一种基于应用层ARQ的传输机制

提出了一种基于应用层ARQ的传输机制:BAATM(Transmission Mechanism Based on ARQ of the Application Layer)。基于BAATM,提出了一种数据封装:DDoIP(Data Directly over IP,数据直接IP封装)。DDoIP头部开销比TCP节约了20字节,比UDP节约了8字节;在传输数据量相同时,BAATM有效性比TCP提高了约30%,比TFTP提高了约50%。实验证明了BAATM的可行性。     

13SiMnNiCrMoV钢切口疲劳裂纹萌生门槛值

本文研究在13SiMnNiCrMoV 结构钢中用尖裂纹的应力强度因子来反映三点弯曲缺口试样的疲劳裂纹萌生规律。当 R=0.1,f=100Hz,试样尺寸 B×W×L=12.5×25×117mm 时,缺口名义应力幅的门槛值为Δσ_(th)=3315ρ~(0.352) MPa,0.5mm≤ρ≤5mmΔK_(th)=250ρ~(0.352) MPam~(1/2)门槛值与ρ有关。同时得到缺口裂纹萌生的循环次数 N_i 与名义应力幅Δσ、缺口曲率半径ρ的定量关系是N_i=3.98×10~(22)ρ~(1.62)/Δσ~(4.85),N_i≤10~(5.5)并讨论了(ΔK_1/ρ~(1/2))_(th)与ρ无关的结论。     

双子表面活性剂(C12-2-12.2Br-1)表面活性与驱油效率研究

用滴体积法测定了几种双子表面活性剂和对应常规单链表面活性剂的表面张力-浓度曲线,确定了各自的临界胶束浓度,筛选出高效驱油用表面活性剂—C12-2-12. 2Br^-1;并在不同条件下对其进行了室内模拟驱油评价实验。表面张力测试表明,双子表面活性剂—C12-2-12. 2Br^-1的临界胶束浓度仅为547mg/L,对应表面张力为30.72mN/m,较对应单链表面活性剂DTAB具有更优的表面活性。驱油实验表明C12-2-12. 2Br^-1的驱油效率与浓度呈同向变化关系,其浓度为500mg/L即可提高采收率6.45%,其效果明显优于常规单链表面活性剂-DTAB;该剂更适合于中、低渗油藏水驱采收率的提高。     

降低射频电路串扰噪声的布线方法

研究并解决了无障碍多层无网格射频电路的布线问题,主要包括三个部分:设计规则、串扰噪声限制和布线方法.首先通过设计规则计算连线参数,运用RLc模型估算串扰噪声,然后,按照需要连接的实节点个数进行归类并提出相应的布线算法.实验结果表明,该布线方法可有效地降低射频电路的串扰噪声.     

负载型TiO2催化剂对提高老龄化垃圾渗滤液可生化性处理效果的研究

本文针对在不同条件下的光化学氧化处理高浓度垃圾渗滤液，进行了改善其可生化性与提高NH3～N去除率的研究。在负载型TiO2催化剂催化下BOD5／CODCr，值从0、064提高到0，228，超过了0.1的可生化性要求。二氧化钛催化剂对NH3-N去除效果明显，15minNH3-N去除率可达80.19％。     

安钢1#煤气混合加压站的单加压改造实践

阐述了煤气混合加压站运行中的不足，提出了单加压焦炉煤气和叶轮两方面改造的措施，并取得了良好的效果。     

建立湖州广电网络信息业务平台的设想

叙述在数字电视平台上建立广电网络信息业务平台的设想,并提出建立湖州广电网络信息业务平台的几点看法。     

A SURVEY OF ARYLAMINE N-ACETYLTRANSFERASE ACTIVITY IN COMMON FRUITS AND VEGETABLES

The N-acetyltransferase activity was determined in 58 common fruits and vegetables. The assay was based on acetylation of 2-aminofluorene or p-amino-benzoic acid, followed by high pressure liquid chromatographic analysis of products and remaining nonacetylated substrate. The highest specific activities were observed in Balsam pear which contained 17.37 ± 1.45 N-acetyl aminofluorene nmole/min/mg protein and 46.27 ± 6.87 N-acetyl p-aminobenzoic acid nmole/min/mg protein. N-acetyltransferase activities within the remaining 57 foodstuffs analyzed ranged from none detected to 3.39 ± 0.72 N-acetyl aminofluorene nmole/min/mg protein and none detected to 32.45 ± 6.55 N-acetyl p-aminobenzoic acid nmole/min/mg protein. This is the first demonstration of acetyl CoA: arylamine N-acetyltransferase activity in common foodstuffs.     

碳纤维表面处理对铝电解用硼化钛阴极涂层性能的影响

硼化钛阴极涂层是铝电解用可润湿性阴极材料中的一种，具有优良的抗钠渗透性和对铝液润湿性，可以有效地延长铝电解槽寿命。碳纤维是硼化钛涂层材料的增强剂之一．对硼化钛阴极涂层的性能影响很大。本文研究了不同工艺的液相碳纤维表面氧化处理法对硼化钛阴极涂层抗拉强度和粘接强度的影响。采用PTIR检测碳纤维处理后表面含氧基团的变化，寻找影响硼化钛阴极涂层性能的原因，从而达到最有效地提高TiB2阴极涂层抗拉强度和粘接强度的目的。结果表明，采用工艺(1)(10％HNO3，80℃、恒温5min．超声波、5min)对碳纤维进行表面处理最合理，处理后碳纤维表面含氧基团的含量最高．用其制备硼化钛阴极涂层的抗拉强度、粘接强度最大。     

Hydrothermal Synthesis of Acicular Lead Titanate Fine Powders

A pure, acicular lead titanate (PbTiO₃) fine powder with a white color has been prepared by hydrothermal synthesis. It is a new phase of PbTiO₃ with I 4 symmetry, cell parameters of a = 12.358 Å and b = 14.541 Å, and a density of 6.80 g.cm⁻³. The influences of pH (12.5 to 14.4), Pb/Ti ratio (1.0 to 1.6) in the feedstock, reaction temperature (130° to 230°C), time (0.25 to 4 h), starting materials, and additives on the formation of acicular PbTiO₃ under hydrothermal conditions have been investigated. The acicular PbTiO₃ with I 4 symmetry, referred to as the PX phase, can be converted to the perovskite-type (PE phase) of PbTiO₃ at about 605°C while its acicular morphology is essentially unchanged. The preferable conditions for preparing pure acicular PX-phase PbTiO₃ are that the pH is 13.0 to 14.0, Pb/Ti ratio is >1.3, reaction temperature is 170° to 200°C, time is 0.5 to 1.0 h, titanium butoxide (Ti[O(CH₂)₃CH₃]₄) is the starting material, and poly(vinyl alcohol) is an additive. The acicular grain of the PX phase is usually less than 100 nm in diameter and more than 1000 nm in length.