Electrical Breakdown Properties and Space Charge Formation in High Temperature Region in Ultraviolet Ray Irradiated PVC

Polyvinyl chloride (PVC) is the most popular insulating material for electric wiring instruments. However, an exothermic reaction above 150 °C may cause deterioration of the insulating properties of PVC. Therefore, it is important to clarify the heat degradation in PVC, not only to investigate the ignition of electrical wiring products but also to use electrical products safely. It is known that ultraviolet (UV) irradiation causes chemical deterioration of PVC and an increase in its conductivity. Generally, it has been thought that the electrical breakdown properties, electrical conduction, and insulating performance are affected by space charge accumulation in an insulating material. A high temperature pulsed electroacoustic (PEA) system usable up to 250 °C has been developed, and the PEA system can measure the space charge distribution and conduction current in the high temperature range simultaneously. In this investigation, the space charge distribution and conduction current were measured up to electrical breakdown in a non‐UV irradiated sample (normal PVC) and in 353 nm and 253 nm UV‐irradiated PVC samples in the range from room temperature to 200 °C in a DC electric field. In the short wavelength UV irradiated PVC sample (253 nm, 300 h), a deterioration of breakdown strength at 90 °C to 150 °C and negative packet‐like charges were observed at 60 °C and 100 °C, a positive charge accumulated in front of both the anode and cathode above 90 °C, and a higher electric field near the cathode side because the positive charge of the cathode side was greater.     

Studies on high density polyethylene (HDPE) functionalized by ultraviolet irradiation and its application

The structure and properties of high density polyethylene (HDPE) functionalized by ultraviolet irradiation at different light intensities in air were studied by electron analysis, FTIR spectroscopy, contact angle with water, differential scanning calorimetry and mechanical properties measurement. The results show that oxygen‐containing groups such as C?O, C—O and C(?O)O were introduced onto the molecular chain of HDPE following irradiation, and the rate and efficiency of HDPE functionalization increased with enhancement of irradiation intensity. After irradiation, the melting temperature, contact angle with water and notched impact strength of HDPE decreased, the degree of crystallinity increased, and their variation amplitude increased with irradiation intensity. Compared with HDPE, the yield strength of HDPE irradiated at lower light intensity (32 W m^?2 and 45 W m^?2) increases monotonically with irradiation time, and the yield strength of HDPE irradiated at higher light intensity (78 W m^?2) increases up to 48 h and then decreased with further increase in irradiation time. The irradiated HDPE behaved as a compatibilizer in HDPE/polycarbonate (PC) blends, and the interface bonding between HDPE and PC was ameliorated. After adding 20 wt% HDPE irradiated at 78 W m^?2 irradiation intensity for 24 h to HDPE/PC blends, the tensile yield strength and notched Izod impact strength of the blend were increased from 26.3 MPa and 51 J m^?1 to 30.2 MPa and 158 J m^?1, respectively. Copyright © 2003 Society of Chemical Industry     

30.4 nm光电成像系统分辨率的初步实验研究

本文基于微通道板MCP(Microchannel Plate)探测器件设计一套成像系统，用于对波长为30．4nm的极紫外EUV(Extreme Ultraviolet)光进行成像．结果获得了一宽度为3mm的狭缝的像，实验测得490μm的成像系统的空间分辨率，并分析了影响系统分辨率的各种因素及为提高系统分辨率所应采取的措施．     

Pool boiling on a superhydrophilic surface

Titanium Dioxide, TiO₂, is a photocatalyst with a unique characteristic. A surface coated with TiO₂ exhibits an extremely high affinity for water when exposed to UV light and the contact angle decreases nearly to zero. Inversely, the contact angle increases when the surface is shielded from UV. This superhydrophilic nature gives a self-cleaning effect to the coated surface and has already been applied to some construction materials, car coatings and so on. We applied this property to the enhancement of boiling heat transfer. An experiment involving the pool boiling of pure water has been performed to make clear the effect of high wettability on heat transfer characteristics. The heat transfer surface is a vertical copper cylinder of 17 mm in diameter and the measurement has been done at saturated temperature and in a steady state. Both TiO₂-coated and non-coated surfaces were used for comparison. In the case of the TiO₂-coated surface, it is exposed to UV light for a few hours before experiment and it is found that the maximum heat flux (CHF) is about two times larger than that of the uncoated surface. The temperature at minimum heat flux (MHF) for the superhydrophilic surface is higher by 100 K than that for the normal one. The superhydrophilic surface can be an ideal heat transfer surface. Copyright © 2002 John Wiley & Sons, Ltd.     

