喷锚网技术在高陡边坡防护中的应用

喷锚网支护可提高高且陡的边坡岩土结构强度和抗变形刚度,增强边坡的整体稳定性.根据公路路段的情况,路堑边坡采用喷锚网支护的形式,针对设计方案、材料要求、施工方法、技术措施,以及现场质量管理和检测问题进行探讨.     

喷射沉积SiCP/Al复合材料及6066铝合金热挤压工艺的研究

作者应用喷射共沉积工艺制备 6 0 6 6 / Si Cp复合材料和 6 0 6 6铝合金锭坯 ,在不同的挤压比、挤压温度下挤压成　　型 ,用金相显微镜观察材料的显微组织 ,并测试了材料的力学性能。结果表明 :Si C/ Al复合材料喷射沉积状态的组织很疏松 ,存在许多的间隙 ,其密度约为理论密度的 86 % ,Si C颗粒在复合材料中分布不均匀 ,喷射沉积铝合金基体的致密度可达 90 % ;挤压过程使 Al/ Si Cp复合材料的大多数空隙消失 ,致密程度随挤压比的增大而增大 ,挤压比超过 14 .7后不会明显变化 ,而铝合金基体的致密程度与挤压比的变化关系不明显 ;挤压温度对材料的致密程度影响不大 ;Al/ Si Cp复合材料性能在挤压比超过 14 .7后变化不大 ;铝合金的性能不受挤压比变化的影响 ;而挤压温度过高使材料性能下降     

Al_(10)Zn_(2.9)Mg_(1.7)Cu超高强铝合金的喷射成形制备研究

采用喷射成形技术制备了Al1 0 Zn2 .9Mg1 .7Cu高强高韧铝合金沉积坯件 ,研究了喷射成形制备过程中各工艺参数对沉积坯件的成形性、显微组织、致密度的影响 ,确定了适当的工艺参数 ,研究了沉积坯件的热挤压及热处理工艺 ,对材料的组织进行了分析并对不同状态的材料性能进行了比较。研究结果表明 :当喷射成形工艺参数合理时 ,沉积坯件具有良好的成形性与致密度 ,在随后的热挤压过程中 ,通过较低的挤压比即可使材料达到全致密 ;通过对合金进行适当的热处理 ,材料的极限抗拉强度达到 810MPa ,同时延伸率保持在 8%～ 11% ,该材料是一种理想的轻质高强结构材料。     

Plasma Sprayed Hydroxyapatite Coatings with Nano-hydroxyapatite Prepared by Ultrasonic Precipitation Process

Nano-particle hydroxyapatite （ HA ） was prepared with a novel ultrasonic precipitation process and the as-prepared nanopowder was used to produce hydroxyapatite （ HA ） coatings on titanium substrate via plasma spraying. The phase and the microstructare of the coating were characterized by X- ray diffraction （XRD） and scanning electron microscopy （SEM）. Results showed that spherical particles could be prepared by ultrasonic precipitation process; and a corresponding dense HA coating with molten surface and low-porosity cross-section structure was acquired. During the plasma spraying process, new phases of Ca3 （ PO4 ）2 and Ca2 P2O7 were generated. After heat-treating at 800℃ for 1 h, the contents of Ca3 （ PO4 ）2 and Ca2 P2O7 decreased while HA content increased. Tensile adhesion tests showed that the plasma sprayed coating prepared with the spherical nanoparticles exhibited high tensile bond strength.     

Wave propagation in two-phase flow of magnetic fluid under a nonuniform magnetic field

The effect of nonuniform magnetic field on the linear and nonlinear wave propagation phenomena in two-phase pipe flow of magnetic fluid is investigated theoretically to realize the effective energy conversion system using boiling two-phase flow of magnetic fluid. Firstly, the governing equations of two-phase flow based on the unsteady thermal nonequilibrium two-fluid model are presented and the linear void wave propagation phenomena in boiling two-phase flow are numerically analyzed by using the finite volume method. Next, the nonlinear pressure wave propagation in gas-liquid two-phase flow is numerically analyzed by using the finite different method. According to these theoretical studies on the wave propagation phenomena in two-phase flow of magnetic fluid, it seems to be a reasonable proposal that the precise control of the wave propagation in two-phase flow is possible by effective use of the magnetic force.     

钠冷快堆中喷雾钠火的计算分析

根据钠冷快堆中喷雾钠火的特点建立了理论模型，编制了SSPRAY程序。该程序模拟钠喷雾燃料过程中钠滴的运动、钠和氧气的燃烧反应、热量传递和质量传递等瞬态过程。用该程序计算了气体和墙壁温度、气体压力、氧气摩尔份额、喷雾流燃烧速率和热量热递速率等主要参数。利用AI实验数据和美国SPRAY－3A的计算结果对程序进行了验证，结果符合较好。     

A novel dynamic survivable routing in WDM optical networks with/without sparse wavelength conversion

In this paper, we study the dynamic survivable routing problem, both in optical networks without wavelength conversion and in optical networks with sparse wavelength conversion, and propose a novel hybrid algorithm for it based on the combination of mobile agents technique and genetic algorithms (GA). By keeping a suitable number of mobile agents in the network to cooperatively explore the network states and continuously report cycles (that are formed by two disjoint-link routes) into the routing tables, our new hybrid algorithm can promptly determine the first population of cycles for a new request based on the routing table of its source node, without the time consuming process associated with current GA-based lightpath protection schemes. We further improve the performance of our algorithm by introducing a more advanced fitness function that is suitable for both the above networks. Extensive simulation studies on the ns-2 network simulator show that our hybrid algorithm achieves a significantly lower blocking probability than the conventional survivable routing algorithms for all the cases we studied.     

一种制备磁性粉末的新技术--均匀颗粒成型法

采用均匀颗粒成型法（Uniform Dropler Spray-UDS）制备Fe基合金粉末，该方法制备的颗粒粒度分布均匀，性能一致，大大优于传统的粉末制备方法（如破碎法、气雾化），具有广阔的应用前景。本文分析了粉末制备过程中颗粒尺寸的影响因素，结果表明：颗粒的大小主要取决于坩埚底部小孔、坩埚内外气体压强差以及振荡频率三个独立变量。     

新增探明储量的经济可采储量计算方法

提出了新增探明储量有无经济可采储量的判别方法。在此基础上，通过对立已开发油田技术可采储量经济转化率与油藏空气渗透率的相关关系式和图版，根据储层的空气渗透率，计算新增探明储量的经济转化率和经济可采储量。该方法参数易取，计算简便，对于快速、准确计算新增探明储量的经济可采储量具有重要意义。     

无差拍控制提高变速异步风力发电系统的故障承受能力

变速风力发电机对于电网扰动、故障以及电网电压跌落非常敏感，当上述情况发生时风力发电机将从电网切除，直到电网恢复正常才能重新投入运行。如何在电网发生扰动时保持风力发电机的正常运行是一个有挑战性的课题。未来的电网规范甚至要求在电网发生故障时风力机组仍能保持运行，这就要求必须安装保证风电机组低电压运行的控制装置。文中针对采用全载换流器与电网进行连接的异步风力发电机组提出了相应的风电机组低电压控制器及控制策略，无须进行硬件改造即可实现电网故障情况下风电机组不退出运行。其中，风电机组电气子系统控制器基于无差拍控制策略进行设计。算例给出了300 kW的风电机组在30%电压跌落情况下的暂态过程，没有加入控制器之前风电机组将停机，加入之后则可以保持运行，验证了所提方法的正确性。