Polymer derived ceramic materials from Si,B and MoSiB filler-loaded perhydropolysilazane precursor for oxidation protection

Silica-based coating systems were developed using polymer derived ceramics (PDCs) technology. Ceramic composites on the base of a SiO₂ and SiNO matrix and homogeneously distributed Mo₅SiB₂, SiB₆, Si and B fillers were manufactured. The coating systems have low porosity and provide a high oxidation resistance up to 100 h at 800 °C and 1100 °C in air. The influence of temperature and atmosphere of pyrolysis on the polymer precursor, the volume fraction of filler materials on the chemical composition of compacts as well as their high-temperature oxidation protection was investigated.     

Influence of SiC content on the oxidation of carbon fibre reinforced ZrB2/SiC composites at 1500 and 1650 °C in air

The microstructure and the oxidation resistance in air of continuous carbon fibre reinforced ZrB₂–SiC ceramic composites were investigated. SiC content was varied between 5–20?vol.%, while maintaining fibre content at ～40?vol.%. Short term oxidation tests in air were carried out at 1500 and 1650?°C in a bottom-up loading furnace. The thickness, composition and microstructure of the resulting oxide scale were analysed by SEM-EDS and X-Ray diffraction. The results show that contents above 15?vol.% SiC ensure the formation of a homogeneous protective borosilicate glass that covers the entire sample and minimizes fibre burnout. The scale thickness is ～90?μm for the sample containing 5?vol.% SiC and decreases with increasing SiC content.     

Oxidation of Hastelloy-XR Alloy for Corrosion-Resistant Glass-Coating

The oxidation behavior of Hastelloy-XR alloy was investigated to obtain the optimum surface condition for corrosion-resistant glass-coatings. The surface morphology of oxide scales changed significantly with variation of temperatureand oxygen partial pressure (po2 ). The oxidation kinetics was mainly parabolic independent of oxidation conditions.The oxide scales were consisted of inner Cr2O3 and outer spinel layers. The phase component of spinel layers wereMn1.5Cr1.5O4 and (Mn,Ni)(Cr,Fe)2O4 for the oxygen partial pressures po2<10 kPa and po2>10 kPa, respectively.The optimum oxidation condition to obtain an oxide scale for well-adhered glass-coating to the substrate was 1248 Kand po2 =0.01 kPa for the oxidation time of 43 ks.     

Impact of Reaction Conditions on MnO2 Genesis during Permanganate Oxidation

To enhance the understanding of the behavior and effects of the precipitation of MnO2 particles in the subsurface generated during in situ chemical oxidation (ISCO) using permanganate, laboratory batch experiments were completed to examine the influence that varied reaction matrix conditions have on the generation and properties of manganese oxides. The conditions examined include organic material type and concentration, permanganate concentration, pH, and the presence of calcium (as a representative divalent cation) in solution. Experimental studies included: (1) spectrophotometric examination of permanganate depletion and manganese oxides generation over time during reactions with trichloroethene; (2) scanning electron microscopy analyses of manganese particle morphology; (3) particle size distribution (filtration) characterization studies; and (4) optical particle sizing and numeration studies. Bench-scale, batch experiments were conducted to focus on fundamental chemical properties affecting particle development under varied potential environmental conditions. The amount of manganese oxides particles that develop, grow, and potentially settle as a result of permanganate ISCO of organic contaminants is a function of the particle size and concentration, the time allowed for particle development, and the impact of matrix conditions on the ability of particles to agglomerate.     

Niobium-containing catalysts—the state of the art

This review article is devoted to the materials containing niobium, which have been discovered or developed in the past few years and exhibit the potential application in heterogeneous catalysis. Niobium oxides and mixed oxides as well as sulfides, nitrides (oxynitrides), carbides (oxycarbides), and phosphates are considered. Among the catalytic processes in which Nb-containing materials were tested, liquid and gas phase oxidation is described in details, and the role of niobium in the prevention of the catalyst from SO₂ poisoning is mentioned.     

