成型温度对PBX装药内部质量及性能的影响

针对压制成型的PBX炸药装药，选择CT无损检测、巴西实验和扫描电镜检测等技术，对比研究了室温和加热两种温度下压制成型的炸药装药内部质量、静态力学性能和细观破坏形式。结果表明，加热压制有利于改善炸药装药的内部质量，可避免产生初始损伤，且提高了装药的力学性能。细观尺度上，室温压制成型的装药主要发生界面脱黏破坏，加热压制成型装药的主要破坏形式是穿晶断裂。     

控制爆破法处理卡钻事故

介绍了在包头市某工程实施管道穿越黄河施工中,采用爆破法处理卡钻的经验。针对深水环境条件及钻杆内径小不宜采用集团装药的条件,确定采用"小直径爆破筒,钻杆内部装药"的爆破方案,阐述了爆破设计及施工注意事项。可供类似工程参考。     

基准平面垂直断面法在爆破漏斗试验中的应用

系统阐述了基准平面垂直断面法在爆破漏斗试验中测量爆破漏斗体积的基本原理,并将隧道激光断面仪应用于金厂河矿1 750 m水平15^#采场底部切割巷道爆破漏斗试验爆破漏斗体积测量中。通过与传统体重法等计算法所得漏斗体积分析比较,结果表明基于隧道激光断面仪与3D Mine软件分析的基准平面垂直断面法实用性强、操作方便、结果直观可靠,达到试验预期目的。     

Dynamic simulation of hydrogen-based off-grid zero energy buildings with hydrogen storage considering Fanger model thermal comfort

In this study, some locations with different climates, off-grid zero energy buildings with hydrogen energy storage systems are designed, and transient analysis is conducted. These considered buildings supply their electricity consumption without using the electrical grid and PV panels or wind turbines. Also, they supply thermal comfort to occupants by using a vapor compression chiller and humidifier. Domestic hot water of occupants is supplied using solar collectors. For analyzing building's performance and objectives achievement, TRNSYS software is used. Also, for evaluating occupant thermal comfort, the Fanger model is used. The considered building is a one-story building with a 150 m² area. Four occupants are considered. Both of them are seated at rest, and another is seated with light working such as typing. Using the Fanger model equation and MATLAB software, the thermal comfort of occupants is determined. For domestic hot water consumption, verified profiles that vary during 24 h of the day are considered. Achieved results show that for humid and cold cities, PV panels with an area of 73 and 76 m² can be supplied the required electricity of considered building with four occupants and battery state of charge is higher than 50% and 10%, respectively. Moreover, with a suitable air conditioner system, the predicted percentage of dissatisfied (PPD) can be lower than 12% and 8% for humid and cold cities. Therefore, the building can be converted to a zero-energy building using its rooftop area.     

Effects of different metal corrosion inhibitors on hydrogen suppression and film formation with Mg–Zn alloy dust in NaCl solutions

To improve the safety of wet dust removal systems for processing magnesium-based alloys, a new method is proposed for preventing hydrogen generation. In this paper, hydrogen generation by Mg–Zn alloy dust was inhibited with six common metal corrosion inhibitors. The results showed that sodium dodecylbenzene sulfonate was the best hydrogen inhibitor, while CeCl₃ enhanced hydrogen precipitation. The film-forming stability of sodium dodecylbenzene sulfonate was tested with different contents, temperatures, Cl^? concentrations and perturbation rates. The results showed that this inhibitor formed stable protective films on the surfaces of Mg–Zn alloy particles, and adsorption followed the Langmuir adsorption model.     

Status and initial experiments of DRAGON-V facility for lithium-lead blanket technologies of hydrogen fusion reactors

A dual-coolant integrated experimental facility named DRAGON-V has been developed at the Institute of Nuclear Energy Safety Technology, Hefei Institute of Physical Science, Chinese Academy of Sciences, for the key technology research and performance evaluation of candidate liquid lithium-lead (PbLi) blanket of hydrogen fusion reactors. The loop is composed of a material test sub-loop and thermal-hydraulic test sub-loop, the design parameters are PbLi inventory 20 tons, PbLi temperature up to 550 °C, the maximum PbLi flow rate up to 40 kg/s. A novel cold trap system is designed to remove the suspended and crystalized impurities in PbLi fluid with three cooling zones and cross row arrangement of rod bundle filter elements. The paper describes the loop itself and its major components, initial loop testing, flow and measurement diagnostics and current experiments. The obtained test results of the loop and its components have demonstrated that the new facility is fully functioning and ready for experimental studies of material corrosion with/without a magnetic field, magnetohydrodynamic (MHD) effect, purification, heat and mass transfer phenomena in PbLi flows and can also be used in mock-up testing in conditions relevant to fusion applications.     

