Comparison of activities in selective catalytic reduction of NOx by C3H8 over Co/MFI, Fe/MFI, and H/MFI zeolite catalysts

The Co/MFI(SiO₂/Al₂O₃ = 30) were prepared by a precipitation method with NaOCl in alkali solutions exhibited high activities to N₂ at 250 °C for the selective catalytic reduction (SCR) of NO_x. These catalysts showed two UV–vis bands at 700 and 400 nm, indicating the presence of octahedral Co(III) as well as tetrahedral Co(II). The high SCR activity over such Co(III, II)/MFI(30) seems to come from Co(III)---O moieties. The Co(II)MFI(30) catalysts prepared from Co(II)Cl₂ exhibited low SCR activities due to the presence of tetrahedral Co(II) ions in MFI. Less CO formation occurred over Co/MFI catalysts. The Fe/MFI(30) catalyst exhibited high activity due to the presence of some Fe---O species in MFI but more amount of CO were produced during SCR. H/MFI(30) catalyst exhibited a good SCR activity. However, more amount of carbonaceous deposits were produced on it. The correlation between acid concentration and SCR activity was discussed over H/MFIs.     

Resistive superconducting transition of κ-type BEDT-TTF organic superconductors in a magnetic field

The superconducting transition of the organic compoundsκ-(BEDT-TTF)₂ X is studied by resistive measurement in a magnetic field up to 10 T applied normal to the conducting plane. For the salts withX=Cu[N(CN)₂]Br andX=CuCN[N(CN)₂] the transition shows fanshaped broadening caused by superconductivity fluctuation. For theX=Cu(NCS)₂ salt the resistivity shows a peak in the transition region in a magnetic field below 4 T.This phenomenon is suppressed in defect-reduced samples for intralayer conduction. We discuss this peak in relation to the thermal fluctuation on the Josephson junction structures in this salt.     

A 1.5-V full-swing BiCMOS logic circuit

A BiCMOS logic circuit applicable to sub-2-V digital circuits has been developed. A transiently saturated full-swing BiCMOS (TS-FS-BiCMOS) logic circuit operates twice as fast as CMOS at 1.5-V supply. A newly developed transient-saturation technique, with which bipolar transistors saturate only during switching periods, is the key to sub-2-V operation because a high-speed full-swing operation is achieved to remove the voltage loss due to the base-emitter turn-on voltage. Both small load dependence and small fan-in dependence of gate delay time are attained with this technique. A two-input gate fabricated with 0.3-μm BiCMOS technology verifies the performance advantage of TS-FS-BiCMOS over other BiCMOS circuits and CMOS at sub 2-V supply     

Development of a new advanced process for manufacturing polyacetal resins. Part III. End-capping during polymerization for manufacturing acetal homopolymer and copolymer

Conventionally, acetal homopolymer or copolymer is obtained by the polymerization of formaldehyde or trioxane, following the end-capping using acetic anhydride or unzipping of the unstable polymer end fraction. First, Asahi Chemical developed a new process to obtain an end-capped polymer during polymerization of highly purified formaldehyde using acetic anhydride as the chain-transfer agent. Use of highly purified formaldehyde and endcapping during polymerization using acetic anhydride as a chain-transfer agent or an endcapping agent will provide a simple process for manufacturing acetal homopolymer. The polymerization mechanism was confirmed by infrared spectroscopy analysis and proton NMR analysis of the polymer obtained. Second, for the acetal copolymer, purified trioxane was copolymerized with ethylene oxide in the presence of methylal, which gave an endcapped polymer with high thermal stability. Two new intermediates from the initiation reaction of the copolymerization, 1,3,5,7-tetraoxacyclononane (TOCN) and 1,3,5,7,10-pentaoxacyclododecane (POCD), were isolated and a new initiation mechanism was proposed. © 1993 John Wiley & Sons, Inc.     

Role of conserved Asn-Tyr-Asp-Tyr sequence in bacterial copper/2,4, 5-trihydroxyphenylalanyl quinone-containing histamine oxidase

Copper amine oxidase contains a covalently bound quinonoid cofactor, 2,4,5-trihydroxyphenylalanyl quinone (TPQ), which is synthesized by post-translational modification of a specific tyrosyl residue occurring in the highly conserved sequence, Asn-Tyr-(Asp/Glu)-Tyr. To elucidate the role(s) of the conserved sequence in the biogenesis of TPQ, each of the corresponding residues at positions 401-404 in the recombinant histamine oxidase from Arthrobacter globiformis has been replaced with other amino acids by site-directed mutagenesis. When Asn-401 was changed to Asp or Gln, the rate of TPQ formation by copper-dependent self-processing was 10(3)- to 10(4)-fold slower than in the wild-type enzyme. When Tyr-402 was replaced by Phe, TPQ was not formed at all, showing that Tyr-402 is essential as the precursor to TPQ. In contrast, Asp-403 could be replaced by Glu without changes in the rate of TPQ formation, whereas its replacement by Asn led to a marked decrease. Furthermore, when Tyr-404 was changed to Phe, TPQ was formed swiftly on incubation with copper ions, but the TPQ enzyme exhibited very low activity with altered substrate specificity. These results collectively indicate that a very rigorous structural motif is required for efficient formation of TPQ and for the catalytic activity in the active site of copper amine oxidases.     