Effect of the oxide support on the propane ammoxidation with Sb–V–O-based catalysts

The role of Nb₂O₅ and γ-Al₂O₃ oxide supports on the ammoxidation of propane on supported mixed Sb–V oxide at different Sb+V surface coverages is studied. Sb and V oxide species on alumina and on niobia support show different structural features that reflect in different performance during the ammoxidation of propane to acrylonitrile. Niobia-supported catalysts are much more selective to acrylonitrile than alumina-supported ones. Alumina interacts weakly with the supported oxides while niobia forms new phases through solid state reactions with the supported oxides during catalytic operation that must account for its higher selectivity values towards acrylonitrile and higher specific rate of acrylonitrile formation per vanadium site.     

无机高分子絮凝剂聚硫酸铁合成条件的研究

实验研究了以工业硫酸亚铁及废硫酸为原料,分别采用NaClo_3、KClO_3、H_2O_2及(o_2+NaNO_2)为氧化剂成聚硫酸铁的条件。在以(O_2+NaNO_2)为氧化剂的合成过程中,发现添加微量助催化剂(型号为HG-1、HG-2和HG-3),对提高合成速度及反应过程的稳定性具有重大作用。     

Ozonation of Two Acidic Azo Dyes with Different Substituents

The ozonation of two differently substituted azo dyes (Schwarz GRS and Orange Acid 8) in water media is studied. The influence of pH on the effectiveness of the ozonation at various initial concentrations of each dye is explored. It was found out that the rates of decolorization for amino-group substituted dyes reflect the considerable influence by the widely varying initial pH from 4.5 to 10. Specifically, the highest effect of decolorization of this dye was obtained at the highest pH studied (pH 10) for all initial concentrations of the solutions. Considering the dye without an amino-group substitute, the rates of color disappearance in ozonation reflected to a lower degree the variations of the initial pH. Pseudo-first-order trends of decolorization were observed in all the experimental runs. Regarding the kinetic results obtained, an attempt to explain the different dyes reactivity was made based on the absolute electronegativity (E_lumo + E_homo) of both dyes. The COD/BOD analysis shows that the ozonation of both azo dyes can reduce the sample COD but it could not improve the biodegradability ratio (BOD₅/COD). BOD decrease with ozonation time indicates that the intermediates of the ozonation are of lower biodegradability. Oxalic acid was found as the final product of ozonation of both dyes.     

Pretreatment of Highly Polluted Pharmaceutical Waste Broth by Wet Air Oxidation

The preoxidation of a highly polluted waste pharmaceutical fermentation broth using wet air oxidation (WAO) has been studied as a possible method for the effective removal of organics. The applied (pre)treatment method should enhance the biotreatability of the pharmaceutical fermentation broth in terms of reduced initial toxicity and higher biodegradability. Preliminary experiments in the pilot biological treatment plant were successful only at low organic loads, whereas the system collapses at higher ones. The characterization of the fermentation broth was started by common physicochemical analysis, whereas several bioassays were used to determine its impact on biological treatment plants and the environment. Toxicity prior to and after WAO was determined using the acute Vibrio fischeri test, measurement of inhibition of O2 consumption, and the Daphnia magna acute test. Ready biodegradability of the treated and untreated broth has also been assessed. WAO experiments were accomplished in the 2?L batch reactor at different temperatures (240/280°C) and operating pressures. WAO experiments confirmed reduction of the toxicity toward microorganisms, whereas oxidized wastewater was more toxic to daphnids. Biodegradability of the oxidized broth has also been enhanced. Further work has been focused on designing appropriate combination of WAO and biological processes.     

Exchange and oxidation of CO on O-predosed Rh---Al2O3 and Rh---CeO2 catalysts

Exchange and oxidation of C¹⁶O were investigated at 450°C on ¹⁸O-predosed Rh and Pt catalysts supported on A1₂O₃, CeO₂ and CeO₂-Al₂O₃. In all cases, a rapid exchange of C¹⁶O with the surface can be observed. CO oxidation leads to C¹⁶O₂, C¹⁶O¹⁸O and C¹⁸O₂. Significant formation of C¹⁶O₂ is due to the relatively high ¹⁶O coverage in reaction resulting from the C¹⁶O exchange and from an exchange between O surface species and ¹⁶O internal atoms. Hydrogen is also formed via a water-gas shift reaction (CO + surface OH) in higher proportion on CeO₂-containing catalysts than on A1₂O₃. Chlorine inhibits all the reactions (exchange, oxidation and WGS) and particularly the internal exchange.