碳/碳复合材料CVI工艺中热解碳形成机理的研究

对碳碳复合材料CVI或（CVD）工艺中热碳组织的类型，沉积机理等研究情况进行了简要的综述，并对其进一步研究提出了相应观点。     

化学镀非晶态Ni—B合金的研究

本文通过化学镀方法在铜和钢上沉积非晶态Ni-B合金。着重讨论了还原剂浓度、络合剂浓度对化学镀沉积速率的影响;分析了它的耐蚀原因和其显微硬度随退火温度的变化情况并就其应用和发展略作说明。     

宝浪油田侏罗系三工河组浅水辫状河三角洲沉积模式研究

焉耆盆地侏罗系三工河组广泛发育由辫状河进积到湖泊中形成的辫状河三角洲。这种三角洲特征显著不同于其它三角洲,其主体是辫状分流河道和水下分流河道。宝浪油田含油层段主体为辫状分流河道,以心滩发育为主要特征,是典型的浅水缓坡粗粒辫状河三角洲沉积。     

生长温度对等离子体增强化学气相沉积生长ZnO薄膜质量的影响

以Zn(C2 H5) 2 和CO2 为反应源 ,在低温下用等离子体增强化学气相沉积方法 ,在Si衬底上外延生长了高质量的ZnO薄膜。用X射线衍射谱和光致发光谱研究了衬底温度对ZnO薄膜质量的影响。X射线衍射结果表明 ,在生长温度为2 3 0℃时制备出了高质量 ( 0 0 0 2 )择优取向的ZnO薄膜 ,其半高宽为 0 2 6°。光致发光谱显示出强的紫外自由激子发射与微弱的与氧空位相关的深缺陷发光 ,表明获得了接近化学配比的ZnO薄膜     

Modification of platinum surfaces by spontaneous deposition: Methanol oxidation electrocatalysis

The presence of a second metal on platinum surfaces affects the performance of methanol oxidation. However, most of the electrocatalytic reactions are studied by using electrochemically deposited platinum alloys, but in the case of spontaneous deposition the situation is not so clear since the surface distribution, stability and morphology are usually not well documented. The formation of surface decorated samples on mono- and poly-crystalline platinum is followed by electrochemical and spectroscopic techniques and analysis of their performance towards methanol adsorption and oxidation compared with that on pure platinum. Pt/Sn and Pt/Ru are of special interest because of their well-known performance in methanol fuel cells. Methanol oxidation on Pt(111)/Ru, Pt(111)/Sn and Pt(111) shows that ruthenium is the only one able to promote the reaction since the simultaneous dissolution of tin occurs and competes with the process of interest. The in situ infrared spectroscopy is used to compare methanol oxidation on Pt(111)/Ru and Pt(111) in acid media using p-polarized light. The formation of bridge bound carbon monoxide is inhibited in the presence of ruthenium ad-species, whereas on Pt(111) the three adsorption configurations are observed. Linear sweep polarization curves and Tafel slopes (calculated from steady state potentiostatic plots) for methanol oxidation are compared on polycrystalline surfaces modified by tin or ruthenium at different coverages. There is almost no change in the Tafel slopes due to the presence of the foreign metal except for Pt/Ru, where a 0.09 V decade⁻¹ slope was calculated below 0.55 V due to hydroxyl adsorbates on ruthenium islands. The anodic stripping of methanol residues on the three surfaces indicates a lower amount of carbon monoxide-type adsorbates on Pt/Ru, and the simultaneous tin dissolution process leading to residues oxidation on Pt/Sn electrodes.     

Formation and electronic structure of interface

In the present work the formation of the interface between polycrystalline silver and thin films of titanium oxide was studied with photoelectron spectroscopy (XPS, UPS) and time-of-flight secondary ion mass spectrometry (TOF-SIMS). Titanium oxide was deposited stepwise on 100 nm thick silver films by reactive magnetron sputtering allowing to study the evolution of the interface formation process. The process involves two steps: formation of thin layer of silver oxide and subsequent growth of the TiO₂ film. For better understanding of the silver oxidation process, pure silver films were exposed to a low temperature Ar/O plasma for different time intervals providing a possibility to investigate early stages of the oxide film growth.     

离子束辅助沉积制备高功率激光薄膜的研究

综述了离子束辅助沉积技术在高功率激光薄膜制备中的应用研究进展.指出该技术在制备高激光损伤阈值的薄膜中存在的问题,即出现过高的堆积密度,会给薄膜带来杂质缺陷、化学计量比缺陷、损伤缺陷、晶界缺陷,制备薄膜的残余应力存在着压应力增加的趋势,会改变薄膜的晶体结构等.并指出了该研究领域的研究方向.     

Electrochemical C-V Characteristics and Photoluminescence of a-C∶N Films

Amorphous carbon (a-C) films and amorphous carbon films incorporating with the nitrogen (a-C∶N) were deposited on silicon substrates in a radio-frequency driven plasma enhanced chemical vapour deposition system, while the surface electrical properties of films were investigated by electrochemical capacitance-voltage measurements. It was examined the effect of the interface defects on the properties and deduced that the conducting type of a-C∶N films was n-type. Subsequently, a comparative studies of a-C and a-C∶N films were performed by photoluminescence spectra depending on the temperature. With the decrease of the temperature, the main band with peak energy of 2.48 eV in the a-C∶N films was more intense compared with the other three bands caused by amorphous C in the a-C films.     

Plasma spraying of nanostructured partially yttria stabilized zirconia powders

Nanosized partially yttria stabilized zirconia particles, prepared using a co-precipitation method, were reprocessed into agglomerate powders using two methods for plasma spraying. The first method was to make micrometer-sized agglomerates directly following the grinding of the calcined yttria–zirconia agglomerates. The second method was to reconstitute the nanosized particles into micrometer agglomerates using spray drying. The deposition efficiency, porosity, microhardness and average grain size of the deposits made from these two reprocessed powders were studied. Distinct results related to the process parameters were obtained for the two types of powders. The second type of powder was more suitable for plasma spraying than the first one. Using the second type of powder, some unique results distinguished from those of the conventional partially yttria stabilized zirconia powders were observed and an optimized coating with a porosity of 3.8%, Hv_0.3 of 953 and mainly consisting of 1–3 μm columnar grains in the columnar direction and smaller than 100 nm in their cross-sections was achieved.