尖晶石型纳米钴蓝陶瓷颜料的制备

采用化学共沉淀法作为钴蓝颜料的制备方法,探讨了主要工艺因素对制备钴蓝颜料性能的影响,对制备的样品进行了测试与表征。结果表明:Co2+和Al3+物质的量比为1∶2.5时,制备的钴蓝样品颜色饱和度与明度最高,沉淀剂为尿素时制得的样品的粒度最小,粒度分布比较均匀。前驱体的洗涤过程采取水洗加醇洗的方法可有效减少样品的硬团聚现象,且前驱体的最佳煅烧温度为950℃左右。     

Effect of pH on the Crystallization of Homogeneously Precipitated Nanosized PZT Powder

Nanosized lead zirconate titanate (PZT) powder with Zr:Ti ratio in the morphotropic phase boundary region was synthesized by homogeneous precipitation of metal ions. The powder precipitated at 90°C and at pH 6.7 resulted single-phase perovskite lead zirconate titanate powder when calcined at 550°C and above for 4 hours in air. The solution pH and the precipitation temperature strongly affect the composition of the calcined powder. The results obtained by structural characterization of homogeneously precipitated powder were compared with that obtained from the conventional precipitation method using ammonia in terms of crystallization, homogeneity, and microstructure. The homogeneously precipitated powder showed smaller particle size, minimum agglomeration and uniform shape on calcination and annealing. Powdered samples that precipitated by homogeneous precipitation crystallized directly to perovskite PZT, without any intermediate pyrochlore phase formation. In contrast, the NH₃ precipitated powder converted to perovskite PZT via metastable pyrochlore and it showed phase segregation upon annealing at higher temperatures. The reaction kinetics has been studied by X-ray diffraction, differential thermal analysis, and differential scanning calorimetry.     

NaAlO_2-Al_2(SO_4)_3法制备拟薄水铝石成胶机理的研究

研究了拟薄水铝石和三水氧化铝的生成机理。考察了成胶pH、成胶温度对生成物类型的影响,在此基础上确定了NaAlO2溶液和Al2(SO4)3溶液成胶过程中完全中和时的临界体积比Ψ/Ψ0,在成胶过程中,当Ψ/Ψ0≤1时,NaAlO2溶液与Al2(SO4)3溶液发生中和反应生成拟薄水铝石和/或碱式硫酸铝;当Ψ/Ψ0>1时,过量的NaAlO2溶液发生自发水解反应,生成三水氧化铝。     

高纯超细氧化铝的制备

介绍一种利用氧化铝生产过程的中间物料———铝酸钠溶液 ,生产高纯超细氧化铝的方法 ,即利用钡盐净化铝酸钠溶液 ,得到A/S >10 0 0 0的精制溶液 ,再进行种分分解 ,得到超细Al(OH) 3 ,经过酸洗 ,最终得到纯度达 99 99% ,粒度 90 %小于 2 μm高纯超细氧化铝。     

铜在高纯净钢中析出过程的观察

利用透射电子显微镜观察了铜在高纯净钢中的析出过程，发现早期析出阶段有类B2结构的亚稳相出现，分析了铜在高纯净钢中的析出贯序，研究结果对分析铜在高纯净钢中的时效强化机理具有重要意义。     

奥氏体耐热钢21-4N碳化物析出行为研究

通过对奥氏体耐热钢21-4N碳化物析出行为的研究,探讨了对性能的影响,提出了改善其综合性能的措施和方法.     

微絮凝接触过滤处理低浊度含藻水的研究

通过现场试验，对微絮凝过滤处理生活用水所带来的一系列问题进行了详细、科学的分析，在大量试验数据基础上对产生问题的原因进行了研究并取得了初步结论。在此基础上，提出了改进措施，取得了实效。     

高压热处理对氧沉淀低温形核的影响

研究了外加高压(1GPa)下对450℃热处理硅片中氧沉淀行为的影响.透射电镜观察表明相对于大气压下热处理的样品,高压处理的样品会产生密度更高、尺寸更小的氧沉淀,表明高压有利于小直径氧沉淀的生成.电学性能测试表明,高压下处理的样品其热施主生成浓度和生成速率远远高于常压下处理的样品,这表明热施主与低温热处理过程中生成的高浓度氧沉淀核心有密切的关系.     

Effect of thermomechanical treatment on mechanical properties and electrical conductivity of a CuCrZr alloy

The CuCrZr alloy undergoes processes of precipitation during ageing. Besides precipitation hardening the strength is affected by cold deformation which is performed before and after ageing. The cold deformation (D ₁) before ageing accelerates the process of strength hardening, since it induces higher rate of precipitation from the saturated a-sold solution. Cold deformation (D ₂) after ageing primarily affects the alloy strength. In this paper the results of the effect of thermomechanical treatment on mechanical properties and electrical conductivity of a CuCrZr alloy are presented. The aim of the paper was to evaluate the most suitable combination of thermomechanical treatment and alloy properties.     

原油沥青质沉积引起储集层损害的室内评价

防止沥青质沉积造成的储集层损害是渤海稠油油藏开发生产中遇到的技术难题之一。结合渤海SZ36-1油田实际情况，使用岩心流动实验装置，建立沥青质沉积导致储集层岩心渗透率下降的室内评价方法，并应用SARA法对稠油发生沥青质沉积的可能性进行预测。评价实验结果表明，损害程度与沥青质沉积量和储集层岩心的原始渗透率有关。沉积量越大，原始渗透率越低，则损害越严重。表5参12