超宽带大功率合成器设计北大核心CSCD

在80 MHz~1 GHz频段,单个功率管输出功率能达到100 W以上,为研制输出功率400 W的功率放大器,文中设计了四路功率合成器。该合成器需要实现功率容量大、工作频带宽、体积小的设计目标。在功率容量方面,文中采用悬置带状线结构,其功率容量远远大于微带线结构;在工作频带方面,采用切比雪夫九节阻抗变换器,将工作带宽拓宽为80 MHz~1 GHz;在体积方面,文中合成器的功率合成部分采用Y型节级联实现四路功率合成,阻抗变换部分采用切比雪夫阻抗变换器进行阻抗变换,该结构相较于磁环巴伦功率合成器,不但具有损耗小、平坦度高的优点,而且通过将阻抗变换器设计成曲折的形状,进一步缩小了合成器体积。仿真与实测结果显示该合成器在80 MHz~1 GHz范围内还具有较高的平坦度,合成效率可达90%以上。     

Designed damping controller for SSSC to improve stability of a hybrid offshore wind farms considering time delay

This paper presents the stability improvement results of hybrid doubly fed induction generator (DFIG)-based and permanent magnet generator (PMG)-based offshore wind farms (OWFs) using a static synchronous series compensator (SSSC). An adaptive-network-based fuzzy inference system (ANFIS) controller of the proposed SSSC is designed to render adequate damping characteristics to the studied system. A frequency-domain approach based on a linearized system model using eigenvalue technique analysis is performed. A time-domain scheme based on a nonlinear system model subject to a three-phase short circuit fault at infinite bus with variations in the signal transmission delays has also been investigated to compare the damping of the studied system in cases of with and without controller. The simulation results with MATLAB/SIMULINK toolbox have been presented. It can be concluded from the simulation results that the proposed SSSC joined with the designed ANFIS damping controller can offer adequate damping performance to the studied hybrid DFIG-based and PMG-based OWFs under severe disturbance.     

Stress distribution in thick-walled cylinder due to non-uniform radial pressure on the example of reinforcement corrosion in concrete

This paper presents an analytical solution to the non-uniform pressure on thick-walled cylinder. The formulation is based on the linear elasticity theory (plain strain) and stress function method. As an example, the proposed solution is used to model the stress distribution due to non-uniform steel reinforcement corrosion in concrete. The model is formulated considering different scenarios of corrosion pressure distribution. It is validated against the finite element model for different cases of non-uniform pressure distributions. The results show that the corrosion-induced cracks are likely to start just beyond the anodic zone. This is confirmed by the experimental tests on concrete cylinder exposed to non-uniform accelerated corrosion of steel reinforcement. The model can be effectively used to calculate the distribution of corrosion-induced stresses in concrete.     

Operational time-series data modeling via LSTM network integrating principal component analysis based on human experience

Today’s information technologies involve increasingly intelligent systems, which come at the cost of increasingly complex equipment. Modern monitoring systems collect multi-measuring-point and long-term data which make equipment health prediction a “big data” problem. It is difficult to extract information from such condition monitoring data to accurately estimate or predict health statuses. Deep learning is a powerful tool for big data processing that is widely utilized in image and speech recognition applications, and can also provide effective predictions in industrial processes. This paper proposes the Long Short-term Memory Integrating Principal Component Analysis based on Human Experience (HEPCA-LSTM), which uses operational time-series data for equipment health prognostics. Principal component analysis based on human experience is first conducted to extract condition parameters from the condition monitoring system. The long short-term memory (LSTM) framework is then constructed to predict the target status. Finally, a dynamic update of the prediction model with incoming data is performed at a certain interval to prevent any model misalignment caused by the drifting of relevant variables. The proposed model is validated on a practical case and found to outperform other prediction methods. It utilizes a powerful deep learning analysis method, the LSTM, to fully process big condition monitoring series data; it effectively extracts the features involved with human experience and takes dynamic updates into consideration.     

Detection of correlation characteristics between financial time series based on multi-resolution analysis

Interactions between financial time series are complex and changeable in both time and frequency domains. To reveal the evolution characteristics of the time-varying relations between bivariate time series from a multi-resolution perspective, this study introduces an approach combining wavelet analysis and complex networks. In addition, to reduce the influence the phase lag between the time series has on the correlations, we propose dynamic time-warping (DTW) correlation coefficients to reflect the correlation degree between bivariate time series. Unlike previous studies that symbolized the time series only based on the correlation strength, the second-level symbol is set according to the correlation length during the coarse-graining process. This study presents a novel method to analyze bivariate time series and provides more information for investors and decision makers when investing in the stock market. We choose the closing prices of two stocks in China’s market as the sample and explore the evolutionary behavior of correlation modes from different resolutions. Furthermore, we perform experiments to discover the critical correlation modes between the bull market and the bear market on the high-resolution scale, the clustering effect during the financial crisis on the middle-resolution scale, and the potential pseudo period on the low-resolution scale. The experimental results exactly match reality, which provides powerful evidence to prove that our method is effective in financial time series analysis.     

傅立叶级数模拟计算与仿真的实现

根据积分的近似计算模型，结合计算机语言建模与程序编写的方法，用计算机程序模拟计算周期信号的傅立叶级数，并应用Matlab实现仿真。这种模拟计算与仿真使得复杂的数学计算问题可视化、简单化。     

一种单相串联混合电力有源滤波器的研究

文中对串联混合电力滤波器抑制谐波的原理进行了分析。为了检测单项系统的谐波电流,提出一种基于虚拟三相法和瞬时无功理论的谐波检测方法,并且对串联滤波逆变器的直流侧电压的控制进行了讨论。仿真结果证明了其有效性。     

一种多用户波束优化设计的分析与仿真

智能天线技术可以在提高移动通信服务容量和质量的同时而不占用更多的频谱资源。文中就一种利用切比雪夫天线阵来实现智能天线下行波束的优化设计进行了详细分析和仿真。理论分析和仿真结果表明，与其它方法相比，该方法具有空间分辨率高，同信道干扰可控，且计算量小，鲁棒性好，用户波束个数不受阵元个数限制的优点。     

宝浪油田宝北区块低渗透油藏层系优化研究

针对宝浪油田宝北区块低孔低渗油藏地质特征以及油层层数多、分布井段长、部分零散层动用难度大等问题 ,研究了宝北区有效厚度、油层层数、单井产能及单井控制地质储量等层系划分与组合的技术经济界限 ,并在此基础上进行了宝北区层系划分与组合优化论证 ,最终优选出宝北区开发层系     

声光效应拉曼-内斯方程矩阵级数解法及声光调制器优化设计

提出一种求解正常声光相互作用拉曼 内斯 (Raman Nath)方程的矩阵级数解法 ,该解法直观方便且具有普遍性。计算结果表明 ,对Q =4 1π ,Bragg衍射的效率只有 97 5 % ;对非对称入射 ,以往的Raman Nath近似解误差较大 ;指出提高Bragg衍射效率的有效途径在于提高声光频率比并给出计算声光器件最优长度的计算公式。