玉米秸秆衍生碳基固体酸的制备及其催化纤维素水解糖化

以玉米秸秆为原料，通过碳化-磺化法制备了碳基固体酸（CSA），采用XRD、FTIR、XPS、SEM、阳离子交换与返滴定法等手段对其结构形貌进行表征，并考察了制备条件对固体酸表面活性基团含量与催化活性的影响。以NaOH/尿素冻融预处理后的纤维素为底物，研究了CSA催化纤维素水解糖化的效果与条件。结果表明：NaOH/尿素冻融预处理能够有效辅助固体酸催化纤维素水解，在350℃碳化2h、100℃磺化5h条件下制备的CSA催化性能最好，其酸量达3.94mmol/g，其中磺酸基、羧基、酚羟基含量分别为1.09mmol/g、1.36mmol/g、1.49mmol/g。在m(CSA)∶m(纤维素)=3∶1、水解温度200℃、水解时间为0.5h的条件下，纤维素水解还原糖得率与转化率分别为47.1%和63%。CSA循环利用3次催化活性下降不大。本研究可为废弃生物质原料制备的固体酸催化纤维素水解转化利用提供科学参考。     

以氢氧化钾替代氢氧化钠解决漏氯吸收装置碱液冬季结晶技术

针对保定中法供水有限公司原漏氯吸收装置中的中和碱液氢氧化钠,在空气中会吸收二氧化碳生成部分碳酸钠,形成大量结晶物,阻塞管道及泵腔,严重影响漏氯吸收装置运行的问题,找到了氢氧化钠的替代物氢氯化钾。实验结果表明,氢氯化钾在低温时能够有较高的溶解度,在空气中吸收二氧化碳之后生成的新物质,在低温和强碱环境中仍能拥有较高的溶解度,同时仍呈碱性并保持对氯的足够吸收能力。     

阳极氧化钽酸锂薄膜在NaOH溶液中的腐蚀行为研究

通过阳极氧化法在高纯钽片表面制备了钽酸锂复合薄膜,采用浸泡失重法和电化学测试法考察了镀膜前后样品在10% (质量分数) NaOH溶液中的腐蚀行为。利用X射线衍射仪、扫描电子显微镜及能谱仪分别对薄膜的物相组成、表面及截面形貌、膜层厚度进行了测试分析。结果表明,阳极氧化后得到的复合薄膜由钽酸锂和氧化钽组成;该薄膜与基体之间结合良好,厚度约3 μm;镀膜后样品的质量腐蚀速率至少减少了6倍,腐蚀电流密度下降了2个数量级,腐蚀96 h后样品表面没有明显变化。而对比的纯钽样品却发生了严重的腐蚀反应,生成了很多长条状和多棱柱状的腐蚀产物Na₃TaO₄、Na₂Ta₂O₆和Na₈Ta₆O₁₉。     

The surface carboxyl group of carbonaceous microspheres effects on the synthesis and structure of SiOC ceramics

In this study, C/SiOC and C/SiO₂ composites were prepared by using carbonaceous microspheres with different surface functional groups. Carbonaceous microspheres based on hydrothermal reaction of glucose contains hydroxyl group, while the surface carboxyl group increases after NaOH etching. The hydroxyl group increases the oxygen-enriched structural units of SiOC ceramics, and the C spheres are closely enwrapped in SiOC matrix after pyrolysis at 900 °C. However, the interfacial reaction of surface carboxyl with Si–OH results in the formation of cristobalite SiO₂, and C spheres are not only encased inside the SiOC matrix, but also dispersed outside of SiOC ceramics. After removal of C via calcination at 500 °C for 5 h, C/SiOC and C/SiO₂ composites are transformed into amorphous SiO₂ and cristobalite SiO₂, respectively. The thermogravimetric analysis indicates the oxidation resistance of SiOC is superior to that of C and SiO₂.     

