新型无灰分散剂的结构分析研究

通过薄膜渗析、红外光谱、凝胶渗透色谱、皂化反应等一系列手段建立了一套对无灰分散剂的系统分析方法，并利用该方法得到了一种新型无灰分散剂及其衍生物的平均结构、相对分子质量分布、分散度等重要结构信息，得出该新型无灰分散剂的结构与传统无灰分散剂的结构不同。     

直接还原在当代冶金变革中的发展

简述了当代的直接还原现状与方法，论述了直接还原是发展短流程的重要基础，直接还原也是熔融还原法的重要组成，同时分析了发展直接还原与熔融还原是当代世界冶金变革中的重要方向之一，也是中国面向２１世纪的重大任务。     

Inhibiting and deactivating effects of water on the selective catalytic reduction of nitric oxide with ammonia over MnOx/Al2O3

The effect of water on the selective catalytic reduction (SCR) of nitric oxide with ammonia over alumina supported with 2–15 wt.-% manganese oxide was investigated in the temperature range 385–600 K, with the emphasis on the low side of this temperature window. Studies on the effect of 1–5 vol.-% water vapour on the SCR reaction rate and selectivity were combined with TPD experiments to reveal the influence of water on the adsorption of the single SCR reactants. It turned out that the activity decrease due to water addition can be divided into a reversible inhibition and an irreversible deactivation. Inhibition is caused by molecular adsorption of water. TPD studies showed that water can adsorb competitively with both ammonia and nitric oxide. Additional kinetic experiments revealed that adsorbed ammonia is present in excess on the catalyst surface, even in the presence of water. Reduced nitric oxide adsorption is responsible for the observed reversible decrease in the reaction rate; the fractional reaction order changes from 0.79 in the absence of water to 1.07 in its presence. Deactivation is probably due to the dissociative adsorption of water, resulting in the formation of additional surface hydroxyls. As the amount of surface hydroxyls formed is limited to a saturation level, the deactivating effect on the catalyst is limited too. The additional hydroxyls condense and desorb in the temperature range 525–775 K, resulting in a lower degree of deactivation at higher temperature. A high temperature treatment at 775 K results in a complete regeneration. The amount of surface hydroxyls formed per unit surface area decreases at increasing MnO_x-loading. The selectivity to the production of nitrogen is enhanced significantly by the presence of gas phase water.     

Selective catalytic reduction of nitric oxide by propane over vanadia-titania aerogels

An investigation has been carried out of the effect of vanadia loading on the activity and selectivity ofV₂O₅TiO₂ aerogel catalysts, prepared by a two-step procedure, for the reduction of NO by propane. The structure of catalysts have been characterized by laser Raman spectroscopy and XRD measurements. At vanadia loading levels below ca. 4.4 wt%, the vanadia is present in the form of coordinated polymeric species, whereas crystallites of V₂O₅ are formed at higher vanadia contents. At this critical level of 4.4 wt% V₂O₅, the kinetic measurements showed also a maximum in the activity per mass of catalyst which very likely indicated that the coordinated polymeric surface species are more active than crystalline V₂O₅. The selectivity towards the formation of dinitrogen decreased as the loading increased, presumably because of the formation of larger polymeric species and V₂O₅ crystallites, below and above the critical loading level, respectively. For the reduction of NO by propane, titania supported vanadia aerogel catalysts are significantly more active, per mass of catalyst, and more selective towards N₂ formation than conventionalV₂O₅TiO₂ and V₂O₅Al₂O₃ aerogel catalysts, at vanadia loading levels below ca. 11 wt%.     

《周培德三角剖分不是最小权三角剖分》一文商榷——反例不成立

周培协三角剖分是否能得到最小权三角剖分，周培德在《周培德三角部分不是最小权三角剖分》一文撰写之前已有新的结论，本文还指出《周培德三角剖分不是最小权三角剖分》一文所举反例不成立。     

具有减少辨识参数的随机多变量极点配置自适应控制器

本文提出了一种新的限制输出个数减少随机多变量自适应控制中辨识参数的方法，并给出了减少辨识参数的极点配置自适应算法。虽然采用ｎ个输入１个输出的减少辨识参数的模型来设计控制器，但所提出的控制器能够保证被控系统的几个输出跟踪参考输入信号，仿真结果表明，所提出的方法是成功的。     

聚碳硅烷的分子量分布与可纺性研究

阐述了聚碳烷的合成及其分子量分布，讨论了高低分子含量对聚碳硅烷熔点及可纺性的影响，而且提出了分子量分布的控制标准与方法。     

On the boundary-layer control through momentum injection: Studies with applications

The concept of moving surface boundary-layer control, as applied to a Joukowsky airfoil, is investigated through a planned experimental programme complemented by numerical studies. The moving surface was provided by rotating cylinders located at the leading edge and/or trailing edge as well as top surface of the airfoil. Results suggest that the concept is quite promising, leading to a substantial increase in lift and a delay in stall. Depending on the performance desired, appropriate combinations of cylinder geometry, location and speed can be selected to obtain favourable results over a wide range of angle of attack. Next, effectiveness of the concept in reducing drag of bluff bodies such as a two-dimensional flat plate at large angles of attack, rectangular prisms and three-dimensional models of trucks is assessed through an extensive wind tunnel test-programme. Results show that injection of momentum through moving surfaces, achieved here by introduction of bearing-mounted, motordriven, hollow cylinders, can significantly delay separation of the boundary-layer and reduce the pressure drag. The momentum injection procedure also proved effective in arresting wind-induced vortex resonance and galloping type of instabilities. A flow visualization study, conducted in a closed-circuit water tunnel using slit lighting and polyvinyl choride tracer particles, adds to the wind-tunnel and numerical investigations. It shows, rather dramatically, the effectiveness of the moving surface boundary-layer control (MSBC). The Sabita Chaudhury Memorial Lecture The models were fabricated in the Mechanical Engineering Workshop. The assistance of M/s E Abell, P Hurren and D Camp in the design and construction of the models is gratefully acknowledged. The investigation was supported by the Natural Sciences and Engineering Research Council of Canada, Grant No. A-2181.     

项重写系统的并行实现方案

项重写系统的并行归约可以提高归约的效率，在无共享内存的Ｔｒａｎｓｐｕｔｅｒ网络上实现时要考虑任务的分配，项的拼装，归约任务的控制等问题，其中怎么样减少机间的机内进程的通信慢提高系统效果的关键。本文从控制方式角度讨论在不同拓扑结构的Ｔｒａｎｓｐｕｔｅｒ网络上实现项重写系统的方案，重点介绍基于树形结构下的控制方法，进程安排和通讯形式。