Associations between indoor CO2 concentrations and sick building syndrome symptoms in U.S. office buildings: an analysis of the 1994-1996 BASE study data

Higher indoor concentrations of air pollutants due, in part, to lower ventilation rates are a potential cause of sick building syndrome (SBS) symptoms in office workers. The indoor carbon dioxide (CO2) concentration is an approximate surrogate for indoor concentrations of other occupant-generated pollutants and for ventilation rate per occupant. Using multivariate logistic regression (MLR) analyses, we evaluated the relationship between indoor CO2 concentrations and SBS symptoms in occupants from a probability sample of 41 U.S. office buildings. Two CO2 metrics were constructed: average workday indoor minus average outdoor CO2 (dCO2, range 6-418 ppm), and maximum indoor 1-h moving average CO2 minus outdoor CO2 concentrations (dCO2MAX). MLR analyses quantified dCO2/SBS symptom associations, adjusting for personal and environmental factors. A dose-response relationship (p < 0.05) with odds ratios per 100 ppm dCO2 ranging from 1.2 to 1.5 for sore throat, nose/sinus, tight chest, and wheezing was observed. The dCO2MAX/SBS regression results were similar.     

Large-scale test of symmetric cold-formed steel (CFS)-concrete composite beams with BTTST enhancement

A new connection device, based on bent-up tab shear transfer enhancement called bent-up triangular tab shear transfer (BTTST), has been studied through a symmetric cold-formed steel (CFS)-concrete composite beam subjected to a static bending test. BTTST provides an alternative connector system unique to CFS where CFS sections are usually thinner than hot-rolled sections and welding of headed-stud shear connectors is inapplicable. Coupled with the back-to-back arrangement of two CFS channels where symmetricity of the built-up section is restored, the resulting composite floor system has been proven to possess adequate strength and stiffness properties under static loads. The work has shown that the predicted values of the flexural capacities calculated using a new equation of shear capacity of BTTST agrees reasonably well with the experimental values.     

Density effects on activated sludge zone settling velocities

A recently developed method to manipulate biomass density based on the addition of synthetic microspheres was used to isolate density effects on zone (hindered) settling velocities in samples from full-scale activated sludge plants over a range biomass densities and concentrations. Settling velocities increased by as much as a factor of five as density was increased by microsphere addition. The effects of density on the Vesilind sedimentation model parameters (V=V(o)e(-kX) , where V is the settling velocity, X is the biomass concentration, and V(o) and k are constants) were evaluated. The parameter V(o) was positively correlated with density for values greater than approximately 1.02 g/mL, while k values were approximately constant in this range. New models were developed for settling velocity as a function of both density and biomass concentration, and these may be useful for future incorporation with clarifier models to improve predictions of system performance, particularly when biomass characteristics known to affect density are variable, such as polyphosphate and nonvolatile suspended solids content.     

Modeling and monitoring of long-term acidification in an upland catchment of the Western Ore Mountains,SE Germany

Modeling and monitoring of acidification patterns in a limed forest catchment in the Ore Mountains, SE Germany are presented. A lumped-parameter model, MAGIC, satisfactorily reproduced the main parameters of stream water chemistry. Despite repeated whole-catchment liming, between 1993 and 1999 stream water pH increased from 4.3 to only 4.6, while calcium concentrations declined slightly. Stream water sulfate concentration declined from 687 to 396 microeq l(-1), and the pronounced effect of deposition decline during the 1990s was probably more important than liming.     

Testing the credit view with pooled data: dynamic links among state bank health, investment-oriented bank loans, and economic performance

This paper focuses on the “credit view” theory at the state level, which suggests that state-level banking sector health influences state-level real economic performance. Specifically, we extend typical analysis of the credit view theory, applying relevant state-level economic variables to consider whether the health of a state’s banking system affects capital investment loans and, in turn, whether growth of these loans affects a state’s economic performance. We develop a two-equation state-level model, use more refined measures of capital investment loans, and apply advanced dynamic pooled estimators to our panel of state data for the 1984–1993 period. Regression results support dynamic links among state bank health, state investment-oriented bank loans, and state economic performance, thus supporting existence of a state-level credit channel effect.

The effect of coal and diesel particulates on the weathering loss of Portland Limestone in an urban environment

Due to reductions in domestic usage, legislation and changes in fuel use, coal derived particulates in the UK urban atmosphere have been significantly reduced. However, a large increase in road usage and an expansion in the use of diesel engines, has meant that the majority of particulates, now present in the urban atmosphere, originate from vehicle exhausts. Particulate matter, resulting from coal combustion, has been recorded as being present in black patinas observed on some historic stone buildings and monuments and has been associated with accelerated weathering of stone surfaces as a result of enhanced gypsum formation. In contrast, the effects of particulates resulting from vehicle exhaust on stone are much less understood. To investigate this, a comparative study was undertaken using the technique of microcatchments under ambient atmospheric conditions. This compared the elemental composition and volume of precipitation runoff from Portland Limestone coated with three different particulate treatments. Treatments consisted of coal and diesel particulates, both separately and in combination. Combining these treatments attempts to investigate any synergistic effects that may occur when coal derived particulates are overlain by layers formed by particulates from more contemporary sources. It was found that diesel-coated samples were much darker in appearance and showed a significant reduction (P<0.05) in the overall rate of weathering loss when compared to untreated samples. Microcatchment runoff volume was reduced from diesel-coated Portland Limestone compared to untreated stone. Enhanced surface temperatures may be increasing the rate of moisture loss from the pore network between rainfall events. Since, generally, the pores must be full before runoff can occur, the reduction may be due to the differential volume of empty pore space between diesel-coated and untreated Portland Limestone.     

