电石渣浆处理及澄清水回收系统工艺改造

通过对乙炔工段电石渣浆系统进行改造与优化,将电石渣浆澄清水全部回收利用,实现了工业废水零排放。节约了水资源,降低了生产成本,取得了显著的环保效益和经济效益。     

脱钾树脂在乙二醇装置中的应用研究

本文主要介绍了"争光"牌CD650在乙二醇装置中的脱钾应用试验情况,从运行出水电导率、pH、UV值等指标看,试验稳定性好,说明争光牌CD650完全可应用在乙二醇装置中代替进口树脂对冷凝水进行脱钾处理,从而能达到冷凝水回收利用和节约水资源的目的.     

80%莠灭净水分散粒剂的配方

采用了挤压造粒的加工工艺对高含量莠灭净固化新剂型WG(水分散粒剂)进行了研制,尤其对该制剂中的润湿剂、悬浮分散剂、粘结剂和崩解剂的种类及用量进行了筛选,并对该制剂的润湿、崩解、悬浮等性能进行了检测,根据试验结果得到了由2%的烷基萘磺酸钠、4%的马来酸-丙烯酸共聚物钠盐、3%的聚乙烯吡咯烷酮、2.5%的可溶淀粉、83.3%的莠灭净原药(含量为96%)和适量膨润土等组成的较佳配方,该产品的悬浮率在90%以上,崩解时间在1min以内,在(54±2)℃下贮存4周后的分解率小于5%,各项性能指标均符合水分散粒剂的要求。     

硫氰酸钠法高吸湿(水)腈纶纺丝工艺及其性能的研究

采用丙烯酸和丙烯腈的共聚物与聚丙烯腈共混纺丝的方法,纺制了丙烯酸改性的聚丙烯腈纤维,研究了纺丝工艺条件与改性腈纶性能之间的关系。实验结果表明:随着共混纺丝所采用的丙烯酸共聚物的共聚比的增加,改性腈纶的断裂强度有所下降,吸湿性和保水性则不断提高;采用低温干燥致密化和较低的总拉伸倍数,有利于提高改性纤维的吸湿和保水性能;随着纤度的增大,改性腈纶的回潮率和保水率渐渐减小。     

脱酮肟型有机硅建筑密封胶的研制

本文介绍了脱酮肟型有机硅建筑密封胶的配制原理、工艺、产品性能及其影响因素     

离子交换膜间水的电离及其应用

本文通过分析纯水的电离,讨论了普通电渗析(ED)和填充床电渗析(EDI)中水的电离现象及其相关 机理。EDI过程中水电离产生的H+和OH-离子可以自再生离子交换树脂。文中简单介绍了已得到产业化的EDI 技术和正在推广中的离子交换树脂的电再生技术。     

硅钢高炉循环冷却水系统的清洗

指出循环水系统清洗的必要性，通过分析垢物数据，清洗系统表面的沉积物，达到清洁系统设备的目的。     

Moisture Distribution and Dewatering Efficiency for Wet Materials

This review paper summarizes current research efforts toward a comprehensive view of wet material dewatering, considering the binding energy as the strength to hold water, and rupture energy given to remove moisture from materials.     

Controlled release of insecticide carbaryl from sodium alginate,sodium alginate/gelatin,and sodium alginate/sodium carboxymethyl cellulose blend beads crosslinked with glutaraldehyde

Interpenetrating network polymeric beads of sodium alginate (NaAlg) and its blend with gelatin (gels) or sodium carboxymethyl cellulose (NaCMC) have been prepared by crosslinking with a common crosslinking agent, glutaraldehyde (GA), for the release of insecticide carbaryl (Carb). The prepared beads were characterized by Fourier transform infrared spectroscopy and scanning electron microscopy. Scanning electron microscopy confirmed the spherical nature and surface morphology of the particles. Bead characteristics, such as carbaryl entrapment efficiency, particle size, equilibrium swelling degree, and carbaryl release kinetics, were determined. The effects of the preparation conditions, such as Carb/NaAlg ratio, time of exposure to GA, blend ratio, and temperature of release medium on the carbaryl release, were investigated for 25 days at 25°C. It was observed that the carbaryl release decreased with increase in crosslinking of network, while it increased with increase in Carb/NaAlg ratio and temperature. The release of carbaryl also increased with increase in Gel or NaCMC content in the blend beads. The highest carbaryl release was found to be 100%, for the beads that were prepared with 1 : 1 NaAlg/Gel at 16 days. The diffusion coefficients have been calculated for the transport of insecticide through the polymeric beads, using initial time approximation method. These values were also consistent with the carbaryl release data. The carbaryl release from most of the bead formulations followed the Fickian trend. © 2005 Wiley Periodicals, Inc. J Appl Polym Sci 99: 1310–1319, 2006     

Hygrothermal aging of rubber‐modified and mineral‐filled dicyandiamide‐cured DGEBA epoxy resin. III. Dielectric spectroscopy investigation

The effects of moisture absorption on the dielectric properties of a rubber‐modified, mineral‐filled, epoxy resin based on the diglycidyl ether of bisphenol A cured with dicyandiamide are reported. Samples of the resin were aged by immersing in deionized water, or 5% w/w NaCl solution, at elevated temperatures. Dielectric measurements were carried out over the frequency range 10^?1 to 6 × 10⁵ Hz. A featureless dielectric spectrum was observed with both real and imaginary dielectric permittivity increasing with the amount of absorbed water. The change in the dielectric properties with absorption of water was independent of presence of salt, temperature of exposure, and aging history, although a hysteresis of the hydration–dehydration process was observed at low frequencies. Two types of absorbed water were observed—water molecularly dispersed within the epoxy matrix and clustered water in spherical microcavities. The time dependence of the real dielectric permittivity measured at 10 kHz was found to closely resemble that of the water absorption, which allowed the activation energy of diffusion to be calculated from both dielectric and gravimetric data. © 2002 Wiley Periodicals, Inc. J Appl Polym Sci 84: 1011–1024, 2002; DOI 10.1002/app.10368