Ion irradiation—induced structure damage to botanic samples using the ion transmission energy spectrum

1 INTRODUCTIONThe new aPplications of low energy heavy ion beam in irradi4ted botanical materialswere studied in recellt yeaxs. The beaminduced mutation effect on crop seeds has causedthe attention of physicist and biologists.[1l:] FOr examPle, 1ow energy ions can induceremarkable mutation to rice seeds.[3] There are many special phenomena when heavyions bombard botanic sW1e due to its special structure. Some studies showed that tllepenetration depths of some ions were far larger than t…     

Air bearing design, optimization, stability analysis andverification for sub-25 nm flying

Three sub-25 nm fly height sliders are presented for near contact recording. The designs are geared towards the goal of achieving 10 Gb/in ² areal density. The optimization procedure presented shows promise for facilitating achievement of this goal. The dynamic simulations show the stability of these designs when disturbed from their steady state conditions     

Effects of solid retention time on the performance of submerged anoxic/oxic membrane bioreactor.

In this study, four similar bench-scale submerged Anoxic/Oxic Membrane Bioreactors (MBR) were used simultaneously to investigate the effects of solids retention time (SRT) on organic and nitrogen removal in MBR for treating domestic wastewater. COD removal efficiencies in all reactors were consistently above 94% under steady state conditions. Complete conversion of NH(4+)-N to NO(3-)-N was readily achieved over a feed NH(4+)-N concentration range of 30 to 50 mg/L. It was also observed that SRT did not significantly affect the nitrification in the MBR systems investigated. The average denitrification efficiencies for the 3, 5, 10 and 20 days SRT operations were 43.9, 32.6, 47.5 and 66.5%, respectively. In general, the average effluent nitrogen concentrations, which were mainly nitrate, were about 22.2, 27.6, 21.7 and 13.9 mg/L for the 3, 5, 10 and 20 days SRT systems, respectively. The rate of membrane fouling at 3 days SRT operation was more rapid than that observed at 5 days SRT. No fouling was noted in the 10 days and 20 days SRT systems during the entire period of study.     

阴极爆炸发射电子电离气体原初过程的动力学模拟

基于阴极爆炸发射电子和电子对气体的碰撞电离模型 ,用胞中粒子 (PIC)模拟方法对单间隙冷阴极气体放电过程中阴极爆炸发射产生的电子和电子碰撞电离产生质子的动力学特性进行了研究。分别给出了在 1.33× 10 - 2 Pa氢气压和 10kV间隙电压下 ,气体放电过程中电子和质子的空间和相空间分布、速度统计分布以及轴线上电荷密度分布 ,分析了阴极爆炸发射电子电离过程。模拟结果表明 ,间隙中电子的最大速度达 5 .8× 10 7m/s ,而只有少数的气体电离产生的质子最大速度达到 1.3× 10 6 m/s。     

A Stronger Complexity Result for the Single Machine Multi-Operation Jobs Scheduling Problem to Minimize the Number of Tardy Jobs

We consider the single machine multi-operation jobs scheduling problem to minimize the number of tardy jobs. Each job consists of several operations that belong to different families. In a schedule, each family of job operations may be processed in batches with each batch incurring a setup time. A job completes when all of its operations have been processed. The objective is to minimize the number of tardy jobs. In the literature, this problem has been proved to be strongly NP-hard for arbitrary due-dates. We show in this paper that the problem remains strongly NP-hard even when the due-dates are common and all jobs have the same processing time.     

Physicochemical Properties of Bread Baked from Flour Blended with Immature Wheat Meal Rich in Fructooligosaccharides

ABSTRACT: Grain of the soft white wheat cultivar Harus was harvested weekly from anthesis to maturity and fructooligosaccharides (FOS) contents were determined by reversed-phase high-performance liquid chromatography. Tests were carried out to determine the effect of adding immature wheat meal to a base flour of cultivar Russ (hard red spring) on the quality characteristics of bread. FOS content was also analyzed in baked bread, and the effect of transglutaminase in improving bread quality was examined. Marked decreases in FOS contents, such as 1-kestose and nystose, were observed with grain maturation. The overall quality of bread appeared to be acceptable, and the added FOS were retained after baking.     

NMR structure and mutagenesis of the FADD (Mort1) death-effector domain

When activated, membrane-bound receptors for Fas and tumour-necrosis factor initiate programmed cell death by recruiting the death domain of the adaptor protein FADD to the membrane. FADD then activates caspase 8 (also known as FLICE or MACH) through an interaction between the death-effector domains of FADD and caspase 8. This ultimately leads to the apoptotic response. Death-effector domains and homologous protein modules known as caspase-recruitment domains have been found in several proteins and are important regulators of caspase (FLICE) activity and of apoptosis. Here we describe the solution structure of a soluble, biologically active mutant of the FADD death-effector domain. The structure consists of six antiparallel, amphipathic alpha-helices and resembles the overall fold of the death domains of Fas and p75. Despite this structural similarity, mutations that inhibit protein-protein interactions involving the Fas death domain have no effect when introduced into the FADD death-effector domain. Instead, a hydrophobic region of the FADD death-effector domain that is not present in the death domains is vital for binding to FLICE and for apoptotic activity.     

Imaging of follicular dendritic cell tumours of the liver

Follicular dendritic cell tumour of the liver is a recently recognized entity. To date, only two cases have been described, both in the pathology literature. Histologically, it resembles an inflammatory pseudotumour and immunohistochemical and ultrastructural studies are required for its diagnosis. The ultrasound, computed tomography and angiographic features of two cases of follicular dendritic cell tumour of the liver are described in detail. One of the patients had multiple recurrences of this tumour. The imaging features are very similar to those of hepatocellular carcinoma. As follicular dendritic cell tumour is considered to be of low-grade malignant potential, in contrast to the dismal prognosis for hepatocellular carcinoma, it is important to be able to accurately distinguish between the two types of tumour prior to initiating definitive therapy.     

Control of high common mode voltage during transthoracicdefibrillation

A high common mode voltage (V_cm) relative to earth ground is produced on the myocardium during the delivery of a defibrillator pulse and can generate a differential error signal when potential gradients are recorded with bipolar electrodes and isolation amplifiers. The error signal is proportional to V_cm, and therefore, a reduction in V_cm improves the accuracy of the potential gradient data. Experiments were conducted on 5 dogs to determine whether V_cm can be controlled using a bridge circuit. The bridge circuit consisted of a 5 kΩ power rheostat in parallel with the transthoracic resistance of the dog. The variable contact of the rheostat was connected to earth ground, and by adjusting the rheostat, V_cm on the myocardium could be varied. In each dog, 20 A shocks were delivered through stainless steel transthoracic electrodes. Point contact electrodes sutured to the epicardium were used to measure V_cm. It was determined that V_cm could be reduced to approximately zero at a given electrode on the heart. In addition, for the 5 dogs studied, the maximum measured V_cm on the heart was only 10% of the transthoracic voltage when the bridge circuit was balanced for an interior point in the heart