全文获取类型
收费全文 | 2655篇 |
免费 | 191篇 |
国内免费 | 293篇 |
专业分类
电工技术 | 20篇 |
综合类 | 161篇 |
化学工业 | 364篇 |
金属工艺 | 807篇 |
机械仪表 | 77篇 |
建筑科学 | 194篇 |
矿业工程 | 47篇 |
能源动力 | 59篇 |
轻工业 | 77篇 |
水利工程 | 83篇 |
石油天然气 | 36篇 |
武器工业 | 14篇 |
无线电 | 91篇 |
一般工业技术 | 408篇 |
冶金工业 | 649篇 |
原子能技术 | 27篇 |
自动化技术 | 25篇 |
出版年
2024年 | 5篇 |
2023年 | 58篇 |
2022年 | 78篇 |
2021年 | 100篇 |
2020年 | 107篇 |
2019年 | 88篇 |
2018年 | 61篇 |
2017年 | 90篇 |
2016年 | 84篇 |
2015年 | 95篇 |
2014年 | 147篇 |
2013年 | 176篇 |
2012年 | 174篇 |
2011年 | 208篇 |
2010年 | 168篇 |
2009年 | 149篇 |
2008年 | 96篇 |
2007年 | 139篇 |
2006年 | 115篇 |
2005年 | 121篇 |
2004年 | 119篇 |
2003年 | 106篇 |
2002年 | 102篇 |
2001年 | 64篇 |
2000年 | 51篇 |
1999年 | 45篇 |
1998年 | 44篇 |
1997年 | 43篇 |
1996年 | 33篇 |
1995年 | 35篇 |
1994年 | 24篇 |
1993年 | 35篇 |
1992年 | 43篇 |
1991年 | 24篇 |
1990年 | 27篇 |
1989年 | 29篇 |
1988年 | 23篇 |
1987年 | 10篇 |
1986年 | 6篇 |
1985年 | 4篇 |
1984年 | 3篇 |
1983年 | 1篇 |
1982年 | 4篇 |
1981年 | 2篇 |
1974年 | 1篇 |
1961年 | 1篇 |
1958年 | 1篇 |
排序方式: 共有3139条查询结果,搜索用时 31 毫秒
81.
本文采用磁粉、X射线、CT和超声等无损检测和金相分析等方法对40CrNi2Si2MoVA钢制零件的磁痕显示进行了系统分析.研究认为,40CrNi2Si2MoVA钢制零件的磁痕显示为显微成分沿变形方向偏析导致的马氏体转变点Ms差异所致.显微成分偏析是钢锭结晶过程中不可避免的,但可通过优化熔炼工艺参数降低显微偏析的程度.本文还分析了四种磁痕显示的类型及其判别方法. 相似文献
82.
83.
C. M. Cotell G. J. Yurek R. J. Hussey D. F. Mitchell M. J. Graham 《Oxidation of Metals》1990,34(3-4):173-200
The oxidation behavior at 900°C of pure Cr and Cr implanted with 2×1016 Y ions/cm2 was studied. The kinetics of oxidation were measured thermogravimetrically and manometrically. The mechanisms of oxide growth were studied using18O-tracer oxidation experiments, and the composition and microstructure of the oxide scales were characterized by TEM and STEM. Segregation of Y cations at Cr2O3 grain boundaries was found to be the critical factor governing changes in the oxidation behavior of Cr upon the addition of Y. In the absence of Y, pure Cr oxidized by the outward diffusion of cations via grain boundaries in the Cr2O3 scale. When Y was present at high concentration in the scale, as when Cr implanted with 2×1010 Y ions/cm2 was oxidized, anion diffusion predominated. It is concluded that strain-induced segregation of Y at grain boundaries in the oxide reduced the cation flux along the grain boundaries. The rate of oxidation was reduced because the grain-boundary diffusivity of cations became lower than the grain-boundary diffusivity of the anions, which then controlled the rate of oxidation. Changes in the relative rates of Cr3+ and O2– transport, as well as a solute-drag effect exerted by Y on the oxide grain boundaries, resulted in changes in the microstructure of the oxide. 相似文献
84.
