Augmentation of boiling heat transfer from horizontal cylinder to liquid by movable particles

This paper presents a series of experimental results on a passive augmentation technique of boiling heat transfer by supplying solid particles in liquid. A cylindrical heater 0.88 mm in diameter is placed in saturated water, in which a lot of mobile particles exist, and the nucleate and film boiling heat transfer characteristics are measured. Particle materials used were alumina, glass, and porous alumina, and the diameter ranged from 0.3 mm to 2.5 mm. Particles are fluidized by the occurrence of boiling without any additive power, and the heat transfer is augmented. The maximum augmentation ratio obtained in this experiment reaches about ten times the heat transfer coefficient obtained in liquid alone. The augmentation ratio is mainly affected by the particle material, diameter, and the height of the particle bed set at no boiling condition. The augmentation mechanism is discussed on the basis of the experimental results. © 2001 Scripta Technica, Heat Trans Asian Res, 31(1): 28–41, 2002     

Graphite formation on Ni film by chemical vapor deposition

Thin film formation of graphite by chemical vapor deposition using 2-methyl-1,2′-naphthyl ketone as a starting material was carried out on Ni film substrates. On Ni films directly deposited on quartz glass, the graphite films were obtained when the Ni film thickness was above 1 000 Å and above 5 000 Å at 700 °C and 1 000 °C, respectively. Depositions on thinner Ni film substrates comprise amorphous carbon (a-C) or graphite tubes which was owing to the thermal coagulation of the Ni film into droplets. On the other hand, graphite film was obtained on the Ni film with thickness 10 Å when a-C was inserted between the Ni film and the quartz glass. The coagulation of the Ni film is considered to be avoided by inserting a-C layer.     

Permeation of Zidovudine and Probenecid from Oily Bases Containing Alcohols Through Rat Skin

Permeation of zidovudine (3'-azido-3'-deoxythymidine, AZT) and probenecid from oily bases containing an alcohol through rat skin was examined. Isopropyl myristate (IPM), as an oily vehicle, showed a penetration enhancing effect for AZT and probenecid. Ethanol, n-propanol, and n-butanol were used as additives in IPM and were examined for their own permeation and the enhancing effect on the permeation of AZT and probenecid. The skin permeation of AZT and probenecid from IPM was enhanced by addition of the alcohol in IPM. The degree of the enhancement was decreased with increasing lipophilicity of the alcohol used. me permeation rate of the drug from those systems was shown to be governed by penetration-enhancing effects of the oily base and alcohol, and the penetration of the alcohol itself through the skin.     

Impulse breakdown voltages of triggered multistage vacuum gap

Several sealed-off triggered vacuum gaps are connected in series to improve hold-off voltage. The characteristics of impulse breakdown voltage of these series-connected gaps are investigated experimentally. The sum hold-off voltage of series-connected gaps decreases to a unit hold-off voltage when the maximum value of voltage division ratio across the gaps increases to unity. Self-breakdown probability of the series-connected gaps is always higher than that of a single gap under the same conditions. Hence, stage efficiency of the multistage gap decreases with increasing number of stages. Its value is 90 percent with 2-stage gap and 75 percent with 5-stage gap, respectively, under the same voltage division ratio and the same gap length (2.0 mm) in each stage. Triggered breakdown voltage of 2- or 3- stage gap is several hundred volts when all gaps are triggered simultaneously at the peak of the main impulse wave and a working voltage range is nearly 100 percent in this case. The working voltage range decreases with number of stages. Its value is 45 percent with 3-stage gap and 15 percent with 5-stage gap, respectively, when one triggered gap is fired for switching.     

Effect of puffer volume and operating force on dielectric recovery performance in thermal puffer-type gas circuit breaker

In order to investigate the influence of puffer volume V/sub P/ and operating force to dielectric performance of GCB at current interruption, we calculated the prospective dielectric withstand voltage V/sub W/ between arcing contacts. The withstand voltage was calculated by the electric field strength appeared on arcing contacts and the allowable electric field strength E/sub W//sup */ of hot gas due to thermal puffer action. We could clarify that large initial puffer volume V/sub P/ can increase withstand voltage V/sub W/ at current breaking point and also that an optimum point exists in operating force F. For example, it was found that in case of the operating force of 1000 kgf, the puffer volume V/sub P/ of 1.2 liter would be best choice in the interrupting condition of i=50 kA and arcing time of 1.35 cycle.     

Elevated levels of tumor necrosis factor-alpha (TNF-alpha) and interleukin-6 (IL-6) activities in the sera and milk of cows with naturally occurring coliform mastitis

The presence of tumor necrosis factor-alpha (TNF-alpha) and interleukin-6 (IL-6) activities was determined in milk and serum of cows with naturally occurring coliform mastitis (CFM). TNF-alpha was detected in the sera from 26 of 32 cows with CFM. TNF-alpha levels were higher in the sera than in the milk. IL-6 was high in the sera of surviving CFM animals, but was low in animals that died and in healthy controls. Furthermore, the mean level of IL-6 was 20-fold higher in the milk than in the sera of mastitic cows. The level of IL-6 in the serum was correlated to that in the milk in individual animals. The presence of IL-6 and TNF-alpha in the sera appears to relate to severe clinical condition of CFM, in the milk whereas they may play a role in generating inflammation of the mammary gland.     

A study of suppression of vapor explosions by adding inversely soluble polymers

The mechanism of the suppression of vapor explosions by adding inversely soluble polymers in water is studied. Vapor explosion experiments and quench experiment are conducted using a silver test piece. Polymetric solution (polyethylene oxide), of concentrations from 0 to 500 wppm, whose normalized viscosity (by water) varies from 1.00 to 2.00, is used. No vapor explosion is observed in the aqueous polymer solution at a concentration higher than 200 wppm. Quench experiments using the silver test piece submerged in the polymer solution and water are performed in order to examine the stability of film boiling. The suppression of the vapor film collapse is attributed to the precipitation of polyethylene as a gel around the vapor film. © 2002 Wiley Periodicals, Inc. Heat Trans Asian Res, 31(4): 297–306, 2002; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/htj.10037     

Structural change in the Brill transition of Nylon m/n (1) Nylon 10/10 and its model compounds

Structural changes in the Brill transitions of Nylon 10/10 and its model compounds have been investigated by carrying out the temperature-dependent measurements of X-ray diffraction and infrared spectra along with the DSC measurement. The crystal structure at room temperature was found to be the so-called α form with the all-trans zigzag methylene segments. When the samples were heated, the infrared progression bands of the methylene segments, which are sensitive to the length of all-trans segmental parts, were found to change their spectral patterns in the transition temperature region: the progression bands decreased in intensity and disappeared above the transition region. At the same time several new bands were observed to appear, which were found to correspond to the progression bands of (CH₂)₇-(CH₂)₅trans-zigzag segments. These spectral changes indicate that the methylene segments were conformationally disordered by an invasion of some gauche bonds and as a result the effective length of trans-zigzag segments became shorter. This conformational disordering was found to occur more remarkably in the methylene segment of NH-(CH₂)₁₀-NH part than the CO-(CH₂)₈-CO part. At the same time the infrared bands of amide groups, in particular the bands sensitive to the twisting angles about the CH₂-amide bonds were found to show the remarkable change, indicating the local conformational change from planar-zigzag to twisted form in the CH₂-amide moiety. The frequency shift of amide A band (NH stretching mode) indicated a weakening of intermolecular hydrogen bonds, which however, did not disappear up to the melting region. From these data combined with the X-ray diffraction data, the structural disordering in the Brill transition phenomena was deduced concretely.