尾煤泥水煤浆高效制浆工艺在临涣选煤厂的应用

分析了临涣选煤厂浮选尾煤的性质及成浆性。为了把高粘性尾煤泥滤饼制备成水煤浆，研制了循环剪切桶和剪切泵。实践证明，浮选尾煤泥可以制备出浓度高、稳定时间长和流变性好的水煤浆。研制的制浆设备结构紧凑、电耗低、效率高。笔者介绍了该设备的结构、工作原理以及制浆生产线。     

淤浆法HDPE装置低聚物不能结片原因探析

分析了淤浆法HDPE装置低聚物不能结片的原因,并提出了相应的工艺处理措施。     

造纸黑液制水煤浆添加剂成浆性能的研究

针对淮化德士古气化炉所用的义马煤和鲁南化肥厂使用的配煤 ,进行了造纸黑液制添加剂实验室和工业制浆性能的考察。结果表明 ,其在工业应用中的添加量范围在 1.2 %～ 1.6 % (浆基 ,添加剂含固量 2 0 % ) ,对义马煤和鲁南配煤分别可以制出浓度在 6 4 .5 %和 6 9%之间 ,稳定性能良好 ,满足工业生产要求的水煤浆     

Rheological studies on a slurry biofuel to aid in evaluating its suitability as a fuel

Biomass is an often abundant, renewable, low ash and low sulfur fuel. Due to these properties, biofuels are promising alternatives for traditional petroleum-based fuel applications; however, traditional biofuels for internal combustion engines are not cost competitive with gasoline, diesel or fuel oils. One method to reduce the cost of biofuels is to use slurry fuels which have a potential lower cost than liquid biofuels due to high conversion efficiencies. Slurry biofuels, such as a mixture of corn and water, could provide a biofuel alternative for diesel engines, pressurized gasifiers and heating oil applications such as burners or gas turbines. Use of these biomass slurries poses important questions about their stability and suitability for practical applications in internal combustion engines and combustors.This work reports rheology data for stable corn-starch water slurries (CSWS) which used a polyacrylic acid thickener to eliminate settling of the slurry and to provide desirable shear-thinning behavior for most of the compositions evaluated. The effect of shear rate on the viscosity of the CSWS was studied using a BOHLIN-controlled stress (CS) rheometer. The well-known Ostwald—de Waele power law and Sisko models for viscosity fit the data. The effect of corn starch content, thickener content and temperature on the viscosity of CSWS was also studied. The favorable shear thinning properties were observed for starch contents up to 45% starch and should aid pumping, injection and spraying. The lower heating values of the slurries, however, are undesirably low.     

Strong dependence on pressure of the performance of a Co/SiO2 catalyst in Fischer–Tropsch slurry reactor synthesis

A 10 wt% Co/SiO₂ catalyst was prepared by the incipient wet-impregnation method and tested in Fischer–Tropsch synthesis in a slurry reactor under conditions approaching industrial practice. The catalyst precursor was investigated by X-ray diffraction (XRD), temperature-programmed reduction (TPR), transmission electron microscopy (TEM) and photoelectron spectroscopy (XPS). The XPS and XRD techniques revealed the presence of a crystalline Co₃O₄ spinel-type phase, while-in addition-TEM and XPS analyses pointed to the formation of another amorphous Co₃O₄ spinel phase, both species interacting weakly with the silica substrate. The influence of total pressure on the conversion, selectivity and stability of the catalyst was studied. Upon increasing the overall pressure from 20 to 40 bar, not only activity increased but also the catalyst are not deactivating. These results are explained in terms of an increase of gases solubility in the solvent, this increment of CO concentration in the liquid phase favours carbonyl species formation and the cobalt particles segregation that implies an increase in the metal surface area.     