High speed steel (HSS) rolls can replace traditional rolls such as alloyed cast iron rolls and powder metallurgical (PM) hard alloy rolls. The main reasons for the replacement are that the wear resistance of low-cost alloyed cast iron rolls is poor and the cost of high-quality PM hard alloy rolls is very high. By means of centrifugal casting, HSS rolls having excellent wear resistance have been manufactured. The hardness of the HSS roll is 65~ 67 HRC, the range of variation is smaller than 2 HRC and its impact toughness is 15 J/cm2. The wear rate of HSS rolls used in the pre-finishing stands of high-speed hot wire-rod rolling mill reaches 2.5 × 10-4 mm per ton steel. Furthermore, the manufacturing cost of HSS rolls is significantly lower than that of PM hard alloy rolls; it is only 30 percent of that of PM hard alloy rolls. 相似文献
85.
86.
87.
本实验分别在普通重力场和4230g超重力场下制备了Cu_(98.4)Cr_(1.6)合金的凝固样品,研究了重力场对Cu_(98.4)Cr_(1.6)合金棒状共晶尺寸和宏观偏析情况的影响。结果表明:与普通重力场的凝固组织相比,当Cu_(98.4)Cr_(1.6)合金棒状共晶在4230g超重力场下凝固时,棒状共晶组织得到了明显的细化,其直径由250~350nm降至100~200nm。同时,Cu_(98.4)Cr_(1.6)共晶合金沿超重力场方向的硬度和成分分布基本一致,未出现明显的宏观偏析。 相似文献
88.
建立了三维格子玻尔兹曼方法(LBM)-元胞自动机(CA)耦合数值模型,并用该模型模拟研究了Al-4.7%Cu(质量分数)固溶体合金的凝固过程。该耦合模型采用元胞自动机方法模拟枝晶的生长,同时采用基于分子动力学理论的格子玻尔兹曼方法模拟合金凝固过程中的温度场、流场以及溶质场。模拟结果再现了合金凝固过程中的三维枝晶形貌变化以及溶质富集过程,并将三维流场因素考虑进去,定量研究了自然对流、过冷度对单枝晶形貌和成分分布的影响。研究表明,在纯扩散条件下,枝晶呈现对称的生长现象,模拟自由枝晶稳态生长的尖端速度、尖端半径和过冷度的关系与Lipton-Glicksman-Kurz(LGK)理论模型吻合得较好。在自然对流条件下,枝晶的生长形貌呈现不对称性,即枝晶生长在迎流方向上得到了促进,在顺流方向上受到了抑制。熔体过冷度对枝晶生长的影响较大,过冷度的增加导致枝晶生长加快,二次枝晶增多且呈现出粗化现象,枝晶尖端固液界面处的溶质浓度偏高,加重了溶质偏析。 相似文献
89.
文章基于验证和解决信息设备内存储器存在的信息安全泄漏隐患,提出了内存储器信息泄漏概念并对内存储器存在信息泄漏的原因做了介绍。实测发现现有内存储器存在信息泄漏状况,基于此,该文提出了基于公共信息网和文件型恶意代码窃取的内存储器信息泄漏方式并完成了实测过程,文章结论对于信息安全保密领域的内存储器信息泄漏隐患防护具有重要意义,尤其适用于安全隔离和信息交换等信息系统领域,具有较广泛的应用前景和重大的社会意义。 相似文献
90.
基于计算听觉场景分析和语者模型信息的语音识别鲁棒前端研究 总被引:1,自引:0,他引:1
传统抗噪算法无法解决人声背景下语音识别(Automatic speech recognition, ASR)系统的鲁棒性问题. 本文提出了一种基于计算听觉场景分析(Computational auditory scene analysis, CASA)和语者模型信息的混合语音分离系统. 该系统在CASA框架下, 利用语者模型信息和因子最大矢量量化(Factorial-max vector quantization, MAXVQ)方法进行实值掩码估计, 实现了两语者混合语音中有效地分离出目标说话人语音的目标, 从而为ASR系统提供了鲁棒的识别前端. 在语音分离挑战(Speech separation challenge, SSC)数据集上的评估表明, 相比基线系统, 本文所提出的系统的语音识别正确率提高了15.68%. 相关的实验结果也验证了本文提出的多语者识别和实值掩码估计的有效性. 相似文献