Transport of microsporidium Encephalitozoon intestinales spores in sandy porous media

The retention and transport of microsporidium Encephalitozoon intestinales spores in two water-saturated sandy porous media was investigated in this study. The initial breakthrough of the spores in the column effluent occurred essentially simultaneously with that of a non-reactive tracer, indicating no significant velocity enhancement. A large fraction (45-73%) of the spores injected into the columns was not recovered in the effluent, indicating removal from solution through colloid retention processes of attachment and/or straining. The relative significance of attachment and straining to total retention was evaluated in additional experiments. An experiment was conducted with a sieved coarse fraction of porous media for which straining is unlikely to be of significance based on the relative diameters of the spores and porous-medium pores. The spore recovery for this experiment was similar to the recoveries obtained for microsporidia transport in the un-sieved parent porous medium. An additional experiment was conducted with a subsample of the coarse fraction that was acid-washed to reduce potential surface attachment sites. Spore recovery was complete for this experiment. These results suggest surface deposition was the primary removal mechanism in our system. This conclusion is supported by the results of an experiment wherein deionized water was flushed through a column that was previously flushed with electrolyte solution. The effluent spore concentrations were observed to increase upon injection of deionized water, indicating re-mobilization of spores upon a change in water chemistry. The measured data were successfully simulated using a mathematical model incorporating colloid filtration. The results of this study suggest that the transport of microspordia in sandy porous media is governed by established colloid-transport processes.     

Reduction potential of urban PM2.5 mortality risk using modern ventilation systems in buildings

Urban PM2.5 (particulate matter with aerodynamic diameter smaller than 2.5 microm) is associated with excess mortality and other health effects. Stationary sources are regulated and considerable effort is being put into developing low-pollution vehicles and environment-friendly transportation systems. While waiting for technological breakthroughs in emission controls, the current work assesses the exposure reductions achievable by a complementary means: efficient filtration of supply air in buildings. For this purpose infiltration factors for buildings of different ages are quantified using Exposures of Adult Urban Populations in Europe Study (EXPOLIS) measurements of indoor and outdoor concentrations in a population-based probability sample of residential and occupational buildings in Helsinki, Finland. These are entered as inputs into an evaluated simulation model to compare exposures in the current scenario with an alternative scenario, where the distribution of ambient PM2.5 infiltration factors in all residential and occupational buildings are assumed to be similar to the subset of existing occupational buildings using supply air filters. In the alternative scenario exposures to ambient PM2.5 were reduced by 27%. Compared with source controls, a significant additional benefit is that infiltration affects particles from all outdoor sources. The large fraction of time spent indoors makes the reduction larger than what probably can be achieved by local transport policies or other emission controls in the near future. PRACTICAL IMPLICATIONS: It has been suggested that indoor concentrations of ambient particles and the associated health risks can be reduced by using mechanical ventilation systems with supply air filtering in buildings. The current work quantifies the effects of these concentration reductions on population exposures using population-based data from Helsinki and an exposure model. The estimated exposure reductions suggest that correctly defined building codes may reduce annual premature mortality by hundreds in Finland and by tens of thousands in the developed world altogether.     

Detection of the human specific Bacteroides genetic marker provides evidence of widespread sewage contamination of stormwater in the urban environment

Human sewage contamination of surface waters is a major human health concern. We found urban stormwater systems that collect and convey runoff from impervious surfaces act as a conduit for sewage originating from breeches in sanitary sewer infrastructure. A total of 828 samples at 45 stormwater outfalls were collected over a four-year period and assessed by culture based methods, PCR, and quantitative PCR (qPCR) to test for traditional and alternative indicators of fecal pollution. All outfalls had the HF183 (human) Bacteroides genetic marker detected in at least one sample, suggesting sewage contamination is nearly ubiquitous in the urban environment. However, most outfalls were intermittently positive, ranging from detection in 11%-100% of the samples. Positive results did not correlate with seasonality, rainfall amounts, or days since previous rainfall. Approximately two-thirds of the outfalls had high (>5000 copy number, i.e. CN, per 100 ml) or moderate levels (1000-5000 CN per 100 ml) of the human Bacteroides genetic marker. Escherichia coli (E. coli) and enterococci levels did not correlate to human Bacteroides. A total of 66% of all outfall samples had standard fecal indicator levels above 10,000 CFU per 100 ml. A tiered assessment using this benchmark to identify high priority sites would have failed to flag 35% of the samples that had evidence of sewage contamination. In addition, high fecal indicators would have flagged 33% of samples as priority that had low or no evidence of sewage. Enteric virus levels in one outfall with high levels of the human Bacteroides genetic marker were similar to untreated wastewater, which illustrates stormwater can serve as a pathway for pathogen contamination. The major source of fecal pollution at four of five river sites that receive stormwater discharge appeared to be from sewage sources rather than non-human sources based on the ratios of human Bacteroides to total Bacteroides spp. This study shows the feasibility and benefits of employing molecular methods to test for alternative indicators of fecal pollution to identify sewage sources and potential health risks and for prioritization of remediation efforts.