天然彩色棉产品抗紫外线处理的探讨

介绍了天然彩色棉的应用现状以及对其进行抗紫外线处理的现实意义，探讨了抗紫外线处理的方法和检测手段，并结合初步的实验提出在天然彩色棉产品上进行抗紫外线处理的可行性。     

New developments in speciality polymers: polymeric stabilizers

Many new speciality polymers have been developed in the last few years. In this paper polymeric stabilizers (antioxidants, flame retardants and ultraviolet stabilizers) will be discussed. Polymeric antioxidants of the hindered-phenol type, copolymers of 2,6-ditertiarybutyl-4-vinyl(or isopropenyl)phenol with styrene, methyl methacrylate, or more importantly butadiene or isoprene have been prepared; hydrogenation of the latter copolymers gave copolymers of the two polymerizable phenolic antioxidants with ethylene or ethylene/propylene. The polymeric antioxidants have been blended with diene polymers and selected polyolefins and have improved the long-term oxidative stability of these polymers. Polymeric flame retardants have been prepared by copolymerizing styrene and/or acrylonitrile with acrylates and methacrylates of aliphatic bromine-containing alcohols or bromine-containing phenols. Polymers with polymer-bound flame retardants have a higher limiting oxygen index compared with the original polymer. A new class of polymerizable ultraviolet stabilizers has also been developed; these stabilizers are styryl, α-methylstyryl, acryloyl and methacryloyl derivatives of 2(2-hydroxyphenyl)2H-benzotriazoles. These monomers have been copolymerized with styrene, acrylates and methacrylates. 2(2-Hydroxyphenyl)2H-benzotriazoles substituted in the 4 position of the benzotriazole ring with hydroxyl, acetoxy or carboxyl groups suitable for incorporation into polyesters, polycarbonates, polyamides and epoxy resins have also been synthesized. All 2(2-hydroxyphenyl)2H-benzotriazole ultraviolet absorbers and the polymers into which they are incorporated have high light absorbency with γ_max between 330 and 350 nm and extinction coefficients in some cases as high as 4.5 × 10⁴ 1 mol^?1 cm^?1.     

用于ABS粘接的UV固化胶粘剂

研究了用于低表面能材料ABS的UV固化胶粘剂的组成,及各组分对胶粘剂性能的影响。结果表明,配比为:双酚A环氧丙烯酸酯、脂肪族聚氨酯丙烯酸酯的混合物为预聚物(占50%~55%),混合单体40%~45%,光引发剂3%~7%,流平剂BYK 307占0.1%~0.2%的胶粘剂,对ABS的湿润性及粘接强度最好。     

Simultaneous HPLC quantification of total cholesterol,tocopherols and β-carotene in Barrosã-PDO veal

A simple, rapid and sensitive procedure for the simultaneous determination of total cholesterol, tocopherols and β-carotene in meat is described. The method involves a direct saponification of the meat, a single n-hexane extraction and the analysis of the extracted compounds by normal-phase HPLC, using fluorescence (tocopherols) and UV–Vis photodiode array (cholesterol and β-carotene) detections in tandem. Rates of recovery of spiked meat samples were 93% for cholesterol, 83–86% for (α-, β- and -γ) tocopherols and 89% for β-carotene. Repeatabilities were high (CV < 6%) for all determined compounds, except for δ-tocopherol. This tocopherol, which is not usually present in meat, showed a much lower recovery percentage (73%) and repeatability (12.8%). This methodology was applied for the quantification of total cholesterol, tocopherols and β-carotene in three muscles (longissimus thoracis, longissimus lumborum and semitendinosus) of the Portuguese traditional Barrosã-PDO veal, obtained from autochthonous calves fed extensively during summer (with the least abundant green pastures) and slaughtered in early autumn (October). Barrosã-PDO veal showed median contents of total cholesterol (0.50–0.56 mg/g) and, depending on the analysed muscle, moderate to high contents of α-tocopherol (3.3–3.9 μg/g) and β-carotene (0.07–0.09 μg/g), suggesting an high sensorial and hygienic quality.     

紫外法测菜籽饼粕中硫代葡萄糖甙操作探讨

对用紫外法测菜籽饼粕中硫代葡萄糖甙过程中测试条件、操作质量等操作问题予以分析和探讨，以求提高测试结果的准确率。