Quantitative determination of corrosion products and adsorbed water on copper in humid air containing SO2 by IR-RAS measurements

The time dependency of the amounts of corrosion products and co-existing adsorbed water on copper in humid air containing SO₂ was estimated from a series of in situ time-resolved IR-RAS spectra on the basis of the relations between the band intensities and the mass changes of the corrosion products, which were determined by simultaneous measurement of IR-RAS and QCM. The amounts of both corrosion products increased slowly at the initial stage and later increased rapidly. Although the relative humidity was kept constant, the amount of adsorbed water increased nearly the same behavior as that of corrosion products in the stage of relatively small amounts of corrosion products and later increased rapidly when the amounts of corrosion products increased. In humid air without SO₂, sulfite gradually decomposed and some of it changed into sulfate.     

Meter-scale large area LED-embedded light fabric for the application of fabric ceilings in rooms

We have developed a meter-scale light emitting diode (LED)-embedded light fabric and its weaving machine for application to a light device for fabric ceilings, which have recently become desired for lightweight safe ceilings in Japan and other countries with frequent earthquakes. The LED fabric structure is 1.2-m-wide woven fabric that has 5-mm-wide LED chip-mounted printed circuit board (PCB) tapes as wefts. LEDs are mounted on the tape of PCBs with a reel-to-reel chip mounting system. Then, the LED-mounted tapes are woven with a developed automatic looming machine that aligns the weft with an accuracy of 0.9 mm, which is suitable for precise arrangement of LEDs and wiring to power supply. A 1.2 × 1.2 m LED-embedded light fabric weighing 320 g/m² was woven. The luminance of the LED fabric is 353 lx at a distance of 1 m, which is the luminance of conventional office lighting. The temperature increase of LEDs without a rigid cooling aluminum plate is only 5.8 °C, and the LED fabric is flexible enough to sustain 1,000 bends down to a radius of 3 mm. This LED fabric and its weaving technology will lead to light devices that have lightweight, large area, and high flexibility for fabric ceilings, walls, and other large areas in homes and offices.     

Characterization of the Advanced Satellite for Cosmology and Astrophysics x-ray telescope: preflight calibration and ray tracing

The x-ray properties of multinested thin-foil mirror x-ray telescopes (XRT's) on board ASCA, the Advanced Satellite for Cosmology and Astrophysics, were fully evaluated with an x-ray pencil beam.Scanning over the telescope aperture of 35 cm in diameter with an x-ray pencil beam, we found the effective area of a set of XRT's to be 325, 200, and 113 cm(2) at energies of 1.5, 4.5, and 8.0 keV, respectively. We derive the point-spread functions (PSF's) of the XRT's by measuring the image profile at the focal plane with an x-ray CCD. The PSF is found to exhibit a sharp core concentrated within 30 arcsec and a broad wing extended to 3 arcmin in half-power diameter. We also evaluate the contribution of stray light, which is caused by the single reflection of x rays by primary or secondary mirrors and by the backside reflection of the mirrors. To obtain the characteristics of the XRT in the energy region of 0.5-10.0 keV, incorporated with the measurements at discrete energies, we develop a ray-tracing method with the telescope design parameter, the PSF, and optical constants. In particular, we obtain the optical constants around the gold-atom M shell (Au-M) absorption-edge energies by measuring the reflectivity of our mirror sample, with monochromatized x-rays in the energy range of 2.0-3.5 keV from synchrotron radiation. Taking into account the PSF's and optical constants, we find that our ray-tracing program can reproduce all these XRT performances.     

Incoherent-only joint-transform correlator

An incoherent-only optical and electronic digital joint-transform correlator is proposed. A technique for the removal of extraneous signals inherent in the incoherent-only joint-transform correlator is also presented. A computer simulation and experimental results confirm the performance of the proposed incoherent-only joint-transform correlator.     

Linearized method: A new approach for kinetic analysis of central dopamine D(2) receptor specific binding

We proposed a new method (;linearized method') to analyze neuroleptic ligand-receptor specific binding in a human brain using positron emission tomography (PET). We derived the linear equation to solve four rate constants, k(3), k(4), k(5), k(6) from PET data. This method does not demand a radioactivity curve in plasma as an input function to the brain, and can perform fast calculations in order to determine rate constants. We also tested the nonlinearized method including nonlinear equations which is a conventional analysis using plasma radioactivity corrected for ligand metabolites as an input function. We applied these methods to evaluate dopamine D(2) receptor specific binding of [(11)C] YM-09151-2. The value of B(max)/K(d)=k(3)/k (4) obtained by the linearized method was 5.72+/-3.1 which was consistent with the value of 5.78+/-3.4 obtained by the nonlinearized method.     

