High energy storage and ultrafast discharge in NaNbO3-based lead-free dielectric capacitors via a relaxor strategy

Dielectric capacitors with decent energy storage and fast charge-discharge performances are essential in advanced pulsed power systems. In this study, novel ceramics (1-x)NaNbO₃-xBi(Ni_2/3Nb_1/3)O₃(xBNN, x = 0.05, 0.1, 0.15 and 0.20) with high energy storage capability, large power density and ultrafast discharge speed were designed and prepared. The impedance analysis proves that the introducing an appropriate amount of Bi(Ni_0·5Nb_0.5)O₃ boosts the insulation ability, thus obtaining a high breakdown strength (E_b) of 440 kV/cm in xBNN ceramics. A high energy storage density (W_total) of 4.09 J/cm³, recoverable energy storage density (W_rec) of 3.31 J/cm³, and efficiency (η) of 80.9% were attained in the 0.15BNN ceramics. Furthermore, frequency and temperature stability (fluctuations of W_rec ≤ 0.4% over 5–100 Hz and W_rec ≤ 12.3% over 20–120 °C) were also observed. The 0.15BNN ceramics exhibited a large power density (19 MW/cm³) and ultrafast discharge time (~37 ns) over the range of ambient temperature to 120 °C. These enhanced performances may be attributed to the improved breakdown strength and relaxor behavior through the incorporation of BNN. In conclusion, these findings indicate that 0.15BNN ceramics may serve as promising materials for pulsed power systems.     

甲玛地区角岩矿微生物浸出的试验研究

介绍了西藏华泰龙矿业开发有限公司角岩的矿石性质,针对该低品位铜矿石进行了详细的微生物浸出试验研究,在原矿铜品位仅为0.12%、SiO_2含量高达69.12%的情况下,用接种量为10%的浸矿菌液,浸出1 d时,铜浸出率即为34.44%,浸出11 d时,浸出率达到70.02%,此时较无菌条件下的浸出率高出17.46个百分点。     

Key-dependent side-channel cube attack on CRAFT

CRAFT is a tweakable block cipher introduced in 2019 that aims to provide strong protection against differential fault analysis. In this paper, we show that CRAFT is vulnerable to side-channel cube attacks. We apply side-channel cube attacks to CRAFT with the Hamming weight leakage assumption. We found that the first half of the secret key can be recovered from the Hamming weight leakage after the first round. Next, using the recovered key bits, we continue our attack to recover the second half of the secret key. We show that the set of equations that are solvable varies depending on the value of the key bits. Our result shows that 99.90% of the key space can be fully recovered within a practical time.     

High-rate capability of carbon-coated micron-sized hexagonal TT-Nb2O5 composites for lithium-ion battery

With excellent specific capacity, superior cycle stability, safety and strong practical, Nb₂O₅ has been considered as one of the prospective anode materials for lithium-ion batteries (LIBs). However, current study suggests that Nb₂O₅ electrode materials for LIBs still face the vital issues of low electrical conductivity and poor rate performance. Therefore, carbon-coated TT-Nb₂O₅ materials are designed and synthesized through solid state method in this work, which present high specific capacity (228 mA h g^?1 at 0.2C), satisfactory rate properties (107 mA h g^?1 at 20 C). The outstanding electrochemical property can not only give the credit to the pseudocapacitance effect of TT-Nb₂O₅, but also attribute to introduction of carbon. The homogeneous carbon-coated materials enhance the electrical conductivity, increase the electron transmission speed and alleviate particle crushing. This research not only offers a new method for preparing excellent electrode materials, but also provides a kind of excellent anode material with prospective application for LIBs.     

-15℃下Na+， K+， Mg2+//Cl-， NO3-， SO42——H2O体系相平衡研究

新疆卤水硝酸盐矿主要含有Na⁺、K⁺、Mg²⁺、Cl^-、NO₃^-、SO₄^2-六种离子，属于高元复杂体系，其合理利用和开发需要不同温度下的相平衡研究作为理论支撑。采用等温溶解平衡法，对Na⁺， K⁺， Mg²⁺//Cl^-， NO₃^-， SO₄^2--H₂O体系在-15℃、NaCl·2H₂O饱和条件下的相平衡进行了研究，并构建了相图。相图中有六个零变量点和八个两盐结晶区，只存在一种复盐KCl·MgCl₂·6H₂O。八个两盐结晶区，分别对应于NaCl·2H₂O+Na₂SO₄·10H₂O、NaCl·2H₂O+NaNO₃、NaCl·2H₂O+KCl、NaCl·2H₂O+KNO₃、NaCl·2H₂O+MgSO₄·7H₂O、NaCl·2H₂O+MgCl₂·8H₂O、NaCl·2H₂O+Mg(NO₃)₂·6H₂O和NaCl·2H₂O+KCl·MgCl₂·6H₂O，其中NaCl·2H₂O+Na₂SO₄·10H₂O共晶区最大，在低温时，硫酸钠的溶解度最小，降温过程中较易结晶析出。与该体系在25℃下的相图相比，复盐种类减少5种，零变量点减少19个，相关系得以极大简化。     

