淤浆法HDPE装置低聚物不能结片原因探析

分析了淤浆法HDPE装置低聚物不能结片的原因,并提出了相应的工艺处理措施。     

造纸黑液制水煤浆添加剂成浆性能的研究

针对淮化德士古气化炉所用的义马煤和鲁南化肥厂使用的配煤 ,进行了造纸黑液制添加剂实验室和工业制浆性能的考察。结果表明 ,其在工业应用中的添加量范围在 1.2 %～ 1.6 % (浆基 ,添加剂含固量 2 0 % ) ,对义马煤和鲁南配煤分别可以制出浓度在 6 4 .5 %和 6 9%之间 ,稳定性能良好 ,满足工业生产要求的水煤浆     

Rheological studies on a slurry biofuel to aid in evaluating its suitability as a fuel

Biomass is an often abundant, renewable, low ash and low sulfur fuel. Due to these properties, biofuels are promising alternatives for traditional petroleum-based fuel applications; however, traditional biofuels for internal combustion engines are not cost competitive with gasoline, diesel or fuel oils. One method to reduce the cost of biofuels is to use slurry fuels which have a potential lower cost than liquid biofuels due to high conversion efficiencies. Slurry biofuels, such as a mixture of corn and water, could provide a biofuel alternative for diesel engines, pressurized gasifiers and heating oil applications such as burners or gas turbines. Use of these biomass slurries poses important questions about their stability and suitability for practical applications in internal combustion engines and combustors.This work reports rheology data for stable corn-starch water slurries (CSWS) which used a polyacrylic acid thickener to eliminate settling of the slurry and to provide desirable shear-thinning behavior for most of the compositions evaluated. The effect of shear rate on the viscosity of the CSWS was studied using a BOHLIN-controlled stress (CS) rheometer. The well-known Ostwald—de Waele power law and Sisko models for viscosity fit the data. The effect of corn starch content, thickener content and temperature on the viscosity of CSWS was also studied. The favorable shear thinning properties were observed for starch contents up to 45% starch and should aid pumping, injection and spraying. The lower heating values of the slurries, however, are undesirably low.     

Strong dependence on pressure of the performance of a Co/SiO2 catalyst in Fischer–Tropsch slurry reactor synthesis

A 10 wt% Co/SiO₂ catalyst was prepared by the incipient wet-impregnation method and tested in Fischer–Tropsch synthesis in a slurry reactor under conditions approaching industrial practice. The catalyst precursor was investigated by X-ray diffraction (XRD), temperature-programmed reduction (TPR), transmission electron microscopy (TEM) and photoelectron spectroscopy (XPS). The XPS and XRD techniques revealed the presence of a crystalline Co₃O₄ spinel-type phase, while-in addition-TEM and XPS analyses pointed to the formation of another amorphous Co₃O₄ spinel phase, both species interacting weakly with the silica substrate. The influence of total pressure on the conversion, selectivity and stability of the catalyst was studied. Upon increasing the overall pressure from 20 to 40 bar, not only activity increased but also the catalyst are not deactivating. These results are explained in terms of an increase of gases solubility in the solvent, this increment of CO concentration in the liquid phase favours carbonyl species formation and the cobalt particles segregation that implies an increase in the metal surface area.     

铁电极氰化物电镀过程中的活化现象

采用循环伏安法和恒电流法研究了铁电极在氰化物电解液中的行为,证实了在阴极过程中电极首先极化至铁表面钝态层的还原,实现了表面的活化;随后极化至金属在活化的铁基体上的电沉积过程。     

水煤浆气化炉的形式和新型气化炉的开发

对目前世界上3种主要的气化炉--德士古(Texaco)水煤浆气化炉、道(Dow)水煤浆气化炉和多喷嘴对置式水煤浆气化炉,从工艺流程到气化炉内流场结构都进行了比较说明,同时分析了各种气化炉的优缺点,在此基础上,结合各种气化炉的优点,自行开发设计了一种新型水煤浆气化炉.后期的冷态和热态数值模拟计算以及实验测试结果表明,该气化炉具有流场分布合理、颗粒平均停留时间长、出口粗煤气有效气成分高等优点.     

Analysis of pentasodium triphosphate hydration kinetics

The present work analyzes the effect of various factors on the hydration of pentasodium triphosphate. The experimental method is based on application of the hydration test. Technical-quality products with different proportions of phase I and phase II have been used. The variables studied are phase I/phase II ratio, initial temperature, particle size, stirring rate and composition of the slurry (presence of hexahydrate crystals and water hardness). The results have been discussed according to a kinetics model that includes a series of stages of a physical nature (dissolution of anhydrous salt and the crystallization of the hexahydrate), as well as of a chemical nature (solvation of the ions in solution). Crystallization of the hexahydrate may be the controlling stage in the process.     

结合GIS空间分析的老灌河流域尾矿库溃坝事故模拟预警研究

根据尾矿库溃坝特征,引入泥流水力计算对尾矿库溃坝事故进行计算模拟,并将模拟结果与GIS工具耦合,从空间层面对溃坝事故进程和产生的影响进行动态预测和展示,从而建立尾矿库溃坝事故预警体系,为事故应急工作提供指导。以南水北调中线水源地支流老灌河流域为例,选取流域上下游两个典型尾矿库进行溃坝事故情景模拟,得出上游尾矿库溃坝事故影响范围55km,对该尾矿库下游3~5km处居民区有严重危害,事故影响时间约6~7h;下游尾矿库溃坝事故影响范围13km,主要破坏该尾矿库周边农业资源,事故影响时间约2h。模拟结果在验证本研究实用性的同时,为该流域尾矿库溃坝事故预警应急措施和流域日常安全管理提供决策支持。     

氰化亚铜生产新工艺研究

在氯化钠浓溶液中通氯气将铜氧化生成NaCuCl2，再加入氰化钠溶液生成氰化亚铜沉淀。沉淀经氯化钠浓溶液洗涤和水洗干燥后即得产品。工艺生产周期短，设备简单，成本低，产品质量高，无废气，废渣和有毒废水排放。     

三种骨灰瓷原料的制备与晶相结构

本实验采用牛、猪、羊三种骨头通过高温煅烧制备骨灰瓷原料。采用XRD和SEM方法表征三种骨灰料的晶相结构和显微结构。实验结果表明 :三种骨灰料经 14 0 0℃煅烧后均存在Ca1 0 (PO4 ) 6(OH) 2 、α -Ca3(PO4 ) 2 种晶相。在 132 0℃煅烧的三种骨灰料中 ,按牛、猪、羊顺序 ,Ca1 0 (PO4 ) 6 (OH) 2 含量分别为 87 2 %、89 1%、71 9% ;β-Ca3(PO4 ) 2 含量最高 ,其可塑性和成瓷性能好 ,从晶相上考虑选择羊骨为较佳的骨灰瓷原料。从白度和透光度上考虑选择牛骨为较佳原料。随着煅烧温度升高 ,三种骨头料的β-Ca3(PO4 ) 2 含量增加 ,羊骨和牛骨中的Ca1 0 (PO4 ) 6 (OH) 2 含量减少 ,而猪骨的Ca1 0(PO4 ) 6 (OH) 2 含量反而增加。因此煅烧温度升高对羊骨和牛骨有利 ,而对猪骨不利