Dynamic photorheological analysis of photopolymerizable urethane dimethacrylate resins with varying diluent content and light fluence

The in situ measurement of dynamic changes in viscosity induced by illumination has been performed on a range of photosensitive urethane dimethacrylates (UDMA) evaluating the response at three different illuminations intensities (1, 2, and 5 W cm^?2) and at three different diluent concentrations (15, 30, and 50%), using 1,6‐hexanediol dimethacrylate (HDDMA). The initial viscosity value ranged between 1 and 10 Pa s for the mixtures with final viscosities approaching 1 × 10⁷ Pa s after illumination. The initial rise in viscosity was analyzed using an exponential model with an exponent ranging from 1.0 to 2.5 with time under exposure. Higher conversion rates were observed with both higher intensity and lower HDDMA content. The analytical approach taken here could aid in developing more sophisticated models that consider simultaneous flow and cure advancement in other thermosets. © 2007 Wiley Periodicals, Inc. J Appl Polym Sci, 2008     

KINEMATIC VISCOSITY-TEMPERATURE BEHAVIOR OF HEAVY TBP-FRACTIONS (455°C+) OF ARABIAN CRUDE OILS

A generalized kinematic viscosity-temperature correlation for undefined liquid heavy petroleum fractions has been developed to represent the data for a wide range of temperature from 100°C to 200°C. The correlation is based on the experimental kinematic viscosity data of true boiling point fractions of four Arabian crude oils. The characterization property required for estimation is 50% boiling point. The proposed correlation fits the experimental data with an overall absolute error of 6.1%. Experimental measurements of kinematic viscosity of heavy true boiling point fractions of Arabian crude oils were also obtained in order to develop the proposed correlation.     

植物油、脂肪酸和植物油甲酯在塔河稠油掺稀降黏中的应用评价

稠油由于富含沥青质、胶质等重质组分而具有很高的黏度，给稠油的开采和运输带来了很大的困难。降低稠油黏度进而改善其流动性成为一项十分重要的工作。以植物油、脂肪酸及植物油甲酯为掺稀介质，以塔河油田稠油为研究对象，考察对比了3种不同的掺稀介质对稠油的掺稀降黏效果。研究结果表明，3种掺稀介质对稠油具有良好的掺稀降黏效果，在同一掺稀比下，植物油甲酯对稠油的降黏效果最显著，其次是脂肪酸，再次是植物油。通过斑点试验考察了掺稀介质和稠油的相容性和体系稳定性。结果显示，植物油甲酯与稠油相容性和稳定性最好，脂肪酸和植物油与稠油的相容性和稳定性相对较差。     

Rheological behaviour of processed avocado pulp emulsions

Shear rate vs. shear stress data were obtained on avocado pulp in water emulsions using a concentric cylinder rheometer and fitted to a power law model. Dilution, as volume fraction of water, had a pronounced effect on the apparent viscosity of the pulp emulsions and the Richardson equation, (η_R= exp.( a φ) for the emulsion viscosity fitted the data well. A mean slope coefficient, a , of 4.57 can be used as a first approximation. Enzymatic treatment (40°C, 1 h), is slightly more effective than thermal treatment (65°C, 1 h), in reducing the initial apparent viscosity of the pulp-water emulsions     

High-Pressure (up to 140 MPa) Dynamic Viscosity of the Methane and Toluene System: Measurements and Comparative Study of Some Representative Models

The dynamic viscosity of toluene and methane mixtures containing 25.03, 37.19, 49.95, 64.11, and 95.00 mol% methane has been measured using a falling-body viscometer. The measurements (280 data points) have been performed in the temperature range 293.15 to 373.15 K and at pressures up to 140 MPa. The data have been discussed in the framework of recent representative models (hard-sphere scheme, friction theory, and free-volume model) as well as with simple mixing laws and empirical models (particularly the LBC model and the self-referencing model) used in the literature. This comparative study shows that the average absolute deviation of the models is between 4.9 and 26.8%, and the maximum deviation is between 11.6 and 49.5%.     

