New catalyst systems for the polymerization of acetylene

The catalytic activities of WCI₆Ph₄Sn, MoCl₅Ph₄Sn and tetrabenzyltitanium were examined in the polymerization of acetylene. The structure, morphology and electrical conductivity of the doped and non doped polyacetylene were also studied.     

掺杂型尖晶石Li_(1.05)Mg_xMn_(2-x)O_4的合成及性能研究

采用高温固相法制备了尖晶石正极材料L iMxMn2-xO4(X=0.04,0.06,0.08,0.10),并用XRD、SEM、ICP-AES、充放电测试等手段研究了其组成、结构、表观形貌和电化学性能。结果表明:该法制备的尖晶石正极材料L iMxMn2-xO4为单一尖晶石结构,粒径分布均匀,其比容量和循环性能较未掺杂尖晶石L iMn2O4有显著的提高。     

Structure, thermal-stability and reducibility of Si-doped Ce–Zr–O solid solution

The Si-doped Ce–Zr–O solid solutions have been prepared by the reverse microemulsion method. The effects of Si and its content on the structure characters, thermal-stability and reducibility of the Ce–Zr–O solid solution have been studied by N₂ adsorption, XRD, laser Raman (LR), TPR, FT-IR, NMR and XPS methods. The results indicate that, there are the bonds of Si–O–M (Ce or Zr) in the Ce–Zr–Si–O solid solutions, and the presence of Si can increase obviously the surface area, thermal-stability, crystal lattice distortion rate, and reducibility of the solid solution. The surface area of the sample with 20 wt.% Si reaches 153 m² g⁻¹ after being calcined at 900 °C for 6 h. The Ce–Zr–O solid solution with 5.2–10 wt.% Si shows excellent thermal-stability and reducibility.     

金属离子掺杂二氧化钛及水体光催化脱氮研究

采用溶胶-凝胶法制备了掺杂Ce^3＋、La^3＋、Ag^＋、Fe^3＋的TiO2光催化剂，以考察其薄膜和粉体形式对水中无机氮的光催化去除效果和活性．用所制备的催化剂对含氨氮-亚硝酸氮的混合液进行了光催化脱氮研究．本文利用UV—Vis吸收光谱、XRD和TEM对催化剂进行了表征．同时，对影响TiO2光催化效率的因素：如掺杂金属离子的种类、浓度、涂膜层数、反应液中有无Fe^2＋、不锈钢和玻璃载体、反应器的构型等进行了探讨，并对今后的研究进行展望．经过2h紫外光照射反应，实验最佳脱氮效果：金属离子掺杂TiO2薄膜型催化剂总氮去除率在30％左右，金属离子掺杂粉末型催化剂光催化最高总氮去除率可达41．7％．     

催化剂组成对酸-碱交替沉淀法制备铜基甲醇合成催化剂的影响

采用酸-碱交替沉淀法制备了一种新型的低压甲醇合成催化剂。研究了催化剂组成的影响。当Al和Zr含量固定,随着Cu/Zn摩尔比的增加,催化剂活性先升高后下降,当Cu/Zn摩尔比为1时,活性最高。XRD结果表明,Cu/Zn摩尔比为1时制备的催化剂CuO与ZnO组分间相互均匀分散程度最大。Zr较明显地提高催化剂的活性和耐热性,Mn对催化剂的耐热性提高有一定的作用,La和Ce对提高催化剂活性的作用不大。     

Microstructure and shear strength of ZrB2SiC/Ti6Al4V joint by TiCuZrNi with Cu foam

In this paper, brazing behaviors between ZrB₂SiC and Ti6Al4V by Cu foam interlayer were studied. The microstructure, formation mechanism, mechanical property and fracture surface of the joints were systematically studied. The results showed that the phases in the joints were α+β-Ti, TiCu, Ti₂Cu, Cu(s, s), TiC, TiB₂ and Ti₃SiC₂. An optimum shear strength reached up to 435??MPa?at a brazing temperature of 910?°C and holding time of 20?min. Such a shear strength was 90?MPa higher than the one without the Cu foam. The obtained high shear strength of joint was discussed from microstructure and residual stress. With the increase of brazing time, Cu(s,s) gradually disappeared and the content of Ti₂Cu intermetallic compound increased, which was harmful for the joint. Furthermore, the residual stress of joint with Cu foam was calculated to be 324?MPa, lower than the one without Cu foam interlayer.     

尖晶石型锂锰氧化物的掺杂研究及其进展

综述了不同掺杂元素对尖晶石型锂锰氧化物电化学性质的影响。将掺杂元素按其掺入后的作用可以分为改善尖晶石锂锰氧化物循环性能的掺杂元素和提高其比容量的掺杂元素,并对尖晶石型锂锰氧掺杂研究工作进行了评述。     

非金属掺杂的第二代二氧化钛光催化剂研究进展

寻求廉价、环境友好并具有可见光光催化活性的第二代光催化剂将是光催化发展进一步走向实用化的关键。氮掺杂的TIO2是新发现的具有可见光光催化活性的复合光催化剂,非金属掺杂可以使复合物的复合禁带宽度小于TIO2的禁带宽度,从而使TIO2的吸收边向可见光移动。对TIO2的氮、碳、硫、卤素掺杂国内外研究现状进行了系统评述,分析了提高TIO2可见光活性的原因,指出非金属元素特别是氮元素的阴离子掺杂是在不降低紫外光催化活性的基础上实现可见光响应的较好方法。     

Vapor-Phase Alkylation of Toluene with Isopropanol over Mg/Al, Ni/Al and Cu/Al Hydrotalcites (Layered Double Hydroxide)

Vapor-phase isopropylation of toluene has been carried out over Mg/Al, Ni/Al and Cu/Al calcined hydrotalcites (CHTs). Reaction conditions were optimized for alkylation by varying temperature, weight hourly space velocity and reactant mole ratio. Side-chain alkylation is found to be more predominant than ring alkylation over Mg/Al CHT, while Ni/Al and Cu/Al CHTs favored ring alkylation. The main products were isobutylbenzene and cymene. The combined participation of acidic and basic sites of the materials is found to be crucial for both side-chain and ring alkylation of toluene with isopropanol. An X-ray diffraction pattern of the resulting oxide indicates a diffuse MgO structure. The incorporation of small amounts of Al³⁺ to MgO generates new surface Lewis acid--base pair sites.     

锂离子电池正极材料的现状与发展

介绍了锂离子正极材料氧化钴锂、氧化镍锂、氧化锰锂、磷酸铁锂等研究开发和现状,对其特性进行了较为全面的总结。