矩形介质波导阵列的一种新型分析方法

本文将等效介电常数近似分析方法在应用范围和处理方法上进行了一些改进．发展为双等效介电常数近似分析法，然后用它来分析矩形介质波导阵列．推得两个一维周期的耦合特征方程。如果将Macatili方法应用范围扩展用来研究该波导阵列也会得到同样的结果，它们都能在二维平面上较准确地反应出通带和阻带等主要周期特性。     

吸附精制提高催化裂化柴油的安定性

用卸出的催化裂化平衡催化剂对催化裂化柴油进行吸附精制，取得了很好的效果。精制油收率99％以上，其安定性达到了优级轻柴油的标准（沉渣＜2．0mg／100mL，色号≤16）。精制后柴油的胶质下降约1个百分点，对吸附物的组成分析表明，其氮含量是柴油的17倍以上。对精制油的分析表明，吸附精制可明显降低柴油的酸度和碱性氮化物的含量。     

填料萃取塔液泛速度的计算

介绍了三种有代表性的填料萃取塔的液泛速度计算公式，并通过它们用于三种典型的液-液实验体系和两种不同填料的计算结果的比较，对这些公式的适用范围进行了讨论。     

An equation of state for 1,1-difluroethane (HFC 152a)

An equation of state for 1,1-difluoroethane (HFC 152a, CH₃CHF₂) has been developed on the basis of reliable experimental data including PVT, liquid C_p, and saturated-liquid-density data measured by our group. It is a non-dimensionalized virial equation whose functional form is the same as that originally developed for 1,1,1,2-tetrafluoroethane (HFC 134a) in our group. The effective range is for pressures up to 15 MPa, temperatures from 230 to 450 K, and densities to 1000 kg m⁻³. The equation represents reliable PVT measurements within ± 1% in pressure for the superheated vapour and supercritical fluid, while within ±0.5% in density for the compressed liquid. In addition, it should be noted that the equation represents the other essential thermodynamic properties including vapour pressures, saturated-liquid/ vapour densities, isobaric/isochoric specific heats and sound velocity in both the liquid and gaseous phase of HFC 152a.     

磷酸盐激光玻璃中铂颗粒密度与氧化还原平衡关系的研究

用吸收光谱法研究了Ｒ２Ｏ—ＢａＯ—Ｐ２Ｏ５系统磷酸盐激光玻璃中铂颗粒密度与铭的氧化还原平衡的关系。结果表明，玻璃中铂颗粒密度随平衡向右移动而减小；玻璃中平衡随熔炼气氛中氧分压增大、熔炼温度升高而向右移动，当足够大时，铂颗粒不能形成。     

Impact of uncertainties on estimations of heat pump cycle performance

Sensitivity analysis is used to show how uncertainties in basic factors, such as heat transfer, pressure drop, compressor efficiency, and thermophysical properties, influence the result of heat pump cycle performance estimations. By comparing the results of this analysis with uncertainty levels of estimations and experimental determinations, it is established to what extent improvements in accuracy are needed. The investigation was carried out for several different applications and, as working fluids, both pure substances and non-azeotropic mixtures were examined. It was found that evaporation heat transfer and compressor efficiency are two areas where improvements are needed. It is also shown that estimates using very accurate, substance-specific, equations of state differ from those using more general types by up to 1 % for COP and 2% for capacity.     

基于Patel-Teja状态方程的统一粘度模型(Ⅱ)应用于油气藏流体粘度的预测

基于(I)报根据pVT和Tμp图形的相似性和Patel-Teja状态方程建立的预测纯流体气、液相粘度的统一模型,通过引入常规的状态方程参数的混合规则,将其应用于二元轻烃混合物共计1894个数据点及模拟天然气高压粘度的预测,平均相对误差分别为13.78%和16.75%;应用于油藏原油和天然气高压粘度的预测,结果优于现有的有关油气藏流体粘度模型.     

Finances and Well-Being: A Dynamic Equilibrium Model of Resources.

This study of 513 Dutch farmers tested a dynamic equilibrium model of resources (an extension of the conservation of resources theory; S. E. Hobfoll, 1989, 1998, 2001). With structural equation modeling, the advantages of a 3-wave longitudinal design were comprehensively used, such as addressing bidirectional causal effects and within-individual vs. between-individual change. This allowed for a careful analysis of the management function of resources in the stress process. Results showed that well-being had stronger within-person stability than finances. Increased levels of financial problems temporarily increased psychological distress but not self-reported illness. Conversely, farmers with higher stable baselines of psychological distress also had higher baselines of self-reported illness and experienced more negative changes in their financial situation. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

Cooperative Effect Radiation Loss of Optical Pump Solid Laser

1 Introduction For increasing the output energy of laser, the pumping power must be enhanced. But the cooperative effect will arise and cause spontaneous radiation light in laser medium sample when the pumping power is high e- nough without the resonator. The spontaneous radiation light is coherent light between laser and fluorescent. It will compete the upper energy level population with ex- cited radiation, and the loss increase. In solid laser medium, such as Nd∶YAG, the Nd ion densityi…     

Quasi-static and dynamic crushing behaviors of aluminum and steel tubes with a cutout

Tubular members are commonly used as an energy absorber in engineering structures and many such members have a cutout. In this study, the crushing behaviors of tubes with a cutout are characterized and the effects of cutout on the energy absorption capabilities of these tubes are quantified. Systematic parametric studies were carried out to study the effect of material properties, including yield and ultimate strength of material, strain rate effect, location of cutout, tube length and impact speed on the crushing behaviors and energy absorption capacity of aluminum and steel tubes. First, a numerical model was constructed with a commercial explicit finite element code. It will be first proven that the numerical simulation can produce sufficiently accurate results in an economic manner. Subsequently, the crushing behavior of aluminum and steel tubes with a cutout was experimentally characterized and their energy absorption capacity was evaluated in terms of mean crushing force, peak crushing force and specific energy absorption (SEA). Tubes of various lengths with a cutout located at different locations, subject to both quasi-static and dynamic impact loadings were considered. For steel tubes, the numerical simulation investigated the influence of the strain rate effect and variation in strain hardening ratio of the material. Empirical equations describing the mean and peak crushing forces of aluminum and steel tubes with a cutout were developed using linear and nonlinear regression methods applied to the results obtained from the numerical and experimental studies.