogopite substrate using magnetron sputtering technology. At various temperatures of 500 °C, 600 °C, 700 °C, 800 °C, and 900 °C, the samples were (had) annealed for 2 h (a 2-h duration). The results showed improvement in the crystalline performance of ITO film at selected annealing temperatures, with a significant reduction in resistivity at 800 °C. The lowest resistivity is 4.08 × 10^?4 Ω-cm, which is nearly an order of magnitude lower than the unannealed sample. All samples have an average light transmittance above 85% in the visible light range (400–800 nm), and with increasing annealing temperature, the average light transmittance tends to decrease. Besides, at the sensitive wavelength of 550 nm, the light transmittance is as high as 93.74%. The sheet resistance testing of the sample was through the number of bending times, which revealed that with the increase of the number of bending, the sheet resistance increases. However, after 1200 bending times, the change rate of the sheet resistance remains below 5%. Thus, the ITO film prepared on the flexible fluorphlogopite substrate revealed excellent optical and electrical properties, good flexibility, and improved stability after high-temperature annealing, which guarantees successful application in flexible electronic devices.     

Corrosion behavior of under‐, peak‐, and over‐aged 6063 alloy: A comparative study

The mechanical property of age‐hardenable Al‐alloys is governed by the state of ageing, which determines the microstructure and consequently, their corrosion behavior which is a vital aspect for a number of applications. This article presents a comparative assessment of corrosion behavior of under‐, peak‐ and over‐aged Al‐Mg‐Si alloy. Corrosion characteristics have been determined via immersion tests in 0.1 M ortho‐phosphoric acid solution and intergranular corrosion (IGC) tests. Corroded surfaces are examined by field emission scanning electron micrographs‐energy dispersive spectroscopy and 3D optical profilometer. The obtained results reveal that the corrosion rate at a specific immersion time as well as the depth of IGC increases in the order for under‐, peak‐, and over‐aged states. Irrespective of the state of ageing, corrosion loss increases linearly but the rate of corrosion decreases rapidly with increasing immersion time. The dominant mode of corrosion in under‐aged alloy is identified as localized pitting, while peak‐aged is highly susceptible to IGC in contrast extensive pitting corrosion is observed for over‐aged alloy. The observed differences in corrosion behavior are explained considering characteristics of precipitates. Formation of β (Mg₂Si) in case of over‐aged alloy and presence of inclusions like AlFeMnSi particles are found to accelerate pitting corrosion.     

高效液相色谱法测定多环芳烃的出峰顺序探讨

目的探讨水﹑气﹑土壤中多环芳烃检测标准(HJ 478-2009﹑HJ 647-2013、HJ 784-2016)的正确出峰时间和顺序。方法用高效液相色谱来对苊烯、芴、苊、?、苯并(a)蒽进行定性分析,并与3个标准中的出峰顺序进行比较。结果苊烯、苊、芴、苯并(a)蒽、?的出峰时间分别为6.450、7.923、8.233、17.760、18.740min,与标准HJ478-2009﹑HJ647-2013的出峰顺序存在差异。结论在使用标准HJ478-2009﹑HJ647-2013、HJ 784-2016同时测定16种多环芳烃时,多环芳烃的出峰顺序及时间应以HJ 784-2016为准。     

固相缩聚共聚酯的熔融行为和结晶速率研究

通过固相缩聚合成了两种不同结构的高分子量共聚酯，研究了样品的熔融行为和结晶速率。研究发现，共聚酯的熔融峰随着固相聚合温度和时间的变化而与纯ＰＥＴ有明显的差别，共聚酯泊结晶速率与慢于纯ＰＥＴ的结晶速率。     

油田污水中咪唑啉缓蚀剂浓度检测技术研究

研究评价了油田污水中咪唑啉缓蚀剂浓度检测的七种方法 ,其中紫外光分析法和显色反应法适合于低浓度咪唑啉缓蚀剂检测 ,且方法简便、速度快、成本低 ,检测浓度范围 2～ 5 0mg/L。     

The Minimum PAPR Code for OFDM Systems

In this letter, a block code that minimizes the peak‐to‐average power ratio (PAPR) of orthogonal frequency division multiplexing (OFDM) signals is proposed. It is shown that peak envelope power is invariant to cyclic shift and codeword inversion. The systematic encoding rule for the proposed code is composed of searching for a seed codeword, shifting the register elements, and determining codeword inversion. This eliminates the look‐up table for one‐to‐one correspondence between the source and the coded data. Computer simulation confirms that OFDM systems with the proposed code always have the minimum PAPR.     

实行全面质量管理 做好江口水电站工程设计

江口水电站是芙蓉江干流开发中的骨干工程。为认真履行江口工程的设计合同，确保优质、高效地完成江口工程的各项设计工作，长江委设计院实行全面质量管理，建立了一套规范化的统计管理程序，制订详细的设计计划，落实江口工程项目各级责任人的质量责任制，采取特殊技术措施，对工程设计过程中的各项质量活动进行全过程的管理，使江口工程在满足质量标准、合同进度的情况下，工程投资最省。     

Approximate channel identification via δ‐signed correlation

A method of approximate channel identification is proposed that is based on a simplification of the correlation estimator. Despite the numerical simplification (no multiplications or additions are required, only comparisons and an accumulator), the performance of the proposed estimator is not significantly worse than that of the standard correlation estimator. A free (user selectable) parameter moves ‘smoothly’ from a situation with small sum‐squared channel estimation error but hard‐to‐identify channel peaks, to one with a larger sum‐squared estimation error but easy‐to‐identify channel peaks. The proposed estimator is shown to be biased and its behaviour is analysed in a number of situations. Applications of the proposed estimator to sparsity detection, symbol timing recovery and to the initialization of blind equalizers are suggested. Copyright © 2002 John Wiley & Sons, Ltd.     

高阻值Cd1-xZnxTe晶体的生长及其性能测试

通过适当的工艺措施，采用Bridgman法生长了直径为30mm的X射线及γ射线探测器级的Cd.9Zn0．1Te晶锭．测试结果表明：该晶锭结晶质量良好，位错密度低，成分均匀，杂质含量低，红外透过率和电阻率都十分接近本征Cd.9Zn0．1Te的值．并从晶体的生长特性、缺陷和杂质的角度，分析了生长高性能晶体的条件，研究了生长Cdl-xZnxTe晶体的x值与缺陷和杂质浓度之间的关系．