水煤浆气化炉的形式和新型气化炉的开发

对目前世界上3种主要的气化炉--德士古(Texaco)水煤浆气化炉、道(Dow)水煤浆气化炉和多喷嘴对置式水煤浆气化炉,从工艺流程到气化炉内流场结构都进行了比较说明,同时分析了各种气化炉的优缺点,在此基础上,结合各种气化炉的优点,自行开发设计了一种新型水煤浆气化炉.后期的冷态和热态数值模拟计算以及实验测试结果表明,该气化炉具有流场分布合理、颗粒平均停留时间长、出口粗煤气有效气成分高等优点.     

Analysis of pentasodium triphosphate hydration kinetics

The present work analyzes the effect of various factors on the hydration of pentasodium triphosphate. The experimental method is based on application of the hydration test. Technical-quality products with different proportions of phase I and phase II have been used. The variables studied are phase I/phase II ratio, initial temperature, particle size, stirring rate and composition of the slurry (presence of hexahydrate crystals and water hardness). The results have been discussed according to a kinetics model that includes a series of stages of a physical nature (dissolution of anhydrous salt and the crystallization of the hexahydrate), as well as of a chemical nature (solvation of the ions in solution). Crystallization of the hexahydrate may be the controlling stage in the process.     

进水塔塔背回填抗震设计优化研究与动态响应分析

为分析塔背不同回填材料与不同回填厚度对进水塔动态响应的影响,建立6种回填材料与4种回填厚度相互组合下的数值试验模型,对进水塔进行动力分析。对比进水塔关键部位的应力与位移发现:回填材料的不同对塔背与回填交界区域应力有一定影响,石渣回填时,此区域应力最大值有很大减小,接触面应力分布状态也发生了变化;回填厚度对塔顶位移的影响不大。根据数值试验的计算结果与分析规律,合理使用石渣回填,设计了一种新的回填型式。此型式下塔背与回填交界区域不在为集中应力发生的部位;接触面最大应力大幅减小,相同部位的应力值减小;大应力区位置向下偏移,且区域变大、变宽,说明新回填型式改善了进水塔结构的应力状态,对其安全很有利。将提出的回填方法应用于某泄洪洞进水塔结构中,对比分析了新回填型式与原回填型式两种情况下此进水塔塔背与回填交界角点应力时程曲线、塔背与回填接触面应力云图与损伤云图。结果表明新回填型式下进水塔与回填接触面的动态响应得到了很大改善,该方法对进水塔结构的抗震与安全具有重要意义,可供类似工程借鉴。     

三种骨灰瓷原料的制备与晶相结构

本实验采用牛、猪、羊三种骨头通过高温煅烧制备骨灰瓷原料。采用XRD和SEM方法表征三种骨灰料的晶相结构和显微结构。实验结果表明 :三种骨灰料经 14 0 0℃煅烧后均存在Ca1 0 (PO4 ) 6(OH) 2 、α -Ca3(PO4 ) 2 种晶相。在 132 0℃煅烧的三种骨灰料中 ,按牛、猪、羊顺序 ,Ca1 0 (PO4 ) 6 (OH) 2 含量分别为 87 2 %、89 1%、71 9% ;β-Ca3(PO4 ) 2 含量最高 ,其可塑性和成瓷性能好 ,从晶相上考虑选择羊骨为较佳的骨灰瓷原料。从白度和透光度上考虑选择牛骨为较佳原料。随着煅烧温度升高 ,三种骨头料的β-Ca3(PO4 ) 2 含量增加 ,羊骨和牛骨中的Ca1 0 (PO4 ) 6 (OH) 2 含量减少 ,而猪骨的Ca1 0(PO4 ) 6 (OH) 2 含量反而增加。因此煅烧温度升高对羊骨和牛骨有利 ,而对猪骨不利     

新型多喷嘴对置式水煤浆气化技术工业化应用

煤气化技术是实现煤炭洁净利用的关键。介绍了新型多喷嘴对置式水煤浆气化炉流场、煤气化机理及其工业化应用概况。通过工业化运行结果表明:该装置气化效率高,交叉流式洗涤冷却水分布器的水均布,气化炉运转平稳,负荷可调节范围大,洗涤、冷却性能好,该技术打破了国外对水煤浆气化技术的垄断。