碳铵法制备纳米氧化锌的研究

一种纳米氧化锌的制备方法，其过程包括：以硫酸锌和碳酸铵(或碳酸氢铵和氨水)为原料中和制备碱式碳酸锌，碱式碳酸锌经水洗除掉硫酸根后，再醇洗、干燥、煅烧，制备了纳米氧化锌。经表观密度、比表面积、孔容积和透射电镜(TEM)的测定，确定了研制的物料为纳米氧化锌，粒子峰值为10～20nm。     

从废旧聚苯乙烯泡沫塑料中回收苯乙烯

本文采用有机溶剂甲苯作为消泡剂，用热裂解法从废旧聚苯乙烯泡沫塑料中回收苯乙烯，苯乙烯收率可达８０％以上。     

Zeolite‐catalyzed isomerization of oleic acid to branched‐chain isomers

Branched‐chain (bc) saturated fatty acids (SFA) have potential as oleochemical intermediates since they have better oxidative stability than linear unsaturated fatty acids (UFA) and have better low‐temperature properties than linear SFA. Previous studies in converting UFA to bc‐FA using clay catalysts have resulted in only modest yields and conversions. Recent reports, however, have suggested that certain zeolites can be effective catalysts for converting UFA to bc‐FA in higher yields and conversions. In this work, we examined the scope and potential of the zeolite‐catalyzed synthesis of bc‐FA starting from readily available monounsaturated linear FA. Our results show that common UFA such as oleic acid can be converted to bc‐isomers using modified Ferrierite zeolite catalysts with high conversions (98%) and high selectivity (85%) and that the zeolite catalysts are reusable for at least three cycles. The positions of branching (methyl) on the FA chain were determined from the GC‐MS spectra of the picolinyl esters of the bc‐FA.     

基于遗传算法优化的OCSVM双轮廓模型异常检测算法

针对Modbus工业总线协议的特殊性及工控数据样本的不均衡性,利用单类支持向量机（OCSVM）分别构建正常OCSVM模型和异常OCSVM模型,即双轮廓模态来模拟系统通信的正常模式和异常模式,从而实现工控系统异常检测。同时将遗传算法优化自变量降维应用于工控网络入侵检测场景,实现对输入自变量的降维压缩处理,防止OCSVM模型出现过拟合现象及分类准确率低的问题,提高异常检测的精度,缩减建模时间。通过仿真验证了该算法对工控网络异常检测的有效性。     

Graft copolymerization of styrene and acrylonitrile onto EPDM

Acrylonitrile–EPDM–styrene (AES) graft copolymers were synthesized by solution graft polymerization of styrene (St) and acrylonitrile (AN) onto EPDM in an n‐hexane/benzene solvent with benzoyl peroxide (BPO) as an initiator. The structure changes were studied by an FTIR spectrophotometer. The grafting parameters were calculated gravimetrically. The influence of the polymerization conditions, such as the reaction time, concentration of the initiator, EPDM content, and weight ratio of St/AN, on the structure of the products was investigated. It was found that a proper initiator concentration and EPDM content will give a high grafting ratio of the AES resin. The thermal property of the copolymer was studied using programmed thermogravimetric analysis (TGA). The results showed that the copolymer has a better heat‐resistant property than that of ABS, especially for the initial decomposition temperature (T_in) and the maximum weight loss rate temperature (T_max). Also, the mechanism of the graft reaction was discussed. © 2002 Wiley Periodicals, Inc. J Appl Polym Sci 86: 428–432, 2002     

Effects of the electrospray ionization parameters on the formation and morphology of colloidal microspheres of polyacrylonitrile

Polyacrylonitrile colloidal microspheres have been successfully prepared with different concentrations of electrospraying polyacrylonitrile solutions. The morphology of the colloidal spheres has two kinds of structures and is strongly affected by electrospray‐ionization parameters, such as the polymer concentration, applied voltage, and distance between the electrodes. The solvent can also affect the morphology of polyacrylonitrile. The optimum conditions for preparing colloidal spheres have been found, and differential scanning calorimetry results indicate that polyacrylonitrile colloid spheres are amorphous. © 2006 Wiley Periodicals, Inc. J Appl Polym Sci 102: 2889–2893, 2006     

高温煤气铁系脱硫剂的研究

高温煤气脱硫净化是目前先进洁净煤利用技术之一 ,但是以前高温煤气脱硫剂在多次硫化再生循环过程中出现粉化 ,妨碍脱硫剂进一步使用 .本研究选择钢厂赤泥作为脱硫剂原料 ,添加不同活性组分和防粉化结构助剂 ,制备了氧化铁基高温煤气脱硫剂 .经过 1 0次硫化 /再生循环实验 .结果表明 :1 0次循环累计 1 96.98% ,再生后脱硫活性不发生变化 ,具有较高和较稳定的脱硫活性 .再生后脱硫剂的机械强度高于新鲜样品 ,在使用过程中没有出现粉化现象 ,这为氧化铁基高温煤气脱硫剂的工业化研究提供了可靠的依据 .     

渭河中下游水文变异点识别及生态保障流量计算

针对水文变异引发的基于水文统计学的生态保障流量分析方法在实践应用上存在的问题,提出通过水文变异点分析找出受环境变化影响的转折年,以该年份之前的水文序列计算生态系统需要的保障流量的思路,可有效避免因水文变异而导致的水文统计学方法失效问题。以渭河中下游为例,通过累积曲线法和Mann-Kendall(M-K)检验法对渭河干支流7个关键控制断面进行水文变异点识别,并以此为基础,应用改进Tennant法计算渭河中下游各控制断面的生态低限流量与适宜生态流量。该成果可作为渭河开展流域综合治理和生态保护的参考数据。     

吸声材料的研究与应用

利用吸声材料来吸声降噪是治理噪声污染的重要途径之一.阐述了共振吸声材料与多孔吸声材料吸声降噪的机理,较为详细的介绍了各种吸声材料的分类、研究与应用及性能评价,对吸声材料未来研究发展趋势加以展望.     

两种不同原料制备无粘结剂高强度炭材料的研究

分别以生石油焦和煤系原料改性炭粉为原料成功制得了无粘结荆高强度炭材料。实验表明：原料挥发分含量较高对粉料的成型有利，但挥发分含量过高，不利于无粘结剂炭材料的烧结；另外，随着成型压力的增加，生坯密度和无粘结荆炭材料烧结制品的密度都呈升高的趋势。研究结果表明：成型压力为IOOMPa，烧结温度为1000℃，生石油焦粉制得的无粘结剂炭材料的抗折强度为42．90MPa，抗压强度为90．23MPa；煤系原料改性炭粉制得的无粘结剂炭材料的抗折强度为61．58MPa，抗压强度为116．12MPa。