Emission of trace toxic metals during pulverized fuel combustion of Czech coals

A study of the trace elements emission (As, Se, Cd, Co, Cr, Cu, Zn, Hg, Tl, Pb, Ni, Sn, Sb, V, Mn and Fe) from pulverized coal combustion has been made at six heating and power stations situated in the Czech Republic. The amount of chlorine in coal has considerable influence on volatilization of some elements such as Zn, Cu, Pb, Hg and Tl, which is explained by the formation of thermodynamically stable compounds of these elements with chlorine. Generally, the affinities for Cl follows the order Tl > Cu > Zn > Pb > Co > Mn > Sn > Hg. The experimental data indicates enrichment of some of the trace toxic elements in the emissions (Cu, Zn, As, Se, Cd, Sn, Sb, Hg and Pb) and good agreement was obtained by thermodynamic equilibrium calculations with a few exceptions. In the case of Fe, Mn, Co, Cr and Sn calculated values are overestimated in the bottom ash and there are zero predicted amounts of these elements in the fly ash. In comparison, the results from experiments show up to 80% of these elements retained in fly ash. This implies that there exist additional steps leading to the enrichment by Fe, Mn, Co, Cr and Sn of small particles. Such mechanisms could include the ejection during devolatilization of small inorganic particles from the coal of bottom ash particles, or disintegration of the char containing these metals to small particles of fly ash. On the other hand, there are slightly overestimated or similar values of relative enrichment factors for As, V, Cu, Cd, Sb, Tl and Pb in the fly ashes and zero predicted values for bottom ashes. Our experimental results show about 5% or less of these elements are retained in bottom ashes, so they probably remain in the bottom ash inside unburned parts of coal. Copyright © 2003 John Wiley & Sons, Ltd.     

大塑性变形制备纳米结构金属

细化晶粒是改善材料性能的有效手段，传统的压力加工技术(如轧制、挤压、拉拔和锻造等)可以细化晶粒(微米量级)。纳米结构金属由于具有很小的晶粒尺寸(20-500nm)和独特的缺陷结构，从而表现出优异的物理—力学性能。大塑性变形(SPD)具有将铸态粗晶金属的晶粒细化到纳米量级的巨大潜力，近年来已引起人们的极大关注。介绍了4种大塑性变形制备纳米结构金属的方法、原理、变形特点及应用，分析了纳米结构金属的强度和超塑性变形特征，以及当前研究中存在的主要问题，并对大塑性变形技术的应用前景进行了展望。     

Electrical/electronic effects of titanium and iron impurities in EFG and FZ solar cell silicon: SPV/EBIC analysis

In this paper results on surface photovoltage (SPV) and electron beam induced conductivity (EBIC) studies of edge-defined film-fed growth (EFG) and floating zone (FZ) silicon solar cell materials (both p-type) are presented. A systematic comparison based on minority carrier diffusion length and carrier recombination is made between: (i) samples contaminated with Ti and/or Fe, (ii) samples gettered by phosphorous diffusion, and (iii) as-received samples. Deep level transient spectroscopy (DLTS) measurements, together with the iron-boron (FeB) pairing kinetics [1] have successfully been used to detect the presence of Fe in the samples. Even though this process is effective in revealing Fe impurities in p-type FZ silicon it is evidently not suitable for Fe identification in p-type EFG silicon. Ti, like Fe, is found to be a prominent lifetime-limiting metallic impurity in both EFG and FZ silicon. Phosphorous diffusion is proven to be an effective external gettering technique for fast-diffusing impurities such as Fe, but not for Ti.     

提高辽河原油重交通道路沥青的质量

辽河油田石化总厂为提高从辽河原油生产重交通道路沥青的质量，对所用的辽河原油中的低凝点环烷基原油经过分储、分输、分炼，对减压蒸馏塔进行改造，控制减压拔出率，对直馏沥青进行轻度氧化，使９０号重交通道路沥青中沥青质的含量大于１０％，蜡含量小于２％，质量达到了国际先进水平。     

黑色金属常温磷化发黑

提出了一种新型黑色金属常温磷化发黑工艺，研究了影响膜层质量的各种因素，结果表明，常温磷化发黑集常温发黑和常温磷化二者的优点，磷化发黑膜层是磷化膜与发黑膜协同生长形成的“共生膜”。黑色金属在10－15℃范围内处理6－10min，可以获得防护和装饰性能优良的磷化发黑膜。     

火烧油层技术在庙5块低渗透稠油油藏中的应用

方法在物理模拟的基础上，利用数值模拟及油藏工程方法，对影响火烧油层的技术参数进行了优选研究，并对影响火驱成败的油藏地质参数、注气参数进行了分析。目的寻找适合庙５块低渗透稠油油藏的开采方法。结果提出了庙５块火驱的最佳开采方式、点火参数及注气参数；庙５块火驱生产后，平均单井日产液由０１ｔ上升到５６ｔ，平均单井日产油由０１ｔ上升到３５ｔ，生产２６ｄ后由于压风机供风不足被迫停止火驱注气；从数模结果看：火驱最终采收率可达３９８％。结论火烧油层是一种潜力很大的稠油开采方法，但其物理、化学反应机理复杂，火烧前缘难以控制；庙５块火驱初期虽然见到了一定的生产效果，但没有取得经济效益     

重Fermi子体系反常比热的理论研究

利用文献中Ｋｏｎｄｏ格子理论模型，研究了重Ｆｅｒｍｉ子体系比热与温度的反常关系。     

新取代苯基荧光酮试剂的合成及其性质的研究Ⅱ．新型取代苯基荧光酮与金属离子显色反应的研究

研究了３，５－二溴－４－氨基苯基荧光酮、３，５－二溴－４－偶氮变色酸等８种苯基荧光酮在酸性介质中与高价金属离子Ｚｒ（Ⅳ）、Ｍｏ（Ⅵ）、Ｗ（Ⅵ）、Ａｌ（Ⅲ）、Ｇａ（Ⅲ）等的显色反应。３，５－位二溴取代的试剂的灵敏度高于未取代的灵敏度，摩尔吸光系数绝大多数在１０５Ｌ·ｍｏｌ－１·ｃｍ－１以上。     

稠油微生物开采矿场试验研究——以克拉玛依油田为例

为了增加开发效益及进一步提高原油采收率,克拉玛依油田优选了混源采油菌组合,采用单井吞吐的生产方式,分两批对21口稠油开发井进行了微生物开采矿场试验。经采油菌作用,作业区的稠油粘度大幅度降低,在停止注蒸汽的情况下,大多数试验井都能达到经济产能,试验得到了较高的投资回报率。结果表明,所选用的采油菌组合对胶质、沥青质含量高的稠油作用效果显著,矿场试验的投资少、见效快、收益高。稠油微生物开采技术值得在克拉玛依油田的稠油开发中加以应用、推广。     

新疆重质混合原油研制高等级道路沥青

对利用新疆重质混合原油生产的减压渣油作为基质沥青制备高等级道路沥青进行了研究。考察了低硫石蜡基原油（A）和含硫环烷-中间基原油（B）的掺炼比对基质沥青四组分组成的影响，减压渣油软化点与基质沥青四组分组成的关系，以及添加剂对改进沥青性质的作用。由此得出原油（B）的合适掺炼量，减压渣油软化点的控制范围和优化的生产工艺条件，调合出了符合GB／T18150—2000和JTGF40—2004要求的高等级道路沥青。