全文获取类型
收费全文 | 72篇 |
免费 | 5篇 |
国内免费 | 6篇 |
专业分类
电工技术 | 25篇 |
综合类 | 2篇 |
化学工业 | 11篇 |
机械仪表 | 1篇 |
建筑科学 | 5篇 |
矿业工程 | 1篇 |
能源动力 | 1篇 |
轻工业 | 4篇 |
水利工程 | 2篇 |
无线电 | 1篇 |
一般工业技术 | 16篇 |
冶金工业 | 11篇 |
原子能技术 | 1篇 |
自动化技术 | 2篇 |
出版年
2019年 | 3篇 |
2018年 | 1篇 |
2016年 | 1篇 |
2015年 | 3篇 |
2014年 | 1篇 |
2013年 | 3篇 |
2012年 | 1篇 |
2011年 | 1篇 |
2009年 | 7篇 |
2008年 | 3篇 |
2007年 | 5篇 |
2006年 | 6篇 |
2005年 | 9篇 |
2004年 | 4篇 |
2003年 | 5篇 |
2002年 | 11篇 |
2001年 | 3篇 |
2000年 | 2篇 |
1999年 | 1篇 |
1996年 | 3篇 |
1995年 | 5篇 |
1992年 | 1篇 |
1990年 | 1篇 |
1989年 | 1篇 |
1987年 | 1篇 |
1982年 | 1篇 |
排序方式: 共有83条查询结果,搜索用时 312 毫秒
41.
42.
Electrical Properties and Applications of (ZrO2)0.92 (Y2O3)0.08 Electrolyte Thin Wall Tubes Prepared by Improved Slip Casting Method 总被引:2,自引:0,他引:2
8%(mole fraction) yttria-stabilized zirconia electrolyte thin wall tubes were prepared by improved slip casting method. The length and wall thickness of the tubes are 266 mm and 0.4 - 0.9 mm, respectively and the relative density is 96.7 %. The microstructure and electrical properties of samples sintered at different temperatures were studied using SEM and ac impedance spectroscopy. The effect of sintered density, grain and grain boundary on the electrical properties of the samples was analyzed. The research results show that the density of the samples increases gradually with increasing sintering temperatures. The microstructurc of samples strongly influences its electrical properties, and the electrical prop.erties of samples enhance with the increase of sintered density. The ionic conductivity of grain and grain boundary is increased as the sintering temperature increases. Better sinterability of the samples was obtained at the sintering temperature of 1650℃. The maximum open circuit voltage and short circuit current for single cell is 0.946V and 1.84A, respectively. The maximum output power of single cell is 0.46W at the temperature of 850℃. 相似文献
43.
The magnetocaloric effect of LaFe11.7Si1.3 compound was investigated under an external magnetic field up to 9 T.The magnetization changed drastically at the Curie temperature TC under different fields and TC increased with the applied fields.The magnetic entropy change |?SM| vs temperature peak consisted of a spike and a plateau.The spike was a spurious result,while the plateau part resulted from the field-induced itinerant-electron metamagnetic(IEM) transition above TC,which went up with magnetic fields increasing.The width of the magnetic entropy change increased with magnetic fields at a rate of dL?S /dT~4 K/T. 相似文献
44.
45.
利用PEG法合成了粒度约为30nm的处于正交结构的钙钛矿型氧化物La0.7Sr0.3FeO3-δ;通过对此氧化物进行高温后处理得到了立方和菱方结构的同化学计量比氧化物,测量了这三种不同结构样品的XPS谱和Mossbauer谱,并同由固相反应法得到的同样化学计量的正交和立方混相氧化物进行了对比.结果表明Sr3d由处于体相和表面两种状态组成,随粒度的增加,体相含量增加,同时Fe2p3/2亦发生了明显的变化.讨论了Fe电子状态的变化. 相似文献
46.
频率响应分析法只能检测变压器绕组变形故障,而不能实现对局部放电故障的定位.在频率响应分析法的基础上,对变压器绕组的模拟电路进行了分析研究,利用绕组在一定频率范围内呈现纯容性的特性,给出了实现变压器绕组局部放电故障定位的新思路.经仿真计算,验证了这种局部放电故障定位的有效性. 相似文献
47.
带有YSZ保护膜的Bi_2O_3基固体电解质燃料电池的制备及其性能分析 总被引:1,自引:0,他引:1
用带(ZrO_2)_(0.92)(Y_2O_3)_(0.08)(YSZ)保护膜的Bi_2O_3基固体电解质(Bi_20_3)_(0.75)(Y_2O_3)_(0.25)、(Bi_2O_3)_(0.75)-(Gd_2O_3)_(0.25)、(Bi_2O_3)_(0.08)_(0.25)和(MoO_3)_(0.25)做成燃料电池.在600~800℃,将其输出特性与用纯的(ZrO_2)_(0.92)(Y_2O_3)_(0.08)做电解质的燃料电池进行比较.Bi_2O_3基电解质燃料电池的输出功率高于YSZ电解质的,这是由于Bi_20_3基固体电解质具有较高的氧离子导电率;Bi_20_3基电解质燃料电池的开路电压比YSZ的低,是由于Bi_20_3基电解质中存在着一定的电子导电率.从材料的结构、机理上对所得结果进行了分析. 相似文献
48.
采用恒流电泳沉积(EPD)的方法,在NiO-YSZ阳极基底上制备出较为致密的氧化钇稳定的氧化锆(YSZ)固体电解质薄膜,1300℃共烧结5h后得到具有一定厚度的YSZ薄膜。利用SEM对YSZ薄膜的形貌与膜厚进行了表征。在此基础上,以La0.6Sr0.4Co0.2Fe0.8O3(LSCF)为阴极制成单电池,并对单电池的性能及阻抗谱进行了测试,在650℃时得到单电池的最大开路电压为0.84V,单电池在750℃时的最大电流密度为0.64A/cm2,最大功率密度达145mW/cm2;800℃时的短路电流密度接近0.9A/cm2,最大功率密度达200mW/cm2。阻抗谱测试结果表明,电解质部分的电阻占电池内阻的1/4~1/3;电极在-电解质界面处存在的孔洞对电池的性能产生了不利的影响。 相似文献
49.
50.