Highly active lanthanum doped nickel anode for solid oxide fuel cells directly fuelled with methane

Lanthanum doped nickel and YSZ composite anode (LaNi–YSZ) exhibited a greatly reduced polarization resistance and high performance for electrochemical oxidation of hydrogen and methane, which resulted from a fine anode structure with a high dispersion of nickel catalyst and a high catalytic activity towards methane.     

F150交换机告警关联规则的研究

为了提高电信网络运营效率，降低维护成本，电信运营企业在网络告警管理系统中需要引入数据挖掘技术。本文主要研究利用数据挖掘技术来进行故障的管理，即对告警进行关联性分析，详细分析了告警序列数据的关联规则挖掘算法，并在南昌本地网F150交换机的告警数据库中予以实现，同时对实际挖掘结果进行分析和整理，推导出一些实用的关联规则。     

应用底饲回燃循环流化床技术改造东锅DG35/3.82-7型流化床锅炉

采用飞灰循环底饲回燃技术改造西南合成制药总厂热电分厂、天府矿务局磨心坡发电厂2台东方DG35/3.82-7型低倍率循环流化床锅炉。改造后运行结果表明,锅炉可长期、稳定运行,尾部飞灰可燃物含量大幅度降低,锅炉蒸发量提高20％左右,节煤效果明显。为燃用贫煤、无烟煤和煤矸石等劣质燃料且锅炉炉膛高度较低的电站技改,提供了一种切实可行的方法。     

Performance evaluation of a multichannel transceiver system forADSL and VHDSL services

The authors study the performance of a multichannel modulation method for asymmetric digital subscriber lines (ADSLs) and very high-speed digital subscriber lines (VHDSLs). In the ADSL case, over all unloaded North American subscriber lines in the test set, a unidirectional 1.536 Mb/s data rate service from the end office to the customer premises is possible on a single twisted pair at an error rate of 10^-7 with at least a 6 dB margin used coded multichannel modulation with sufficient transmit power. In the VHDSL case, data rates in excess of 100 Mb/s can be transmitted reliably, at an error rate of 10^-7, using uncoded multichannel modulation on a single twisted pair over a distance ⩽150 ft with a sufficiently high sampling rate (≈24 MHz) and transmit power. It is shown that a cost-effective multichannel transceiver design suggested for high-speed digital subscriber line (HDSL) service will also work well for ADSL and VHDSL services with only minimal modifications     

磷酸酯的单双酯比例与加脂性能

以十六醇和P2O5为原料,分别合成了三种单双酯比例不同的十六醇磷酸酯皮革加脂剂,通过应用实验对它们的加脂性能进行研究,确定了单酯和双酯分别在加脂中所起的作用。结果表明,双烷基磷酸酯酯含量高的磷酸酯能赋予皮革更好的柔软性能和防水性能,单酯会使皮革产生明显的增厚。     

热声热机系统振荡频率的理论计算与实验验证

以热声发动机为例采用网络模型计算了热声热机系统的振荡频率，得出振荡频率为复频率，其实部代表实际频率，虚部表示压力幅值的衰减程度。对热机系统在各种不同的情况下(包括不同大小的谐振腔、板叠间距、气体静压、系统长度)进行了数值计算，理论计算值与实验结果能很好的吻合。     

Effect of Additives on Magnetic Properties of High Frequency MnZn Power Ferrite

In keeping with the advance of more compact and more power-saving electronic equipment, the demand is increasing for smaller and more efficient switching power supply. Therefore, it is necessary to provide the adequate magnetic power ferrite materials to satisfy the demand. Such ferrite materials have to meet the following main requirement: 1) high initial permeability (μ i ); 2) high saturation magnetic induction (Bs); 3) high Curie temperature (Tc); 4) high electrical resistivity (ρ ); 5)…     

~(141)CeO_2经气管内注入后在肺及淋巴结内的动态分布

本文报告了应用γ放射性测量和放射自显影方法,观察~(141)CeO_2经气管内注入后在大鼠肺及局部淋巴结中动态分布的特点。实验结果表明,~(141)Ce 在肺内与在不同部位、不同个体和单个淋巴结中的分布都是很不均匀的;其滞留量随时间而变化。     

Network model approach for calculating oscillating frequency of thermoacoustic prime mover

The network model is given and used to calculate the oscillating frequency of thermoacoustic prime mover. Theoretically calculated frequency by the model is plural, whose real part denotes actual frequency of the system, and imaginary part means attenuation coefficient of acoustic pressure. Numerical calculation is made under different conditions including different acoustic cavities, spacing between each parallel plate, gas pressures and system lengths. Theoretically calculated frequency and experimentally measured frequency are in quite good agreement.     

狭缝中生存——浅谈影响建筑师理想实现的因素

本文根据作者最近所参与“北大附中重庆实验学校”的工程项目中的所见所闻,结合国内建筑市场的实际情况,探讨了中国建筑师在理想实现过程中,所面临的各种困难及其背后深刻的社会原因,希望借此启发一些正在为自己的理想而在日夜奋斗着的年轻建筑师们。为了形象地说明这些因素对一项优秀建筑项目的产生所起的作用,文中采用了量化的百分比评价体系。