OPS和OPC系列稠油乳化降黏剂的研制

以工业品烷基酚聚氧乙烯醚OP-n（n=4,6,8,10,15）为起始原料,合成了烷基酚聚氧乙烯醚乙酸盐OPC-n和磺酸盐OPS-n两个系列的阴-非离子表面活性剂。以酸值和黏度不同的胜利单家寺和陈庄稠油为实验油样。将OPC-n和OPS-n溶于矿化度5811 mg/kg的胜利标准盐水和NaCl、CaCl2盐水中作为水相,按油、水质量比7∶3在50℃用玻棒搅拌混合,观察是否形成水包油乳状液并测黏度进行确认。在胜利标准盐水溶液中,OPC-n和OPS-n乳化稠油所需的最低质量分数,随稠油、表面活性剂类型及氧乙烯链节数n而变,一般而言,OPC-n系列中的OPC-8和OPS-n系列中的OPS-4乳化稠油的性能最好,该最低质量分数值分别为0.05%或0.025%和0.025%。在NaCl盐水溶液中,OPC-n的该最低质量分数值与稠油和n有关,均随盐含量增加而增大,在盐含量≤15%时,抗盐性最好的OPC-8和OPC-10的该值≤0.05%;OPS-n的抗盐性好于OPC-n。OPC-n的抗钙性良好,钙盐含量为2%时该最低质量分数≤0.1%;OPS-n的抗钙性更好,钙盐含量为2%和3%时该最低质量分数仅为0.025%或0.05%。表6参5。     

沥青输送泵的选型计算

液体沥青是铝用阳极的重要原料之一,其不同温度下的密度、粘度特性和流量、扬程等直接决定了沥青泵的选型,本文以具体的铝用阳极生产为例,对沥青输送泵尤其是齿轮泵的参数选取进行了科学的计算与合理的分析。     

A simple correlation for estimating viscosities of solutions of salts in aqueous,non-aqueous and mixed solvents applicable to high concentration,temperature and pressure

A new correlation is proposed to correlate the viscosities of salt solutions in aqueous, non-aqueous solvents and their mixtures. The correlation involves two parameters i.e. solvation number and ion-solvent interaction coefficient, which are well-documented quantities in the literature. The proposed correlation has been examined on the experimental viscosity data of salt solutions in aqueous, non-aqueous and their mixtures up to 473 K and 31 MPa pressure. The salts with various ionic charges were employed for testing the proposed correlation. Several non-aqueous solvents like dimethyl sulphoxide, alcohols and formamide were included for the data regression. The viscosities of these solutions can be correlated to within 0.7%.     

Correlation of high-pressure thermal conductivity,viscosity, and diffusion coefficients for n-alkanes

Thermal conductivity, viscosity, and self-diffusion coefficient data for liquid n-alkanes are satisfactorily correlated simultaneously by a method based on the hard-sphere theory of transport properties. Universal curves are developed for the reduced transport properties ^*, ^*, and D ^* as a function of the reduced volume. A consistent set of equations is derived for the characteristic volume and for the parameters R , R , and R _D, introduced to account for the nonsphericity and roughness of the molecules. The temperature range of the above scheme extends from 110 to 370 K, and the pressure range up to 650 MPa.     

Viscosities of nonelectrolyte liquid mixtures. III. Selected binary and quaternary mixtures

This paper is the final in a series of three viscosity and density studies of pure n-alkanes and selected binary and quaternary mixtures. A standard U-tube viscometer was used for viscosity measurements, and a Pyrex flask-type pycnometer was used for density determinations. Results are given here for pure alkane and selected binary mixtures of n-tetradecane + n-octane, for selected quaternary mixtures of n-hexadecane + n-dodecane + n-decane + n-hexane, and for pure and selected quaternary mixtures of n-hexadecane + n-dodecane + n-nonane + n-heptane at 303.16 and 308.16 K. The principle of congruence was tested, as was the Grunberg and Nissan equation, as they have been shown to be useful as prediction techniques for other n-alkane binary mixtures. Comparisons were made between the two groups of quaternary alkane mixtures and the binary n-tetradecane + n-octane mixtures of the same pseudo composition to understand better the dependence of mixture viscosities on the composition parameter.