Induction and intracellular localization of a 72-kDa heat shock protein in rat gastric mucosa after water-immersion stress

We investigated the expression and changes in the intracellular localization of a 72-kDa heat shock protein (HSP72) in rat gastric pyloric and fundic mucosa before and after water-immersion stress. Severe mucosal damage was found in the fundic mucosal area of the stomach after this stress. However, no mucosal lesion developed in the pyloric mucosal area. HSP72 in both the soluble and insoluble fractions of the pyloric and the fundic mucosal areas was significantly increased after water-immersion stress, peaking 6h after the initiation of the stress. The increase in HSP72 was more significant in the pyloric mucosal area than in the fundic mucosal area under both normal and stress conditions. The increase of HSP72 in the pyloric mucosal cells occurred prior to the formation of the mucosal lesions, whereas the increase of HSP72 in the fundic mucosal cells was observed after ulcer formation. An immunohistochemical study showed that HSP72 was constitutively expressed in the cytoplasm of the gastric mucosal cells, and that the intranuclear induction of HSP72 was remarkably intense in the pyloric mucosal cells, especially in the proliferative zone, compared with the fundic mucosal cells. Our results may suggest that HSP72 has an important cytoprotective function in gastric mucosal cells and that there is a "biophysical" difference between pyloric and the fundic mucosal cells.     

Magnetically coupled oscillators applicable to high-sensitivity mass detection

Microsystem Technologies - In this paper, a system of magnetically coupled oscillators consisting of a Π-shaped horizontal cantilever and a rectangular vertical cantilever with a frequency...     

Characteristics of sol-gel derived PZT thin films with lead oxide cover layers and lead titanate interlayers

The sol-gel derived PbZr_0.53Ti_0.47O₃ (PZT) films were fabricated on the bare Pt/Ti/SiO₂/Si substrates or the same substrates coated by the PbTiO₃ (PT) interlayers. The post-deposition annealing temperature and time were optimized when the PbO cover layers and PbO vapour-containing atmosphere were compared with each other and adopted as the method to diminish the lead-loss problem during the high-temperature post-deposition annealing. The X-ray diffraction patterns, microstructures, and electrical properties such as relative permittivity, _r, remanent polarization, P _r, and coercive electrical field, E _c, were investigated in relation to the annealing conditions. The PZT films deposited on the bare Pt/Ti/SiO₂/Si substrates under the PbO vapour-containing atmosphere showed better electrical properties. This indicates that the PbO vapour-containing atmosphere may be the better method of lead-loss-prevention to process the lead-containing films rather than the PbO cover layer method. The electrical characteristics of the PZT films, _r=1150, a dissipation factor of 0.039, P _r=26 C cm^–2, and E _c=40.5 kV cm^–1 were measured at 1 kHz. When PZT films were deposited on substrates coated by the PT layers, PZT-PT films with single perovskite phase were derived by post-deposition annealing at 500 °C for 1 h. However, the relative electrical properties are very poor, i.e. E _r=160, P _r=2.0 C cm^–2 and E _c=75 kVcm^–1. The optimum combination for preparing PZT-PT films is a 40 nm PbTiO₃ interlayer and annealing conditions of 6 h at 550 °C in a PbO vapour-containing atmosphere; the derived films exhibit electrical properties of E _r=885, P _r=21.5 C cm^–2 and E _c=64 kV cm^–1. The combination of inserting a PT interlayer and annealing in a PbO vapour-containing atmosphere can prevent the formation of electrical short paths. In this case, nearly pin-hole-free PZT films can be grown on the PT (interlayer) /Pt/Ti/SiO₂/Si substrates. It is believed that it is possible to prepare the PZT films with nano-scale uniformity, reproducible quality, which may be worth considering for commercial applications.     

Production of IL-6 by T cells from the femoral head of patients with rapidly destructive coxopathy (RDC)

We developed a method to improve the quantitative precision of FDG-PET scans in cancer patients. The total-lesion evaluation method generates a correlation coefficient (r) constrained Patlak parametric image of the lesion together with three calculated glucose metabolic indices: (a) the total-lesion metabolic index ("KT-tle", ml/min/lesion); (b) the total-lesion voxel index ("VT-tle", voxels/lesion); and (c) the global average metabolic index ("KV-tle", ml/min/voxel). METHODS: The glucose metabolic indices obtained from conventional region of interest (ROI) and multiplane evaluation were used as standards to evaluate the accuracy of the total-lesion evaluation method. Computer simulations and four patients with metastatic melanoma before and after chemotherapy were studied. RESULTS: Computer simulations showed that the total-lesion evaluation method has improved precision (% s.d. < 0.6%) and accuracy (approximately 10% error) compared with the conventional ROI method (% s.d. approximately 5%; approximately 25% error). The KT-tle and VT-tle indices from human FDG-PET studies using the total-lesion evaluation method showed excellent correlations with the corresponding values obtained from the conventional ROI methods and multiplane evaluation (r approximately 1.0) and CT lesion volume measurements. CONCLUSION: This method is a simple but reliable way to quantitatively monitor tumor FDG uptake. The method has several advantages over the conventional ROI method: (a) less sensitive to the ROI definition, (b) no need for image registration of serial scan data and (c) includes tumor volume changes in the global tumor metabolism.     

Thermodynamic evaluation of Cu– system based on newly determined Gibbs energy of formation of

Thermodynamic evaluation of Cu–Cu₃P system has been conducted by applying subregular solution model with Gibbs energy of Cu₃P formation that was newly determined by means of triple Knudsen cell mass spectrometry. Both the calculated vapor pressure of phosphorus and phase diagram of Cu–P system are excellently consistent with the literature data in the composition range of Cu–Cu₃P, indicating that there is no significant thermodynamic inconsistency between the present work based on the Gibbs energy of Cu₃P formation determined and the literature data.