Combining a new baseboard radiator with a fan coil system for improving heating performance and reduce energy consumption

In the present work, the heating performance of a new system combined with a new modified baseboard radiator and fan coil is investigated. Using longitudinal fins with special geometry and also forced airflow at the end of the system causes that at the lower inlet water temperature compared with the conventional models, higher heat output rate be obtained. The heat output rate of the new modified system is obtained by experimental metrology based on the European Standard No. EN-442. Temperature and velocity distribution in the room space is done by simulation of the modified system in the Flovent software. Computational fluid dynamics (CFD) results are validated against experimental results and there is a good agreement between them. Also, the energy consumption of the system during the winter season is calculated in TRANSYS software. Experimental results show that the heat output rate of a new modified heating system with inlet water temperature in the range of 45–55°C is on average 4.17 times higher compared with the conventional model. CFD simulation also showed that the combined system provides good thermal comfort conditions. Energy consumption of the new system reduced about 13% compared with conventional models.     

Reproductive tract disease in Irish grazing dairy cows: Retrospective observational study examining its association with reproductive performance and accuracy of 2 diagnostic tests

The detection of reproductive tract disease (RTD) 3 wk postpartum is important because of its effect on subsequent reproductive outcomes. Numerous methods for the diagnosis of RTD are described, some of which are more practical and instantaneous in terms of diagnosis. Two of these methods involve identification of purulent vaginal discharge (PVD) and evidence of ultrasonographic uterine changes indicative of endometritis (UE). The objectives of our retrospective observational study were (1) to assess the association of PVD or UE score at the prebreeding examination (PBE) with the hazard of pregnancy within the subsequent breeding season; (2) to determine the test sensitivity (Se) and specificity (Sp) at the point of sampling of both tests using a Bayesian latent class model; and (3) to determine the effect of varying positivity thresholds on test accuracy. To achieve these objectives, we analyzed an initial data set of 5,049 PBE from 2,460 spring-calved cows in 8 herds between 2014 and 2018. Each PBE was conducted once between 25 and 86 d in milk. At each PBE, vaginal discharge was obtained with a Metricheck device (Simcro) whereas uterine contents were assessed using transrectal ultrasonography. Purulent vaginal discharge was scored on a scale of 0 to 3 depending on discharge character, and UE was scored on a scale of 0 to 4 depending on the presence and consistency of intraluminal fluid. Cows with scores of ≥2 in either test had received treatment. Fertility data were available from 4,756 PBE after data exclusion. The association between PVD or UE score at the PBE and subsequent hazard of pregnancy was analyzed using a Cox proportional hazards model. Cows with a PVD score of 2 or 3 were less likely to conceive than cows with a PVD score 0 [score 2 hazard ratio (HR) = 0.74; 95% confidence interval (CI): 0.59–0.94; score 3 HR = 0.65; 95% CI: 0.51–0.84]. Cows with a UE score of 1, 2, 3, or 4 were less likely to conceive than cows with a UE score of 0 (score 1 HR = 0.82; 95% CI: 0.73–0.93; score 2 HR = 0.79; 95% CI: 0.62–1.00; score 3 HR = 0.43; 95% CI: 0.43–0.90; score 4 HR = 0.39; 95% CI: 0.26–0.58). To determine the Se and Sp of PVD or UE score for diagnosis of RTD at the time of PBE, a Bayesian latent class model was fitted on 2,460 individual cow PBE. Flat priors were used for the Se and Sp of UE, whereas informative priors were used for PVD Se (mode = 65%, 5th percentile = 45%) and Sp (mode = 90%, 5th percentile = 80%) and RTD prevalence (mode = 20%, 5th percentile = 10%). Posterior estimates (median and 95% Bayesian probability intervals; BPI) were obtained using ‘rjags' (R Studio). The optimal test thresholds (PVD and UE score ≥1) were selected by assessing the effect of different thresholds on test estimates and using a misclassification cost analysis. Based on these, median (95% BPI) Se for PVD and UE score ≥1 were 44% (29–60%) and 67% (33–100%), respectively. Median Sp for PVD and UE score ≥1 were 90% (86–93%) and 91% (86–93%), respectively. Higher scores in both tests were associated with impaired fertility, and UE scoring with a threshold of ≥1 had the highest test Se and Sp estimates although test Se was conditional on days in milk when the PBE occurred.     

“半翻转”教学模式下评价指标体系研究与实践

研究基于“半翻转”教学模式的线上教学评价指标体系,包括课前活动开展、课中教学活动设计、课后任务以及基于此过程中的评价指标体系设计。最后通过层次分析法设计评价指标权重,设计评价算法得到动态评价结果。该评价指标体系应用在本专业“数据结构与算法”课程中,并得到良好的应用效果。     

基于误差估值累加开环校正的诱导式欺骗检测方法

诱导式卫星欺骗干扰可诱导航空器逐渐偏离预定航迹，难以被发现，因此及时有效地检测干扰是飞行安全的保障。在现有紧组合导航体制基础上，设计了一种基于误差估值累加开环校正的紧组合导航结构，并证明了其性能与传统闭环校正紧组合导航性能等效。在此结构中，将紧组合导航系统与自适应序贯概率比检测方法结合，提出了一种基于误差估值累加开环校正的诱导式欺骗检测方法，融合紧组合导航信息与其他不受欺骗影响的导航信息，构建欺骗检测统计量进行诱导式欺骗检测。仿真结果表明，开环校正结构可避免随时间累加的惯性导航系统误差所导致的组合导航滤波器发散问题，同时欺骗检测方法可进一步提高算法对“最坏”情形下微小诱导式欺骗的检测效果。