Continuous precipitation of calcium sulfate dihydrate from waste sulfuric acid and lime

Precipitation of calcium sulfate dihydrate, gypsum, from (i) a pure sulfuric acid/lime suspension and (ii) a waste sulfuric acid/lime suspension in a continuous pilot plant in the temperature range from 40 °C to 80 °C was studied. It was observed that in the case of waste sulfuric acid with a high content of Mg²⁺ and Fe²⁺ ions, several hours after the beginning of the precipitation, partial dissolution of the product and modification of the crystals from needle‐ and plate‐like to agglomerated structures occurred. It is suggested that the secondary changes occur due to the increased concentration of Mg²⁺ and Fe²⁺ ions in the reactor. Below 60 °C, and above 70 °C plate‐like and needle‐like single crystals respectively were formed. The mean size (d₅₀) of the crystals was found to increase with increasing temperature and decrease with the initial concentration of lime. Gypsum produced between 70 °C and 80 °C is suitable for further processing for construction plaster. In a precipitation process with pure sulfuric acid only single perfect needle‐like crystals occurred. Copyright © 2005 Society of Chemical Industry     

Grain Growth Behavior of 5Cr21Mn9Ni4N Steel Micro-Alloyed by Rare Earth

Grain growth behavior of 5Cr21Mn9Ni4NRE steel was experimentally studied at various solid solution treatment temperatures and holding for different times. The experimental results show that the 5Cr21Mn9Ni4NRE steel has the feature of sharp austenite grain coarsening after solid solution treatment at the temperature above 1150 ℃. RE added in the steel has the benefit to restrain grain growth and increase grain growth activation energy.     

LW15-252型SF_6断路器存在的问题和对策

国产SF6断路器已在电力系统中得到了广泛的应用,随着时间的推移,这种断路器存在的问题也逐渐地暴露出来。笔者介绍了LW15-252型SF6断路器在实际运用中存在的问题和采取的对策。     

离散事件系统状态反馈控制的几何理论的进一步拓广

本文研究了定义在状态-事件序列上的谓词的离散事件系统的状态反馈控制问题。离散事件系统的数学模型是自动机。状态反馈与闭环过程的关系及许多基本的几何性质得到了详细的阐明;在这些几何背景下,解决了离散事件系统状态反馈控制的拓广问题,包括关于简单谓词与一般谓词的问题。     

探讨电石法PVC烟气治理方法

分析了电石法PVC生产链中电石炉烟气及电厂烟气二氧化硫的排放情况,指出利用电石炉烟气中的CO合成氨、再将合成氨用于燃煤电厂烟气的"氨法"脱硫是具有较大应用潜力的循环经济产业链。     

解吸塔换热器706C结堵的原因分析及其对环保装置正常运行的影响

本文详细分析了解吸塔换热器结堵的原因和对环保装置正常运行的影响,并针对性地提出了防范和处理措施。     

Structural Changes in Titin and Nebulin Filaments Specific to Calcium Ions at 0.1 mM: Factors of Meat Tenderization During Postmortem Aging

ABSTRACT Postmortem structural changes in titin and nebulin filaments were investigated by incubating isolated myofibrils in a solution containing 0.1 mM calcium ions and various concentrations of a protease inhibitor. The inhibition curves showed 2 abnormal steps with increases in the concentration of leupeptin or calpastatin domain I. While the amounts of unchanged titin and nebulin were constant in the 1st step, the 2nd occurred at higher protease inhibitor concentrations. These facts indicated that excess amounts of leupeptin and calpastatin domain I caused deterioration in titin and nebulin properties, thus interfering with the binding of calcium ions. We concluded that the severance of titin and nebulin filaments in the 1st step were induced by calcium ions at 0.1 mM.     

The Transport Properties of Hot Electrons in a Xenon/Methane Mixture

The results are given of numerical solution of the Boltzmann equation in a binomial approximation in view of elastic and inelastic electron collisions in Xe+CH₄ mixtures and in pure methane. The electron energy distribution functions obtained are used to calculate the electron transport coefficients for E/N values of up to several Townsends, i.e., the drift velocity, mobility, average and characteristic energies, diffusion coefficient. The results of calculation for pure methane fit the available experimental data. A similarity rule is found for the electron transport coefficients in a Xe+CH₄ mixture with different concentrations of methane molecules, which enables one to determine the values of transport coefficients in a mixture with a minor (less than 30 percents) methane content.     

Midplane-symmetry breaking in the flow between two counter-rotating disks

This paper considers the axisymmetric steady flow driven by exact counter rotation of two co-axial disks of finite radius. At the edges of the rotating disks one of three conditions is (typically) imposed: (i) zero velocity, corresponding to a stationary, impermeable, cylindrical shroud (ii) zero normal velocity and zero tangential fluid traction, corresponding to a (confined) free surface and (iii) an edge constraint that is consistent with a similarity solution of von Kármán form. The similarity solution is valid in an infinite geometry and possesses a pitchfork bifurcation that breaks the midplane symmetry at a critical Reynolds number. In this paper, similar bifurcations of the global (finite-domain) flow are sought and comparisons are made between the resulting bifurcation structure and that found for the similarity solution. The aim is to assess the validity of the nonlinear similarity solutions in finite domains and to explore the sensitivity of the solution structure to edge conditions that are implicitly neglected when assuming a self-similar flow. It is found that, whilst the symmetric similarity solution can be quantitatively useful for a range of boundary conditions, the bifurcated structure of the finite-domain flow is rather different for each boundary condition and bears little resemblance to the self-similar flow.     

On a three-dimensional axisymmetric boundary-value problem of nonlinear elastic deformation: Asymptotic solution and exponentially small error

In this paper, we study a three-dimensional axisymmetric boundary-value problem of a slender cylinder composed of a nonlinearly elastic material subjected to an axial force. Starting from the field equations, after a transformation and proper scalings, we identify a small variable and two small parameters, which characterize the present problem. Then, by an approach involving compound series-asymptotic expansions, a nonlinear ODE is derived, which governs the axial strain (the first-term in the series expansion). By imposing the zero radial displacement conditions at two ends, we manage to get the analytical solution of the axial strain, from which all other physical quantities can be deduced and thus the three-dimensional displacement field can be determined. Graphical results are presented, which show that there are two boundary layers near the two ends while the middle part is in a state of almost uniform extension. The asymptotic structure of the analytical solution is derived, which offers clear explanations to the structure of the deformed configuration and shows that the thickness of both boundary layers is of the order of the radius. We also point out the relevance of the present results to the St. Venant’s problem. In particular, we obtain the explicit uniformly-valid exponentially small error term, when the obtained deformed configuration is compared to the configuration of a uniform extension.