Facile growth of novel morphology correlated Ag/Co-doped ZnO nanowire/flake-like composites for superior photoelectrochemical water splitting activity

In this paper, novel morphology correlation between silver nanowires (AgNWs) and cobalt (Co)-doped ZnO (Co-ZnO) flake-like thin films (nanowire/flake-like) has been proposed for enhanced photoelectrochemical (PEC) water splitting activity. Here in, high-quality AgNWs/Co-ZnO heterostructures enabled superior visible light water splitting activity compared to the pure ZnO and AgNWs/ZnO. To address the strategic effect of AgNWs coupling and transition metal (Co-2?at%) doping into the ZnO host lattice, we have carried out the X-ray diffraction, field emission scanning microscopy, X-ray photoelectron spectroscopy, UV–Vis transmittance, water contact angle and PEC analyses. In this way, PEC water splitting activity was mainly examined by linear sweep voltammetry (I-V), amperometric I-t and photoconversion efficiency (η) studies. The experimental results provide clear evidence of morphology correlation between AgNWs and Co-ZnO flake-like structures for strong visible light absorption. Specifically, AgNWs/Co-ZnO composites exhibited significant enhancement in the photocurrent density (7.0?×?10^?4 A/cm²) than AgNWs/ZnO (3.2?×?10^?4 A/cm²) and pure ZnO (1.5?×?10^?6 A/cm²). As a result, detailed AgNWs/Co-ZnO geometry has great potential for photoconversion efficiency (0.73%). In a word, the merits of controllable AgNWs/Co-ZnO heterostructure are proposed to improve the visible light harvesting and charge carrier generation for energy conversion devices.     

Pulsed laser deposition of indium antimonide

Single crystalline oriented films of indium antimonide have been grown on cadmium telluride substrates by the pulsed laser deposition technique. The films were (111) oriented which is the substrate orientation. The composition of the grown films were found to deviate from that of the target owing to loss of antimony during evaporation. This deviation from stoichiometry led to film-substrate reaction, resulting in mixed interface. The antimony deficiency in the films were controlled by correcting the stoichiometry, which led to avoiding mixed interfaces. The stoichiometric films showed good surface morphology and well defined sharp interfaces. The IR transmission spectrum showed sharp band to band absorption and effective detection in the MWIR. Paper presented at the poster session of MRSI AGM VI, Kharagpur, 1995     

Thermal and surface characterization of polyurethane–urea clay nanocomposite coatings

This paper reports synthesis and characterization of polyurethane–urea (PU‐urea) and the nanocomposites derived from the PU‐urea with silicate clays. Organophilic montmorillonite cotreated by cetyl trimethyl ammonium bromide (CTAB) was synthesized and used to prepare PU‐urea/montmorillonite nanocomposites coatings. PU‐ureas were prepared from polyethylene glycol (PEG), polypropylene glycol (PPG), trimethylol propane (TMP), and 4,4′‐diphenylmethane diisocyanate (MDI) by reacting excess diisocyanate with polyether glycols. The excess isocyanate of the prepolymers was cured with atmospheric moisture. The synthesized moisture cured PU‐urea and nanocomposites were characterized by Fourier transform infrared (FTIR) spectroscopy, thermogravimetric analysis (TGA), differential scanning calorimetric (DSC), and angle resolved X‐ray photoelectron spectroscopy (AR‐XPS). The thermal stability of the PU‐urea nanocomposites was higher relative to the mother PU‐urea films. DSC results showed a slight enhancement in the soft segment glass transition temperature after 3 wt % clay loading. The surface properties showed an enrichment of the soft segment toward the surface. An enhancement in the hard segment composition in the nanocomposite coatings has resulted in enhancing the phase mixing process. © 2006 Wiley Periodicals, Inc. J Appl Polym Sci 100: 2393–2401, 2006     

Analysis and performance results of computing betweenness centrality on IBM Cyclops64

This paper presents a joint study of application and architecture to improve the performance and scalability of an irregular application—computing betweenness centrality—on a many-core architecture IBM Cyclops64. The characteristics of unstructured parallelism, dynamically non-contiguous memory access, and low arithmetic intensity in betweenness centrality pose an obstacle to an efficient mapping of parallel algorithms on such many-core architectures. By identifying several key architectural features, we propose and evaluate efficient strategies for achieving scalability on a massive multi-threading many-core architecture. We demonstrate several optimization strategies including multi-grain parallelism, just-in-time locality with explicit memory hierarchy and non-preemptive thread execution, and fine-grain data synchronization. Comparing with a conventional parallel algorithm, we get 4X-50X improvement in performance and 16X improvement in scalability on a 128-cores IBM Cyclops64 simulator.     