Effects of anion and cation doping on the thermoelectric properties of n-type PbS

The PbCl_xS_1-x and Pb_1-xBi_xS (x? =?0–0.05) bulks were fabricated with a facile method of hydrothermal synthesis and microwave sintering, and the effect of anionic and cationic donors on the thermoelectric performance of PbS was investigated. Although Cl^? and Bi³⁺ both effectively improved the thermoelectric properties of n-type PbS, more excellent thermoelectric performance was obtained from Cl^? doped samples because of higher electrical property and lower thermal conductivity at higher temperature (T? >?600?K). The thermoelectric figure of merit (ZT) reaches 1.04 for PbCl_0.015S_0.985 at 800?K and increases with temperature increasing without sign of saturation, which is probably the highest value ever reported for single-phase polycrystalline n-type PbS. The results also indicate that the hydrothermal synthesis and microwave sintering can realize anion doping as well as cation doping for n-type PbS at low cost, and PbS should be a robust alternative for PbTe thermoelectric materials.     

分布式连接全装配RC楼盖动力特性分析

为研究分布式连接全装配RC楼盖(DCPCD)的动力特性,进行了 4个足尺DCPCD试件和一个整浇板试件在两端简支条件下的锤击法试验和数值模拟分析,研究了 DCPCD的板缝构造、连接件锚固方式、边界约束条件和自重等对楼盖竖向动力特性的影响.试验结果表明:与整浇板相比DCPCD横板向刚度较小,自振频率较低,板缝构造是影响楼盖刚度和振动特性的主要因素;连接件数量越多,楼盖的刚度和自振频率越高;板缝数量越多,楼盖的刚度和自振频率越低.所提出的有限元模拟方法可以准确模拟DCPCD的动力特性;连接件锚固强度越高,楼盖的刚度和自振频率越高;两端嵌固约束下的楼盖基频比两端简支约束下提高了 70％;随着楼盖自重的增加,自振频率显著降低.研究结果可为四边约束下楼盖的竖向振动特性与人致激励响应研究提供参考和依据.     

施工过程中腐蚀隐患的控制

通过分析石化装置施工过程中常见的现象,分析产生由这些现象加重腐蚀的原因和机理, 指出应加强施工过程中的控制,而达到预期的防腐蚀效果,消除腐蚀隐患。     

阜阳地区石炭-二叠系煤系烃源岩特征

阜阳地区石炭-二叠系煤系地层发育，但由于勘探程度较低，对该区煤系地层烃源岩的生烃潜力认识不清，严重制约了该区的油气勘探。在已有资料的基础上，通过有机地球化学和有机岩石学方法并结合模拟实验，探讨了该区煤系烃源岩的生烃潜力。研究结果表明阜阳地区石炭-二叠系煤系烃源岩有机质丰度达到中等-好烃源岩标准，有机质类型以腐殖型为主，盆地模拟结果显示阜阳地区石炭-二叠系煤系地层油资源量为（30.47~152.33）×10⁶t，气资源量为（266.7～1333.7）×10⁸m³，展示阜阳地区石炭-二叠系煤系地层具有较好的生油气潜力。     

Preparation, patterning and luminescent properties of nanocrystalline Gd2O3:A (A=Eu, Dy, Sm, Er) phosphor films via Pechini sol–gel soft lithography

Nanocrystalline Gd₂O₃:A (A=Eu³⁺, Dy³⁺, Sm³⁺, Er³⁺) phosphor films and their patterning were fabricated by a Pechini sol–gel process combined with a soft lithography. X-ray diffraction (XRD), atomic force microscopy (AFM), scanning electron microscopy (SEM) and optical microscopy, UV/vis transmission and photoluminescence (PL) spectra as well as lifetimes were used to characterize the resulting films. The results of XRD indicated that the films began to crystallize at 500 °C and that the crystallinity increased with the elevation of annealing temperatures. Uniform and crack free non-patterned phosphor films were obtained by optimizing the composition of the coating sol, which mainly consisted of grains with an average size of 70 nm and a thickness of 550 nm. Using micro-molding in capillaries technique, we obtained homogeneous and defects-free patterned gel and crystalline phosphor films with different stripe widths (5, 10, 20 and 50 μm). Significant shrinkage (50%) was observed in the patterned films during the heat treatment process. The doped rare earth ions (A) showed their characteristic emission in crystalline Gd₂O₃ phosphor films due to an efficient energy transfer from Gd₂O₃ host to them. Both the lifetimes and PL intensity of the rare earth ions increased with increasing the annealing temperature from 500 to 900 °C, and the optimum concentrations for Eu³⁺, Dy³⁺, Sm³⁺, Er³⁺ were determined to be 5, 0.25, 1 and 1.5 mol% of Gd³⁺ in Gd₂O₃ films, respectively.