三峡工地高压供电线路故障判断方法的探讨

高压供电设备故障特别是输电线路的高压接地故障对工地的影响是相当大的。由于接地故障为隐性故障，没有明显的物理现象，且若是长期接地可能会发展成较为严重的两相或三相短路故障，使系统解列运行直至崩溃；由于工地流动人员较多，还易造成电击事故。利用高压一相接地时在线路中产生零序电压这一特性来迅速判断和切除接地的用电设备，可以保证各项施工的顺利进行。     

TRVs and fault clearing stresses in extra-high-voltage radial networks

To cope with the high rate of increase of power demand in the main industrialized districts in Japan, 550-kV transmission systems covering the districts have been reinforced, with most of the main power plants connected directly to these systems. Through 550-/300-kV substations, the majority of power to the districts is supplied by 300-kV systems. To limit the excess short-circuit capacity in the 300-kV systems, they tend to be reconstructed as so-called radial networks. In radial networks with high short-circuit capacity and relatively small number of transmission lines connected to the substation busbars, the rate of rise of TRV can be far higher than standard value. This paper analyzes the transient recovery voltages (TRV) in such extra-high-voltage radial networks in Japan, together with the relevant stresses to circuit-breakers during fault clearings. Future system conditions have also been introduced. As the typical rate of rise of the TRV values, more than twice that of today's standard ones are probable.     

降低电解生产槽立柱与水平母线间压接压降方法探讨

通过对电解生产槽立柱与水平母线间压接压降的论述和分析试验，寻求一种降低该压接压降的方法，以达到降低电耗，降低成本，提高电解生产经济效益的目的。     

A new voltage control equipment using fuzzy inference

Power system control equipment needs higher sensitivity and operational reliability. Advanced voltage control equipment is needed for reducing the frequency of tap changes and improving the characteristics (the relationship between the actual voltage and reference voltage) of the voltage to meet today's power system requirements. However, these objectives are in a trade-off relationship. Studies of voltage control derived from a knowledge base suitable for electric power systems can satisfy these objectives using fuzzy inference. Compared with corresponding conventional equipment, the new equipment improved the deviation of 30 min average voltage of 30 percent. This paper describes the design concept of new voltage control equipment using fuzzy inference. In addition, field test results are described along with rules of fuzzy inference, membership functions, and the deviation of 30 min average voltage through detailed simulation.     

高电容比射频/微波MEMS膜开关的理论分析和数值模拟

建立了一个MEMS膜开关电容比理论模型，由于这个模型比较全面地考虑了开关阈值电压、维持电压、偏置电压和介质膜内的电场强度等因素对电容比的影响，因而能较为正确地反映开关的电容特性。用数值方法计算了影响开关电容比的因素，并对计算结果进行了分析和讨论。提出了使用脉冲电压作为偏置电压可以使介质膜gj的厚度减少到50nm，从而使开关的电容比增加到3800。最后，讨论了实现高电容比MEMS膜开关的可行性。     

Insulating safety analysis of the hot-line sweeping robot

This paper presents a method of calculating the insulating safety distances for hot-line working robots at high voltage when dielectric is adulterated with conducts. Also, finite element method is adopted to calculate the electric field strength to find whether it is beyond the critical. The above methods have been applied to analyze the insulating safety of the robot for hot-line sweeping post insulators in a 220 KV substation. They have also been testified by experimentations.     

高压电动机定子线圈匝间绝缘问题的探讨

在实践经验的基础上，分析了我国匝间绝缘短路的主要原因，提出在匝间绝缘的设计，制造工艺及耐压试验等工序采取合理措施，以提高匝间绝缘的可靠性。     

An investigation of induced voltages to an underground gas pipeline from an overhead transmission line

This paper investigates induced voltage characteristics from an overhead transmission line by applying a method of modeling of induced voltages proposed by the authors. EMTP simulation results obtained by the modeling method agree with analytical results obtained from a well‐known formula. The induced voltages are significantly dependent on the configuration of the overhead line. A horizontal line induces the largest voltage in a gas pipeline, and the voltage induced by a vertical twin‐circuit line is about 20% smaller than that induced by a vertical single‐circuit line. The method is applied to a real pipeline system and the simulation results show reasonable agreement with field test results. © 2008 Wiley Periodicals, Inc. Electr Eng Jpn, 164(1): 43–51, 2008; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/eej.20465     

高压大容量变频技术现状及交——交SDM级联技术简介

本文通过对目前广泛使用的三电平及多电平级联高压变频控制方案技术特点的对比论述，介绍了一种新型高压大容量变频器控制方案，并对该方案的优越性作了介绍。     

变频调速器在桥式抓斗吊车中的应用

论文主要介绍了电机的调速方法、变频器的工作原理以及日本FRNIC500G7型变频器在桥式抓斗吊车上的应用，并分析了使用绕线式电机调速与鼠笼式电机变频调速之间的优缺点。