Experimental study and model predictions on helium release in an enclosure with single or multiple vents

This paper presents experiments performed at Canadian Nuclear Laboratories (CNL) to examine the dispersion behaviour of helium in a polycarbonate enclosure that was representative of a residential parking garage. The purpose was to gain a better understanding of the effect of buoyancy- or wind-driven natural ventilation on hydrogen dispersion behaviour. Although hydrogen dispersion studies have been reported extensively in the literature, gaps still exist in predictive methods for hazard analysis. Helium, a simulant for hydrogen, was injected near the centre of the floor with a flow rate ranging from 5 to 75 standard litres per minute through an upward-facing nozzle, resulting in an injection Richardson number ranging between 10^?1 and 10². The location of the nozzle varied from the bottom of the enclosure to near the ceiling to examine the impact of the nozzle elevation on the development of a stratified layer in the upper region of the enclosure. When the injection nozzle was placed at a sufficiently low elevation, the vertical helium profile always consisted of a homogenous layer at the top overlaying a stratified layer at the bottom. To simulate outdoor environmental conditions, a fan was placed in front of each vent to examine the effect of opposing or assisting wind on the dispersion. The helium transients in the uniform layer predicted with analytical models were in good agreement with the measured transients for most tests. Model improvements are required for adequately predicting transients with primarily stratified profiles or strong opposing wind.     

Mathematical representation of radiality constraint in distribution system reconfiguration problem

Distribution systems are most commonly operated in a radial configuration for a number of reasons. In order to impose radiality constraint in the optimal network reconfiguration problem, an efficient algorithm is introduced in this paper based on graph theory. The paper shows that the normally followed methods of imposing radiality constraint within a mixed-integer programming formulation of the reconfiguration problem may not be sufficient. The minimum-loss network reconfiguration problem is formulated using different ways to impose radiality constraint. It is shown, through simulations, that the formulated problem using the proposed method for representing radiality constraint can be solved more efficiently, as opposed to the previously proposed formulations. This results in up to 30% reduction in CPU time for the test systems used in this study.     

两阶段领域自适应学习

针对领域自适应问题中源域和目标域的联合分布差异最小化问题,提出两阶段领域自适应学习方法.在第一阶段考虑样本标签和数据结构的判别信息,通过学习一个共享投影变换,使投影后的共享空间中边缘分布的差异最小.第二阶段利用源域标记数据和目标域非标记数据学习一个带结构风险的自适应分类器,不仅能最小化源域和目标域条件分布差异,还能进一步保持源域和目标域边缘分布的流形一致性.在3个基准数据集上的实验表明,文中方法在平均分类准确率和Kappa系数两项评价指标上均表现较优.     

PLC在中低压配电网自动化RTU中的应用

本文介绍了以PLC为主体的中低压配电网自动化中RTU的硬件组成和PCL软件设计。     

Distribution of properties from sampling inhomogeneous materials by line transects

A theory related to the statistics of the structure and properties of inhomogeneous materials has been proposed, dealing with the distribution of properties from sampling of inhomogeneous structures by line transects. It is demonstrated that the empirical cumulative distribution functions of the intercepts from the microstructural constituents and their variances are important fingerprints of the inhomogeneous structures.Simulated sampling of the images of the microstructure by line transects has been proposed as a powerful method for characterization the distribution of properties of inhomogeneous structures. One of the advantages of the method based on the expected values of the order statistics of the intercepts is that the probability bounds of the property are determined without prior knowledge of the functional relationship between the property and the intercepts from the structural constituents.The concept intercept variance has an important application in determining the minimum transect length that stabilizes the variation of the intercept at a low value. Additionally, the concept ‘intercept variance’ can be used for topological optimization of the microstructure regarding the risk of intercepting a large amount of the weaker constituent. Equations regarding the variance of the intercepted fraction characterizing transect lengths with a specified distribution have also been derived.     

Nondestructive evaluation of the characteristics of degraded materials using backward radiated ultrasound

The frequency dependency of Rayleigh surface wave is investigated indirectly by measuring the angular dependency of the backward radiation of the incident ultrasonic wave in two kinds of degraded specimens by scuffing or corrosion. Then, the frequency dependency is compared with the residual stress distribution or the corrosion-fatigue characteristics for the scuffed or corroded specimens, respectively. The width of the backward radiation profile increases with the increase of the variation in residual stress distribution for the scuffed specimens. In the corroded specimens, the profile width decreases with the increase of the effective aging layer thickness and is inversely proportional to the exponent, m, in the Paris’ law that can predict the crack size increase due to fatigue. The result observed in this study demonstrates high potential of backward radiated ultrasound as a tool for nondestructive evaluation of subsurface gradient of material degradation generated by scuffing or corrosion.     

A simplified expression for the hard-sphere dimer fluid radial distribution function

Recently, in our laboratory a closed form expression for the correlation function of the hard-sphere dimer fluid obtained from Wertheims multidensity Ornstein-Zernike integral equation theory with Percus-Yevick approximation was presented by Kim et al. [2001]. However, it is difficult to apply its expression to perturbation theory and vapor-liquid equilibria calculations, since it is of very complex form. In this work, we present a simplified expression for the first shell of the radial distribution function (RDF) of the hard-sphere dimer fluid using a series expansion of the analytical expression. The expansion is carried out in terms of both the packing fraction and the radial distance. Expressions are also obtained for the coordination number and its first and second derivatives as functions of radial distance and packing fraction. These expressions, which are useful in perturbation theory, are simpler to use than those obtained from the starting equation, while giving good agreement with the original expression results. Then we present an simplified equation of state for the square-well dimer fluid of variable well width (λ) based on Barker-Henderson perturbation theory using its expression for the radial distribution function of the hard-sphere dimer fluid, and test its expression with NVT and Gibbs ensemble Monte Carlo simulation data [Kim et al., 2001].     

烃氧化产物皂化后活性组分在油、水相的分配

用强酸酸化后测定乙醚抽出物酸量和酯量、溴甲酚绿两相滴定测定羧酸盐等方法研究了烃氧化产物皂化后活性组分在油、水相的分配。结果表明,在现行的用NaOH皂化烃氧化产物以制备水溶性石油磺酸盐的过程中有相当多的活性组分分配到油相;在水相和油相中均有大量羧酸酯存在,羧酸酯量远远超过羧酸盐量。     

Directional features in online handwriting recognition

The selection of valuable features is crucial in pattern recognition. In this paper we deal with the issue that part of features originate from directional instead of common linear data. Both for directional and linear data a theory for a statistical modeling exists. However, none of these theories gives an integrated solution to problems, where linear and directional variables are to be combined in a single, multivariate probability density function. We describe a general approach for a unified statistical modeling, given the constraint that variances of the circular variables are small. The method is practically evaluated in the context of our online handwriting recognition system frog on hand and the so-called tangent slope angle feature. Recognition results are compared with two alternative modeling approaches. The proposed solution gives significant improvements in recognition accuracy, computational speed and memory requirements.     

应用时频表示进行结构时变模态频率辨识

本文应用线性和二次时频表示的方法，包括：线性时频分析方法短时傅里叶变换和二次时频表示魏格纳－维尔分布，进行了时变结构模态频率的辨识。通过对刚度连续变化的二自由度系统时变模态频率辨识的仿真，论述了两种时频辨识方法的特点。仿真结果表明时频变换辨识方法是辨识时变模态频率的有效工具，魏格纳－维尔分布二次时频表示能够是到比基于短时傅里叶变换的谱图更好的辨识结果。