The role of repeat transurethral resection in stage A1 carcinoma of the prostate

In order to evaluate the significance of repeat transurethral resection (TUR) in differentiating stage A1 prostatic adenocarcinoma from those with stage A2, we performed repeat TUR in 34 patients with an initial diagnosis of stage A1 prostatic adenocarcinoma. It was found that residual adenocarcinoma was present in five cases (14.7%), but the diagnosis was changed from stage A1 to stage A2 in only one case (2.9%). In one patient with final diagnosis of stage A1 carcinoma, bone metastases were detected seven months after the repeat TUR. It was concluded that repeat TUR for stage A1 prostatic adenocarcinoma did not yield clinically significant information.     

Numerical analysis of wave-type heat transfer propagating in a thin foil irradiated by short-pulsed laser

This paper presents a numerical simulation of wave-type heat transfer phenomena propagating in an aluminum thin foil irradiated by a pulsed laser using the cubic interpolated propagation method coupled with a thermo-convective model. We did not use the two-step model and dual-phase lag model, which are generally known as the non-Fourier heat conduction law, but wave-type heat transfer phenomena could be observed by our method. The main characteristic of the method is to solve the governing equation including the equation of continuity, the equation of motion, the equation of energy and the equation of state. It is found that when the pulse duration is under the order of picosecond, the pure heat conduction is hardly observed and heat transfer toward the inside of materials occurs only by a thermal shock wave. The heat conduction mode after pulse laser irradiation is strongly dependent upon the value of total incident laser energy density E_in and the threshold value for pure heat conduction is 5.0 × 10⁴ J/m² for an aluminum.     

Carrying capacity and vulnerability of four Asian lakes: A comparative study

To present axes for evaluating the water resources, lake environment and water use in a lake and its watershed, a comparative study was done for four East Asian lakes; lake Kasumigaura (Japan), Lake Laguna (Philippines), Lake Songkhla (Thailand) and Lake Dianchi (China). Two axes were then determined from the relationship between: (1) water use and water supply rate, and (2) water use and water quality. To clarify the meanings ‘carrying capacity’ and ‘vulnerability’, the maximum population density in the lake basin and total nitrogen concentration in the lake water were calculated and discussed to decide the direction of environmentally sound management of the drainage basin.     

Expression of the active form of MMP-2 on the surface of leukemic cells accounts for their in vitro invasion

Antibodies reactive with peptide epitopes on the core protein of MUC1 epithelial mucin have been demonstrated in some patients with adenocarcinomas. Because these epitopes can be exposed on MUC1 in the serum of healthy women, we measured concentrations of MUC1-reactive antibodies in the serum of healthy pregnant and non-pregnant women, and in patients with benign and malignant ovarian tumours. Antibodies were measured in an enzyme-linked immunosorbent assay utilising a synthetic peptide corresponding to a 105-amino-acid segment of the MUC1 tandem repeat region (5.25 repeats). MUC1-reactive antibodies were always of an IgM isotype and concentrations were highest in young healthy women and declined progressively with age (P=0.0006) concomitantly with increasing serum MUC1 levels (P=0.003). Regardless of age, antibody levels were lower in cancer patients than in healthy women (P<0.0001), but MUC1 levels were much higher in cancer patients (P<0.0001). Although high antibody levels were associated with greater survival in ovarian cancer (P=0.015), multivariate regression analysis showed that this was not a significant independent prognostic indicator after consideration of the International Federation of Gynaecology and Obstetrics (FIGO) stage, histological type, serum MUC1 levels and age. Serial measurement of MUC1 and MUC1 antibodies during treatment in 18 patients with ovarian cancer and throughout pregnancy in 10 women showed a negative correlation between alterations in MUC1 and MUC1 antibodies. These results show that MUC1-peptide-reactive antibodies are present in the serum of healthy women and women with cancer and that they probably form immune complexes with MUC1, but provide no evidence for an augmentation of the humoral immune response to MUC1 in ovarian cancer