甲基氯硅烷精馏流程的模拟与优化

采用Aspen plus软件对工业七塔精馏过程进行全流程建模与模拟，优化工艺参数，研究了新的精馏节能工艺。对一甲塔等7个精馏塔采用双因素水平的灵敏度分析，考察了塔釜采出率、回流比、进料位置和塔顶压力对产品浓度和热负荷的影响，确定一甲塔最优的工艺参数：塔釜摩尔采出率为0.92，摩尔回流比为130，塔顶压力为0.18 MPa，总理论板数为400，在210块理论板位置进料。在此基础上，针对高能耗的脱高塔/脱低塔，模拟研究了双效精馏新工艺，新工艺可节省39.70%的年总成本；针对一甲塔模拟研究了热泵精馏新工艺，新工艺可降低41.42%的年总成本。     

带有方形肋及双倾斜肋片的细通道内流动、传热和熵产分析

为了探究带有方形肋及双倾斜肋片细通道的流动换热及熵产特性，设计了2种带有方形肋及双倾斜肋片的组合细通道(MCDS-L, MCDS-R)，然后采用数值模拟的方法分析其流动特性、传热特性和熵产特性，并将其分析结果同2种方形肋细通道(MCS-L, MCS-R)和一种双倾斜肋片细通道(MCD)进行对比。结果表明，在所研究的雷诺数范围内，组合通道的摩擦阻力系数基本一致且均高于其他3组通道(MCS-L, MCS-R, MCD) 。此外，组合通道的努塞尔数均高于其他3组通道，而熵产增大数均低于其他3组通道。其中，MCDS-L通道的努塞尔数最大，熵产增大数最低。表明MCDS-L通道的换热效果最佳，能量的综合利用程度最高。研究成果为微细通道热沉的设计提供参考。     

防振条约束失效对蒸汽发生器传热管面内流弹失稳的影响研究

根据防振条布置以及面内支承连续失效个数，将防振条面内约束失效分析划分为多种工况，分析了不同工况下面内约束失效对传热管面内模态的影响，采用各位置阻尼在振型函数上进行加权平均的方法计算了各阶模态的阻尼比，进而研究了防振条面内不同约束对传热管面内流弹失稳的影响。分析结果表明，随着面内支承连续失效位置的增多，弯管段面内首阶模态频率不断降低，出现在弯管段的振型越加明显；弯管段面内首阶模态不一定是最大流弹失稳比值出现的模态，最大流弹失稳比值出现模态的振型几乎都出现在弯管段；随着面内支承连续失效位置的增多，面内流弹失稳比值不断增大，当连续3个及以上防振条面内约束失效时，将出现流弹失稳现象。     

Unsteady free convection of second‐grade nanofluid with a new time‐space fractional heat conduction

The Caputo and Caputo–Fabrizio derivative are applied to study a second‐grade nanofluid over a vertical plate. A comparative analysis is presented to study the unsteady free convection of a second‐grade nanofluid with a new time–space fractional heat conduction. The governing equations with mixed time–space fractional derivatives are non‐dimensionalized and solved numerically, and a comparison between the Caputo and the Caputo–Fabrizio models is made. It is found that the temperature is higher for the Caputo–Fabrizio fractional model than the Caputo model, but the higher velocity only exists near the vertical plate for the Caputo–Fabrizio model than the Caputo model. Moreover, the velocity for the Caputo model will exceed the Caputo–Fabrizio model as y evolves.     

An experimental study of forced convective heat transfer for fully developed Al 2 O 3 –water nanofluid in an annulus tube

Nanofluids have been known as practical materials to ameliorate heat transfer within diverse industrial systems. The current work presents an empirical study on forced convection effects of Al₂O₃–water nanofluid within an annulus tube. A laminar flow regime has been considered to perform the experiment in high Reynolds number range using several concentrations of nanofluid. Also, the boundary conditions include a constant uniform heat flux applied on the outer shell and an adiabatic condition to the inner tube. Nanofluid particle is visualized with transmission electron microscopy to figure out the nanofluid particles. Additionally, the pressure drop is obtained by measuring the inlet and outlet pressure with respect to the ambient condition. The experimental results showed that adding nanoparticles to the base fluid will increase the heat transfer coefficient (HTC) and average Nusselt number. In addition, by increasing viscosity effects at maximum Reynolds number of 1140 and increasing nanofluid concentration from 1% to 4% (maximum performance at 4%), HTC increases by 18%.     

带有蓄热型直接冷凝式加热板的空气源热泵系统性能研究

针对现有的空气源热泵冬季供热系统，提出了一种使用新型蓄热型直接冷凝式加热板（RHP）的空气源热泵供热系统，并测试了RHP的热性能和系统的运行特性，同时分析了系统的效率和经济性。实验结果表明，在39℃的冷凝温度下，RHP的热容量高达1044 W，RHP的蓄热量大于1000 kJ。在室外空气温度为8℃时，系统COP高达3.7。此外，对于20 m²的居住房间而言，该系统的供暖初始投资成本和总运行成本分别为3174.7 CNY和510.7 CNY，在居住建筑冬季供暖领域具有较大的竞争力。     

Stability and thermophysical properties of fly ash nanofluid for heat transfer applications

Improving the performance of heat transfer fluids is altogether significant. The best approach for improving the thermal conductivity is the addition of nanoparticles to the base fluid. In the present study, specific heat, dynamic viscosity, and thermal conductivity of water-based Indian coal fly ash stable nanofluid for 0.1% to 0.5% volume concentration in the temperature range of 30 to 60°C has been investigated. To evaluate an average particle diameter of 11.5 nm, the fly ash nanoparticles were characterized with scanning electron microscopy and dynamic light scattering. Using zeta potential, the stability of nanofluid in the presence of surfactant Triton X-100 was tested. Thermal conductivity and viscosity of fly ash nanofluid increased, while specific heat decreased as volume concentration increased. The effect of temperature on the fly ash nanofluid was directly proportional to its thermal conductivity and specific heat and inversely proportional to viscosity.     

大同市水资源开发利用状况与承载能力的思考

文中分析了大同市水资源开发利用的状况，并对水资源承载能力的有关问题进行了讨论。     

甲烷水合物热稳定性的研究

研究了在阴离子表面活性剂十二烷基硫酸钠(SDS)体系中甲烷水合物在冰点以下的常压分解规律。研究结果表明,静态下生成的甲烷水合物较动态下的分解速度低;在262·15~268·15K在之间,甲烷水合物的分解速度随着温度的降低而升高;在此范围以外,甲烷水合物的分解速度随着温度的降低而降低;在262·15~272·15K之间存在最低分解速度,其中在268·15K,甲烷水合物的分解速度最低。利用外推法计算268·15K时甲烷水合物完全分解需要25d,说明水合物的自我保存性质对气体水合物储运技术具有重要意义。     

变频调速系统中电动机和变频器选择及问题分析

本文分析了选用标准笼形电动机的容量计算方法、问题分析和选用变频器的型式、容量、注意事项。