不同磁场作用对AZ31镁合金的凝固组织的影响

镁合金是具有优越性能的金属材料,镁合金的加工是目前国内外正在深入进行研究的新课题.实验发现在镁合金的凝固过程中施加低频或静态磁场都能细化晶粒,但静磁场得到的细化效果要优于低频交流磁场,同时随磁感应强度的增加,静磁场细化晶粒的效果明显提高;在静磁场条件下晶界共晶体组织的厚度明显减小,同时在晶内出现了大量细小块状化合物,这有利于改善镁合金的综合性能.     

低熔融指数聚丙烯的开发生产

总结了开发生产低熔融指数聚丙烯的试验过程与结果，通过优选催化剂、优化操作过程、控制加氢量，生产出质量稳定可靠的熔融指数在0．2～0．5g/l0min之间的低熔融指数聚丙烯．     

纯镁对碳化硼颗粒的常压浸渗

本文研究了纯镁对不同致密度的碳化硼(B₄C)颗粒基片的常压浸渗性;讨论了镁液对B₄C颗粒聚集体常压浸渗的影响因素;提出了浸渗模型。研究表明,纯镁在氩气保护下,800～850℃温度范围保温30min即可浸渗B₄C颗粒聚集体。浸渗深度和宽度随加热温度升高和保温时间延长而增加;常压浸渗的B₄C_P/Mg复合材料具有很高的硬度,B₄C颗粒在基体中分布较均匀。     

J-199热熔胶膜的研制

讨论了不同VA含量不同熔体指数的EVA和各种增粘剂对热熔胶膜耐热性、软化点、剪切强度、拉伸强度、剥离强度等性能的影响。通过采用不同材料试验和配方的筛选，研制出一种90℃剪切强度0．07MPa、拉伸强度0．47MPa、耐热性好、粘接强度高的热熔胶膜，从而拓宽了热熔胶的使用范围。     

钨在铂电极上成核动力学研究

采用循环伏安法和计时电流法研究了钨在ＫＦ－Ｂ２Ｏ３－Ｋ２ＷＯ４（６２－３７－１ｍ／ｏ）熔体中（Ｔ＝７９５℃）铂电极上成核动力学过程。实验结果表明：该过程符合扩散步骤控制的半球形三维晶核连续成核长大的动力学规律。     

铝液夹杂物检测DMIRT－Ⅲ法的试验研究

提出了一种新的铝液夹杂物快速检测方法。导出了该法的检测原理方程。分析并试验研究了影响检测重复性和分辨率的因素。试验选择了较好的检测参数，并获得了较好的检测结果。     

The chloride stress-corrosion cracking behavior of stainless steels under different test methods

Chloride-induced stress-corrosion cracking (SCC) is one of the failure modes of stainless steels. Highly alloyed austenitic stainless steels S32654, S31254, and N08028, and duplex grades S32750 and S31803 possess much improved resistance to SCC compared with S30400 and S31600 steels. With the development of a database, SSData, experimental data collected from calcium chloride tests, autoclave tests, and drop evaporation tests were evaluated. Stress-corrosion cracking data generated by autoclave tests agreed well with the practical service conditions and can be used to discriminate alloys for SCC resistance in sodium chloride solution. Drop evaporation test data can be used in situations where evaporation may occur and cyclic loading may be involved. The SCC resistance of alloys under each method increased with increasing molybdenum equivalent Mo + 0.25Cr + 0.1Ni. For a given alloy, the testing result depends on the stress state and environment; different test methods can give different ranking orders concerning SCC resistance. The performance of duplex stainless steels in a chloride-containing environment at higher temperatures was not as good as expected when dynamic loading was involved.     

新型缆用热熔胶的研制

分析了通信线缆用 YH- 4热熔胶组成原料的性能和作用 ,找出影响耐环境高温性能的主要原因 ,并对新研制出的耐环境高温性能 YH- 5热熔胶作了一些分析和探讨 .     

New polymer syntheses: 59. Homo-and copolyesters of 4-(4′-hydrophenoxy)benzoic acid

The homopolyester of 4-(4′-hydroxyphenoxy)benzoic acid (poly(4-HPBA)), was prepared under two different reaction conditions and compared with a sample provided by another research group. Depending on the synthetic route, different melting points, d.s.c. traces and crystal lattices were found. However, after repeated heating and cooling, one thermodynamically stable modification with a melting point of 370–375°C can be obtained. Copolyesters of 4-hydroxybenzoic acid and 4-(4′-hydroxyphenoxy)benzoic acid were prepared with various molar ratios either in the melt (condensation in bulk) or in solution. These copolyesters were characterized by elemental analyses, ¹H n.m.r. spectroscopy, d.s.c. measurements, wide-angle X-ray scattering measurements at various temperatures, and optical microscopy. Whereas copolyesters prepared in solution do not melt below 500°C, those prepared by polycondensation in bulk show melting points down to approximately 260°C and form a nematic melt.     

炼镁还原罐制造技术的现状与发展

介绍了炼镁还原罐制造技术的发展历程和研究现状，分析了未来的发展趋势与发展方向。