Mapping of groundwater potential zones in the Musi basin using remote sensing data and GIS

The objective of this study is to explore the groundwater availability for agriculture in the Musi basin. Remote sensing data and geographic information system were used to locate potential zones for groundwater in the Musi basin. Various maps (i.e., base, hydrogeomorphological, geological, structural, drainage, slope, land use/land cover and groundwater prospect zones) were prepared using the remote sensing data along with the existing maps. The groundwater availability of the basin is qualitatively classified into different classes (i.e., very good, good, moderate, poor and nil) based on its hydrogeomorphological conditions. The land use/land cover map was prepared for the Kharif season using a digital classification technique with the limited ground truth for mapping irrigated areas in the Musi basin. The alluvial plain in filled valley, flood plain and deeply buried pediplain were successfully delineated and shown as the prospective zones of groundwater.     

Synthesis, characterization and gas sensing property of hydroxyapatite ceramic

Hydroxyapatite (HAp) biomaterial ceramic was synthesized by three different processing routes viz. wet chemical process, microwave irradiation process, and hydrothermal technique. The synthesized ceramic powders were characterized by SEM, XRD, FTIR and XPS techniques. The dielectric measurements were carried out as a function of frequency at room temperature and the preliminary study on CO gas sensing property of hydroxyapatite was investigated. The XRD pattern of the hydroxyapatite biomaterial revealed that hydroxyapatite ceramic has hexagonal structure. The average crystallite size was found to be in the range 31–54 nm. Absorption bands corresponding to phosphate and hydroxyl functional groups, which are characteristic of hydroxyapatite, were confirmed by FTIR. The dielectric constant was found to vary in the range 9–13 at room temperature. Hydroxyapatite can be used as CO gas sensor at an optimum temperature near 125°C. X-ray photoelectron spectroscopic studies showed the Ca/P ratio of 1.63 for the HAp sample prepared by chemical process. The microwave irradiation technique yielded calcium rich HAp whereas calcium deficient HAp was obtained by hydrothermal method.     

Modelling of wind energy‐based microgrid system implementing MMC

Nowadays, renewable energy systems have come up with more potential in power generation so as to meet the power demand. Among all the renewable systems, the wind energy generating system is believed to be at the peak. However, the wind energy‐based microgrid system is associated with many problems such as fluctuations in output voltage due to the fluctuated wind speeds and harmonics generations in the system. To address these issues, this article proposes a new method in order to achieve harmonic mitigation across its output by maintaining constant voltage. Nevertheless, particular attention has been given to the form and function of modular multilevel converter with multi‐winding transformer connected to the grid. Modular multilevel converter has been implemented with an advanced voltage controller tuned to control the voltage at its output. Also, a new system topology has been introduced with two wind turbines that are interconnected to multi‐winding transformer through asynchronous generators. The proposed system has been implemented with constant and variable wind speeds, and their respective results have also been analysed. The proposed scheme shows its effectiveness by theoretical calculations, verified by simulation and experimental results. Copyright © 2016 John Wiley & Sons, Ltd.     

Investigation on DC/RF Performance of LG = 19 nm Heterogeneous Integrated Ga0.15In0.85As/InAs/Ga0.15In0.85As Composite Channel InP HEMT on Silicon Substrate for Future Beyond 5G and Quantum Computing Applications

Silicon - The RF/DC performances of LG = 19 nm heterogeneous integrated Ga0.15In0.85As/InAs/Ga0.15In0.85As composite channel based InP HEMT (high electron mobility transistor)...     

Structural,optical and magnetic properties of nanocrystalline Zn0.9Co0.1O-based diluted magnetic semiconductors

With a view to understand the influence of nano size on various properties of cobalt-doped ZnO-based diluted magnetic semiconductors, a series of materials were prepared by the citrate gel route. The phase and morphology studies have been carried out by X-ray diffraction and transmission electron microscopy, respectively. All the samples of the present investigation are found to have hexagonal wurtzite structure and crystallite sizes are found to vary from 25 nm to 65 nm. From the optical absorption measurements it has been observed that upon doping with cobalt, the energy band gap is found to shift towards lower energy side (red shift) while it shifts towards higher energy side (blue shift) when the crystallite size is increased continuously. It has been observed from the XPS results that oxidation state of Cobalt is +2 and that the difference in binding energies of Co 2p_3/2 and Co 2p_1/2 is found to increase continuously with increasing crystallite size. Finally, all the samples are found to exhibit room temperature ferromagnetism and the specific magnetization decreases with increasing crystallite size.