氢氧化钠/尿素法和硫酸法测定烟草木质素的对比分析

为了对比氢氧化钠/尿素法(NU法)和硫酸法在测定烟草中木质素含量(质量分数,下同)的差异性,采用NU法和硫酸法测定广东、四川、湖南、云南和贵州5个产区烟梗和烟叶的木质素含量,分析了两种方法在预处理过程的干扰物质去除率及酸解过程木质素含量和结构变化。结果表明:1与硫酸法相比,NU法预处理对干扰物质的去除率更高。2NU法采用稀酸酸解,减少了烟草中木质素的降解;选择在325 nm处测定酸溶木质素(ASL)的紫外吸光度,避免了蛋白质和糠醛对ASL的干扰,提高了烟草木质素测定结果的准确度和重现性。3与硫酸法相比,NU法分离得到的酸不溶木质素(AIL)的氧化程度低、结构变化小,因而更能反映烟草木质素的结构特征。NU法比硫酸法更加适用于烟草木质素的含量测定。     

Enhanced saccharification of corn straw pretreated by alkali combining crude ligninolytic enzymes

BACKGROUND: This work investigated the monokaryogenesis of dikaryon strains of Trametes hirsuta by protoplasts regeneration for extracellular ligninolytic enzyme production. Saccharification of corn straw was enhanced by alkali pretreatment combining crude ligninolytic enzymes. RESULTS: Effectiveness of alkali pretreatment of corn straw on delignification was evaluated under different concentrations. About 45% lignin loss was achieved at the concentration of 1.5% NaOH. In addition, 79.0% sugar yield was obtained after combined pretreatment with NaOH and crude ligninolytic enzyme produced from monokaryotic strains of Trametes hirsuta. Scanning electron microscopy (SEM) images showed that the porosity and surface area increased significantly after combined pretreatment. The FTIR spectra indicated that great intensity changes occurred at the 890–900 cm^?1, 1509–1513 cm^?1 and 1595 cm^?1 bands. CONCLUSION: The proposed combined pretreatment removes lignin and enhances saccharification of corn straw effectively. Copyright © 2012 Society of Chemical Industry     

NaOH/硫脲/尿素预处理对棉纤维TEMPO选择性氧化的影响

采用NaOH/硫脲/尿素体系对棉纤维进行预处理,再进行选择性氧化,可以有效提高氧化棉纤维的羧基生成量。对比研究预处理棉纤维与普通棉纤维经2,2,6,6-四甲基哌啶氮氧自由基(TEMPO)选择性氧化后的羧基含量、纤维形态以及黏度。结果表明,经NaOH/硫脲/尿素体系预处理能够加快氧化反应速率,增加羧基生成量,但对纤维有一定的损伤。其中,羧基生成量随着纤维质量分数的增加呈先增加后减少的趋势,当纤维素质量分数为6%时,羧基生成量最大,棉纤维的可及度和反应性提高。纤维形态分析表明,经NaOH/硫脲/尿素体系预处理的棉纤维润胀溶解程度要大于未预处理的氧化棉纤维;在TEMPO的氧化条件下,氧化棉纤维的相对黏度随着纤维素质量分数增加而增加;当纤维素质量分数较高时,氧化过程中氧化棉纤维的羧基生成量和降解程度都近似于原纤维。     

Reaction mechanism of roasting Zn2SiO4 using NaOH

The reaction kinetics of roasting zinc silicate using NaOH was investigated. The orthogonal test was employed to optimize the reaction conditions and the optimized reaction conditions were as follows: molar ratio of NaOH to Zn₂SiO₄ of 16:1, reaction temperature of 550 °C, and reaction time of 2.5 h. In order to ascertain the phases transformation and reaction processes of zinc oxide and silica, the XRD phase analysis was used to analyze the phases of these specimens roasted at different temperatures. The final phases of the specimen roasted at 600 °C were Na₂ZnO₂, Na₄SiO₄, Na₂ZnSiO₄ and NaOH. The reaction kinetic equation of roasting was determined by the shrinking unreacted core model. Aiming to investigate the reaction mechanism, two control models of reaction rate were applied: chemical reaction at the particle surface and diffusion through the product layer. The results indicated that the diffusion through the product layer model described the reaction process well. The apparent activation energy of the roasting was 19.77 kJ/mol.     

微波联合碱液煤炭脱硫研究

采用微波联合碱液的方法进行煤炭脱硫实验研究,考察了煤炭粒度、碱液浓度、辐照时间、微波功率对脱硫效果的影响,以及脱硫前后煤中矿物质与含硫官能团的变化。结果表明:在所选择的参数范围内,脱硫率随着煤炭粒度的减小而增大,随着碱液浓度、辐照时间、微波功率的增大而增大。XRD分析表明,脱硫后煤中矿物质种类未发生显著变化,但含量明显降低。红外光谱分析表明,脱硫后煤的整体结构未发生显著变化,但含硫官能团吸收峰明显减弱。